磁通量流 的英文怎麼說

中文拼音 [cítōngliángliú]
磁通量流 英文
flux flow
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 通 : 通量詞（用於動作）
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 通量 : [物理學] flux; shower
  1. The verify experiment proves that its ratio and phase characteristics are much better than ordinary ones and the precision is enough for measure use. zero - flux current transformer can ’ t obtain absolute zero flux because residuary flux, so when the secondary turns is too small it will not satisfying. to improve the precision further, proposes a method to compensate zero - flux current transformer using capacitance parallel connected coil and deduces it

    為了進一步抵消剩餘磁通，提高互感器的精度，提出了一種並聯電容線圈補償零磁通的方法，並進行了理論推導，設計了基於該方法的100匝電流互感器，通過校驗證明它可以改善零磁通電流互感器的比差和角差特性，提高互感器的精度，將電流互感器的二次匝數由普通互感器的幾千匝降到了100匝，提高了測量微小電流的能力。
  2. When the secondary circuit is closed, both primary and secondary currents set up a flux in the core.

    當次級電路接通時，初級電流和次級電流都在鐵芯內建立了一個磁通量。
  3. From the model, we can solve and gain the values and change orders of charging current, charging voltage, discharging current, discharging voltage and inductive current. after that, the electromagnetic fields can be created from two circuits " currents, and their magnetic rector and flux can be simulated from ansys solver

    用ansys multiphysics模塊求解出充電電流、充電電壓、放電電流、放電電壓和感應電流以及這些參數隨時間變化的規律：然後利用兩個迴路的電流耦合出電磁場，並模擬出磁矢量、磁通密度。
  4. Based on the special property of magnetic fluid ( mf ), we fill the magnetic fluid into the working clearances of the servo valve torque motor. one side, the magnetized magnetic fluid can exert a damping torque on the torque motor armature and reduce vibration of the armature ; on the other side, it can improve the magnetic circuit efficiency of the torque motor because of the magnetic fluid ’ s larger magnetic permeability

    基於磁流體所具有的特殊性質，將磁流體添加到伺服閥力矩馬達的工作間隙中，一方面磁流體被磁化后可增大銜鐵的阻尼力，減少振動;另一方面由於力矩馬達氣隙中磁導率的提高，使氣隙中的磁通量增大，力矩馬達的磁路效率和輸出扭矩將增大，因此可以提高力矩馬達的固有頻率和伺服閥的響應速度。
  5. By regulating the compensation current injecting into the compensation winding of the reactor, the reactor inductance at different harmonic frequencies can be independently and continuously adjusted

    有源電抗器由一對耦合繞組和一個補償電流發生器組成，通過控制有源電抗器補償繞組中的諧波磁通補償電流，可以獨立且連續地調節電抗器在不同諧波頻率下的電感量。
  6. In this paper, several scheme of vscf is compared firstly, of which gets doubly - fed generating mode. doubly - fed vscf wind power generating system uses a doubly - fed induction generator, which rotate speed can be able to change with wind turbine, and it ensures a constant - frequency output, by controlling the frequency of current input into rotor windings. in vector trans control system, the control of stator active power and the control of stator reactive power can be essentially decoupled, and the former is via torque component and the latter is via exciting component of stator current

    本文首先比較了幾種變速恆頻方案，從中選擇了雙饋式變速恆頻方案；它運用雙饋電機的工作原理，允許發電機轉速變化，而在電機轉子側接入低頻勵磁電流，通過控制該電流的頻率，保證雙饋電機定子輸出的頻率恆定；再結合矢量控制技術，通過調節轉子電流來控制定子電流的轉矩分量和勵磁分量，相應獨立地控制發電機輸出的有功功率和無功功率。
  7. When the secondary circuit is open, the core flux is produced by the primary current only.

    當次級電路開路時，鐵芯磁通量僅僅由初級電流產生。
  8. As a non - linear and multi - coupled system, the control of the ac induction motor ( acim ) has long been challenging. thanks to the vector control algorithm, acim can offer the same control capabilities and dynamic performance as traditional high - performance dc motors. with the vector control algorithm, the stator current of acim can be expressed in two orthogonal axes, and thus the rotor flux part and torque are de - coupled

    交流感應電機難于控制是因為它是一個非線性、多耦合的系統，矢量控制演算法通過坐標變換將異步電機的定子電流分解為轉子磁鏈方向和與之垂直方向的兩個分量分別進行控制，從而實現轉子磁通和轉矩的解耦，使得交流感應電機的動態性能可以和直流電機媲美。
  9. In this thesis, studies are made on the problem of time - harmonic electromagnetic fields excited by an arbitrary current dipole in spherical conductor. the problem is presented in eddy - current nondestructive test and geophysical prospecting. under the condition of magnetic quasi - static state, the boundary - value problem about modified magnetic vector potential is solved and the analytical solution is obtained

    本論文針對渦流無損檢測和地球物理勘探領域用到的球導體中時諧電流元的電磁問題做了研究，在磁準靜態近似下，求解了修正磁矢量位的邊值問題，獲得了問題的解析解，並利用通用有限元分析軟體做了數值驗證。
  10. If the upwelling is strong enough, the top of the poloidal loop is expelled from the core [ see box on this page ]

