磁流電路 的英文怎麼說

中文拼音 [liúdiàn]
磁流電路 英文
magnet current circuit
  • : 名詞1. [物理學] (磁性; 能吸引鐵、鎳等的性質) magnetism 2. (瓷) porcelain; china
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 1 (道路) road; way; path 2 (路程) journey; distance 3 (途徑; 門路) way; means 4 (條理) se...
  • 電路 : [訊] circuit (ckt); electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. On the base of analyzing the development status and trend of the electromagnetic flowmeter technology, this article uses new mcu and ic to design the intelligent electromagnetic flowmeter that has a conversion instrument and a cumulation apparatus

    本文在分析國內外量計發展現狀和趨勢基礎上,採用新型微處理器和集成來開發集轉換器、積算儀於一體的智能量計。
  2. Finally, because high - speed power solenoid valve is one of the most important executive parts in the electronic control diesel engine and the performances of diesel engine are strongly related to the solenoid valve, the response performance of the solenoid valve is investigated. the response performance of the solenoid is influenced by many factors, such as driving voltage, electric driving unit etc. in order to have high excitation voltage and in low maintaining voltage, a high - low voltage electric driving unit is designed, and in order to make the solenoid valve close more rapidly, an active free - wheeling circuit and a bootstrapping circuit are designed in the electric driving unit, too. in the high - low electric driving unit, high voltage and low voltage are supplied by the dc - dc device and by the accumulator respectively

    高速強力閥的響應性能除了與閥本身的結構和材料有關外,與驅動壓、驅動的設計密切相關,本文通過分析,首先開發出一種高低壓驅動,高壓源是山升壓式dc - dc原理獲取的,低壓由蓄池本身提供,實現高壓強激和低壓維持的功能,中採用有源續柴汕機中卜軌知介系統的設訓及其七川j敝略的叭究進行續,加誣了閥的關閉速度;採用自舉吐,降低了場效應管對驅動壓的要求。
  3. The principle of the hardware and software has been introd uced, with the circu it d i agram, the flow chart an d list of the program

    介紹本次課題所用的196單片機的原理,設計出數字勵調節器的,分析裝置的硬體工作原理,給出詳細的硬體原理圖,設計運行程序程圖。
  4. The modulating signals of firing delay angle at the rectifier and firing lead angle at the inverter, and the excitation voltage are chosen to be control variables. the offset of the current of dc line and the extinction angle and the power angle of generator are chosen to be control outputs. then a nonlinear controller is designed for the system under study according to direct feedback linearization theory

    以整側觸發延遲角的調節信號、逆變側觸發超前角的調節信號以及發機勵壓作為控制變量,以直、逆變側關斷角以及發機功角的偏移量作為目標輸出,用直接反饋線性化方法設計了系統的非線性控制器。
  5. With the stringent requirement of low output voltage and high output current, semiconductor diode is necessarily replaced by synchronous rectifier to minimum voltage drop. because the existed driving schemes can not drive srs properly, two novel driving schemes for synchronous rectifiers in magnetic amplifier post regulating circuit are proposed in this paper

    已有的同步整管驅動主要面對多輸出的主輸出,而應用放大器調節的輔助輸出同步整管的驅動,現有的方法存在放大器調節與同步整管驅動的失配,降低了開關源的效率。
  6. When the secondary circuit is closed, both primary and secondary currents set up a flux in the core.

    當次級接通時,初級和次級都在鐵芯內建立了一個通量。
  7. Railway rolling stock. magneto - thermic microcircuit - breakers for maximum current for controls and auxiliaries circuits. dimension

    機車車輛.控制裝置和輔助線用最大機微器.尺寸
  8. Railway rolling stock. magneto - thermic microcircuit - breakers for maximum current for controls and auxiliaries circuits. generalities and tests

    車輛.控制和輔助線用最大機微型器.一般原則和試驗
  9. Thirdly, the paper discusses the driver of the peripheral equipment, how to port the uc / os - n and uclinux, h. 323 protocol and the application of the system in the digital speech classroom. also some software and hardware measure are adopted to enhance the system stability. at last, the shortcoming and the something to be improved are given. dsp can be used to realize real - time speech coding algorithm, and after porting ( ac / os - n, arm can manage the keyboard, the lcd and the ethernet peripheral etc. then the embedded network system with specific purpose can be used in others fields, such as pda, set of top, web tv, ect

    在實際設計實現中,為提高系統軟、硬體整體穩定性和可靠性,使用了以下幾種方法: ( 1 )低壓復位、抗源抖動能力、增加時鐘監測、抗干擾能力、散熱等技術; ( 2 )多層pcb設計,線板結構緊湊,源部分採用數字5v 、 3 . 3v 、 3v 、 1 . 8v和模擬5v多源供; ( 3 )選用表面貼和bga封裝的器件; ( 4 )按照軟體工程的要求進行系統分析,規劃系統框圖、程分析、模塊劃分,減小了不同模塊的相關性,從而最大限度避免了錯誤的發生。
  10. The imperfection mutual inductance will excite spurious frequency, and create circulating currents in each choke capacitor branch, therefore cause magnet current distortion

