碳轉化效應 的英文怎麼說

中文拼音 [tànzhuǎnhuàxiàoyīng]
碳轉化效應 英文
effect of carbon conversion
  • 碳 : 名詞[化學] （非金屬元素） carbon （c）
  • 轉 : 轉構詞成分。
  • 效 : Ⅰ名詞（效果; 功用） effect; efficiency; result Ⅱ動詞1 （仿效） imitate; follow the example of 2 ...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 轉化 : 1. （轉變） change; transform 2. [化學] inversion; conversion
  • 效應 : [物理學] effect; action; influence
  1. Based on the analyses on mechanical properties, microstructure and fracture of - the microalloyed steels socrv with various heat treatment technique, it can be affirmed that various fractures arttribute to various mechanism, we can draw conclusion that the strength and toughness of microalloyed steels 50crv will be increase simultaneously by optimal heat treatment technique. to illustrate the mechanism of the strength and toughness of microalloyed steels socrv, we designed the comparative experiment and observed the microstructure of the sample which occurred at different quench and tempering temperature and different tempering time. the last experiment results were determined by the four factors : fined microalloyed elements grains, the decompound of martensite, martensite transformation of remnant austenite and the second phase precipitation

    為解釋微合金化50crv鋼強韌化機理，本文通過對不同淬火溫度，回火溫度，回火時間下的力學性能指標的對比及顯微分析，認為微合金元素的細化晶粒，馬氏體的回火分解，殘余奧氏體的轉變，第二相的沉澱析出共同決定了微合金鋼的強韌化情況，特別是由於微合金元素的存在，其細化晶粒及其碳氮化物的沉澱析出，導致鋼的良好的強韌性，並且如果工藝滿足第二相的沉澱析出強化大於回火馬氏體分解引起的軟化效應，會在硬度曲線中產生明顯的二次硬化現象。
  2. This dissertation focuses on how to develop a high performance damping mechanism based on multi - energy transitions, which is independent or little dependant with the viscoelasticity of polymer matrix. three sections are mainly included in this dissertation as follows : chlorinated polyethylene ( cpe ) / piezoelectric ceramic ( pzt ) / vapor grown carbon fiber ( vgcf ) composites ; cpe / 2, 2 ' - methylene - bis - ( 4 - methyl - 6 - cyclohexylphenol ) ( zkf ) / vgcf composites ; organic hybrids made from cpe and small molecules cpe / pzt / vgcf composites : the damping composites of multi - energy transitions mechanism were produced by mixing pzt and vgcf into cpe. in this system, the mechanical vibration energy that was transmitted to cpe was found to convert into joule ' s heat through conduction paths between vgcf in the polymer matrix, so the vibration fades away

    本論文主要包括三個方面的研究內容： ?氯化聚乙烯（ cpe ） /壓電陶瓷（ pzt ） /氣相生長碳纖維（ vgcf ）復合材料； ? cpe /雙[ （ 2 -羥基- 3 -環己基- 5 -甲基） -苯基]甲烷（ zkf ） / vgcf復合材料； ? cpe基有機小分子混雜型復合材料cpe / pzt / vgcf減振復合材料：利用壓電和導電填料填充高聚物基體，當復合材料受到機械振動時，通過高聚物基體將機械振動能傳遞到壓電陶瓷粒子上，利用壓電陶瓷的壓電效應，將機械能轉換成電能，則電流在導電粒子產生的迴路中流動，由於導電迴路具有一定的電阻，所以電能又轉變成熱能耗散掉，從而起到減振的目的。
  3. Compared to other types of internal combustion engines, diesel engines that are used more and more widely are more fuel - efficient, provide highest torque and pulling capability, are lower emitters of hydrocarbons and carbon monoxide, but diesel engines can emit up to 30 times more particulate matter than gasoline engines

    與其他類型的內燃機相比，應用越來越廣泛的柴油機具有更高的燃油效率、提供更大的轉矩和拖動能力，碳氫化合物排放低，但微粒的排放卻是汽油機的30倍以上。
  4. Three schemes for this technology were given, including air - blown gasification, recycle gas - blown gasification and steam & recycle gas - blown gasification, which were computed and analyzed. due to different conversion ratio of coal and different temperature that gas enters into gas turbine, the different results were got and analyzed, such as gas heat value, gasification efficiency and generation efficiency

    本文針對空氣氣化方案、再循環煤氣氣化方案以及水蒸汽+再循環煤氣氣化方案對煤部分氣化聯合循環發電系統進行計算分析，根據不同的碳轉化率以及煤氣進入燃氣輪機前不同的溫度，得出不同的煤氣熱值、氣化效率、發電效率等，並進行了分析，提出了適合不同目標工業應用的煤部分氣化方案。
  5. In order to combine biomass gasification technology, we have checked the fuel cell ' s impurity tolerance level. the results show that traces of h2s can damage the fuel cell. but co and cm almost have no influence on the performance of the fuel cell

    試驗結果表明， ch _ 4 、 co對燃料電池性能沒有太大的影響，而是作為燃料參加反應的，而微量的h _ 2s氣體即可對電極產生破壞性的作用，電解質中的碳酸根轉化為硫酸根，從而使電池失效。
  6. This paper analyzes mainfactors that influence the dephosphorization of medium - high carbon steels in con - verter steelmaking process. bytaking effective measuresto optimize steelmaking process better dephosphorizationresults wereachieved at anyang steel

    分析了轉爐冶煉中高碳鋼條件下影響脫磷的主要因素。通過採取相應措施，優化工藝操作，保證了較好的脫磷效果。
  7. It ' s resolve dispersion intensity and operation time. by testing sample of precipitated calcium carbonate and testing sample with particle size and distribution, specific surface area, particle configuration, coated percentage, accumulated density and absorb oil quantity, which indicated that the dispersion and surface modification effect of tri - rotor continuum surface modification equipment are fulfilled the demand of powders applied industry completely, also the system working continuously, realizing produce scale. the performance of the test equipment is much better than others dry machinery in our country, and as well as overseas dry machinery and wet machinery, also it has the advantage of the produce cost low

    通過對樣品?輕質碳酸鈣的性能試驗，同時對試驗樣品進行了粒度及粒度分佈、比表面積、顆粒形貌、包覆率、堆積密度和吸油值的檢測，表明三轉子連續改性機的分散和改性效果完全能夠滿足粉體應用行業的需要，同時系統連續作業，實現了規模化生產；通過與其它改性裝置的對比試驗表明本試驗裝置性能優于國內其它干法改性裝置，達到國外干法和濕法改性裝置的水平，同時又具有生產成本低的優勢。
分享友人
分享到 Line

分享到臉書