    如果涌升流夠強，極向磁場環圈的頂端會被排出到地核之外（見本頁反向通量斑塊） 。
  11. Two generating methods of compensation current are also proposed for the purpose of eliminating detuning or limiting harmonic voltage contents, in which the compensation current is the weighted superposition of filter harmonic currents or voltages and the regulating factor

    針對消除失諧或限制諧波電壓含量的不同控制目標，提出了諧波磁通補償電流的兩種生成方法，補償電流分別是濾波器電流或母線電壓中各次諧波分量與調節系數的加權合成。
  12. A measure of the induced voltage in a circuit caused by a magnetic flux and equal to the flux times the number of turns in the coil that surrounds it

    碰撞，匝鏈電路中由於磁通量而造成電伏減少的單位，等於穿過一載流線圈的磁通量與線圈匝數之積
  13. According to the vector control theory of an induction motor, we utilize the speed estimation and speed control by the rule that the rotor flux of the voltage model must be coincident with the one of the current models

    根據異步電機矢量控制理論，本系統利用電壓模型的磁通應與電流模型的磁通相一致，實現轉速推算和轉速控制。
  14. This strategy has many advantages : solving the problems that the system is unsteady under super - synchronization ; improving power factor of stator ( it is unity relative to that of rotor ) ; no rotor position sensor and no initial position measurement, easily building up doubly fed speed adjustment system with speed sensorless because adjusting speed is taken in the rotor coordinate and rotor current vector fixing is implemented

    該方案由於引入了定子電流勵磁分量的閉環控制，使系統同時具有轉速和勵磁調節兩個調節通道，具有如下優點：一、解決了超同步工作工況不穩定的問題；二、提高了定子側的功率因數（與轉子側功率因數為1相比） 。三、由於速度調節在轉子坐標系下進行，並以轉子電流矢量定向，所以無須轉子位置傳感器，也不用檢測初始位置，易於組成無速度傳感器雙饋調速系統。
  15. A high temperature superconducting quantum interference device ( squid ) was fabricated for magnetocardiogram ( mcg ) measurement, and a single - channel dc squid magnetocardiograph was developed

    摘要研製了用於心磁測量的直流高溫量子干涉器，並建立了單通道高溫直流超導量子干涉器心磁圖儀。
  16. Achieving the sinusoidal waveform of magnetic flux in ac magnetic measurement by digital feedback of harmonic compensation

    利用數字式諧波反饋實現交流磁測量磁通波形正弦
  17. In engineering, vector control ( vc ) is called as filed orientation control ( foc ). the principle of foc is to divide stator current into two dc components. one of them is oriented to the rotor magnetic flux, another is oriented to the torque. the operating process can be carried out by transforming coordinate in magnitude flux and torque keeping consistent conditions

    矢量控制一般稱為磁場定向控制，該控制理論的原理是在轉子磁通和轉矩保持不變的情況下通過坐標變換將異步電機的定子電流分解為按轉子磁場定向的兩個分量分別進行控制，從而實現轉子磁通和轉矩的解耦。
  18. In the paper, the principle and actualizing means of spatial vector control have been systemically discussed and the control software has also been designed. the magnitude of both the rotor flux and the current in torque component have been estimated by using a flux observer, which is developed based on field orientation control principle. the results show that the observer has a good feature due to its speed being calculated without speed sensor or additional hardware

    本文對矢量控制的原理、控制方法以及控制實施策略進行了較為系統的分析與研究，利用速度間接觀測理論，建立了異步電機的磁通觀測器，電機的定子磁通和電流的轉矩分量可以通過磁通觀測器估算出來，從而得到電機的轉速，並由此建立了異步電機無速度傳感器矢量控制的理論數學模型和相應的控制演算法，在此基礎之上，利用工程中常用的電機專用dsp晶元tms320lf2407作為處理器，對異步電機進行變頻調速控制。
  19. The advantages of this system are that the fluxes from the current model are easily obtained, all of the fluxes ( from voltage and current models ) are dc quantities, which are convenient for control and checking, and the system stability is easily analyzed. a further advantage is the avoidance of integration problems

    本系統的優點之一是磁通的指令值通過計算電流模型而獲得，所有的磁通量（電壓、電流模型）都是直流量，便於控制和檢查，系統的穩定性易於分析，另一個優點是利用磁通觀測器可以避免用電壓模型推算磁通時的積分運算問題。
  20. Core losses are caused by an alternating magnetic field in the core material, thie losses are a function of the operating frequency and the total magnetic flux swing, the total core losses are made up of three main components, hysteresis eddy current and residuallosses, these losses vary considerably from one magnetic material to a - nother, applications such as higher power and hither frequency switching regulators and rf designs require careful core selection to yield the highestinductor perfor - mance by keeping the core losses to a minimum

    鐵損是由於在鐵芯中的變更磁場院所造成，這個損失與操作頻率及總流動的磁通量有關，總鐵損由三個成份組成，磁滯損，過流損及殘留損，這些損失因磁性材料不同而異，在如高功率切換調整器和rf的設計需要小心選擇鐵芯種類以降低鐵損使電感的表現最佳。
分享友人
分享到 Line

分享到臉書