    結果表明,諧振抗器的互感系數的不一致性將激勵寄生頻率,從而在每個諧振抗器與容支中產生寄生,並導致的畸變。
  11. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應機進行了深入細致研究,內容包括: ( 1 )本文採用有限長行波面作用於有限長鐵芯上的模型,引用了氣隙場一維解,研究了單層繞組場,奇數極半填槽雙層繞組在採用整距和短距時場的分析、比較,簡單介紹了二維解; ( 2 )用有限元軟體ansoft對大圓環直線感應機空載氣隙場進行了靜態分析,並分析了結果; ( 3 )用軟體進行了額定壓下的瞬態分析,得到了轉矩,位移,轉速隨時間變化曲線圖,利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較,採用等效法計算了堵轉時的最大力並做實驗進行了驗證,由實驗測得了三相波形,並與計算結果進行了比較,對其不對稱性進行了定性分析。
  12. Digital signal processor ( dsp ) combined with repm bldcm, which build up a dc adjustable speed system, achieve to control multiple motor speed, positive and negative rotate, protect and fault exemine by a true single chip. design and present a electromagnetism scheme of repm bldcm used in electromotion chair drive system. select electronical components and chips in the drive board by contrast with variant drive mode. design the drive board principle picture, make a drive board pcb and debug it. design a principle picture with dsp core. workout the motor control code introduced popular programme modle. test the programme reliability and control performance by linking tms320lf2407 evm, pc, drive borad and the bldcm. the bldcm swatch is prepare experiment

    本論文闡述了方波驅動稀土永無刷直動機的原理及數學模型;設計並給出了一種動座椅用稀土永無刷直動機的設計方案;對機採用何種驅動方式進行了對比分析;對驅動進行了元器件選型、原理圖設計、制板及調試;有針對性的闡述了dsp在本系統應用中所涉及到的功能模塊;設計了以dsp為核心的控制原理圖;以模塊化的軟體編程思想編制了機控制軟體;通過tms320lf2407目標板、上位機、驅動板及機的聯調,證明了系統可行。
  13. It is evident from figure 42 that if a ground network contains loops there is a greater danger of it being vulnerable to emfs induced by external magnetic fields, and of ground current ' escaping " from high current areas to cause noise in sensitive regions

    從圖11 . 42可見,如果存在地線迴,外界場切割地線迴時容易出現感生動勢,大會「四處竄」 ,影響精密
  14. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試向偏置線圈輸入偏置和小信號測試,兩者產生的偏置場在控制線圈產生感應信號,檢測檢測控制線圈端壓並提取含有轉子位移信息的壓信號,該信號經半波整和低通濾波后得到與轉子位移成正比例的直信號,再由pid控制器轉換為轉子位移的控制信號,最後控制信號輸入功放產生控制,實現閉環控制。
  15. General model c38 dc meters are portable taut - band suspended moving coil instruments with light - spot indication. the meters have the feature of extremely high in sensitity and small in consumpition being particularly suitable to be used for measuring weak electric quantity on dc circututs, also for testing the static paramenters of transistors as well for measuring the output of millivolt values of zhermocouple in the vacuun furnaces ( or hydrogen furnaces )

    C38型直表是系張絲支承光點指示可攜式表儀表具有極高的靈敏度,功耗小,特別適合弱量直測量及晶體管靜態參數測試用以及用做真空爐(或氧氣爐)中測量熱偶的輸出毫伏值
  16. In particular, the magnetic integrated techniques of the doubler - current rectifier topology applied for the secondary circuit of the transformer are researched carefully

    同時對隔離型拓撲的變壓器副邊整以及集成技術在倍拓撲中的應用進行深入研究。
  17. Abstract : a simple and high - performance brushless dc generator consisting of a controlled rectifying circuit and permanent magnet square wave motor is presented

    文摘:提出了一種可控整,它與永方波機聯合構成一種簡單、高性能的無刷直機。
  18. In order to insure pressurize, the edges and corners of the flume box should be agglomerated with right - angle aluminum material. in the part of the water heater circuit design and analysis, base on the induction cooker circuit, the main circuit, control circuit, protection circuit were mainly analyzed. and some circuits those do not relate close to the water heater circuit were ignored

    熱水器的設計分析部分,主要在的基礎上,著重對主、控制、保護進行分析,分析了的工作原理和工作過程,而對于與熱水器關系不大的某些如試探脈沖產生和負載檢測等可以忽略。
  19. The core component for ktws digital dc computer - controlled governing system is the controlling units provided by british - eurothem. the cabinets adopted framed structures and standard design

    Sf - ts1 - iii系列直調速系統和勵分別採用三相橋式和單相橋式全控整
  20. Since the dc current on each side is the same, the effective dc in the transformer core is cancelled, so there is no need to provide for a large dc component

    因為兩臂的直相等而方向相反,所以在變壓器鐵心中有效直通是互相抵消的,所以不再需要巨大的直元件。
分享友人