磁鏈 的英文怎麼說

中文拼音 [cíliàn]
磁鏈 英文
flux-linking
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 鏈 : Ⅰ名詞1. （鏈子） chain Ⅱ動詞（用鏈栓住） chain; enchain Ⅲ量詞（計量海洋上距離的長度單位） cable length
  1. Three magnetic chain models of asynchronous electromotor are gotten from t - ii evanescence equivalent

    由t ?型瞬態等效電路得出異步電動機的三種磁鏈模型。
  2. Analyzing the limitation of method to observe the stator flux linkage of traditional dtc, indicated the key approach to achieve improvement for dtc preferment is to observe the flux linkage accurately

    深入研究了傳統dtc控制採用的定子磁鏈觀測方法的局限性，提出實現高性能的dtc控制的關鍵環節是實現對電機磁鏈的準確觀測。
  3. The algorithm of svpwm that is adopted by the system implements motor speed - regulation by control of magnitude and phase of motor flux. it can generate less harmonics in the output current of power inverter and less losses of ac motor, reduce pulsant component in output torque and raise availability of dc supply voltage

    系統採用的svpwm演算法通過對空間磁鏈矢量幅值和相位的控制來調節電機轉速，減少了逆變器輸出電流的諧波，降低了脈動轉矩，提高了電壓的利用率。
  4. Permanent magnet synchronous motor ( pmsm ) drived by triphase sinusoidal current is research object in this paper. its mathematics models in several coordinate are set up, controlling principles of flux linkage and torque are discussed under dtc and the block diagram of pmsm with dtc is presented

    本文以三相正弦波驅動的永磁同步電機（ pmsm ）為研究對象，建立了其在不同坐標系下的數學模型，並深入探討直接轉矩控制中永磁同步電機的磁鏈和轉矩的控制思想，給出控制方案。
  5. In the models, the iron core nonlinearly of the traction transformer and the magnetic hysteresis effect without the b - h curve are considered. having tested by digital simulation, the winding parameter has not changed in the state of external fault or magnetizing inrush etc. but the winding parameter has obviously changed in state of inter fault or inter - turn fault. ( 3 ) the rules three phases converted to two phases of traction transformer in electric railways are developed in this paper

    （ 3 ）利用牽引變壓器磁鏈平衡方程，建立了基於系統辨識理論的雙繞組單相接線牽引變壓器、阻抗匹配平衡牽引變壓器及scott （斯科特）接線牽引變壓器的「灰箱」模型，該模型考慮了牽引變壓器鐵芯非線性和磁滯效應，但又不直接反映在模型中，並且無需鐵芯的b - h曲線數據。
  6. One of the fuzzy controllers functions as speed controller, while the other two function as magnetic thrust controller and magnetic flux controller respectively

    1個模糊控制器作為速度控制器，另外2個模糊控制器分別作為電磁推力控制器和磁鏈控制器。
  7. The improved voltage model of rotor flux is proposed in the paper. it eliminates the influence to actual system function in the voltage model of rotor flux for the proper drift problem and cumulative error of pure integral calculus tache

    提出了改進的電壓型轉子磁鏈估算模型，消除了電壓型轉子磁鏈估算模型中純積分環節所固有的漂移問題和積累誤差對實際系統性能的影響。
  8. A model and integrable equation of inhomogeneous generalized heisenberg ferromagnet

    非均勻推廣的海森堡鐵磁鏈模型與可積方程
  9. This paper investigates the integrable inhomogeneous generalized heisenberg ferromagnet model by using the prolongation structure theory

    摘要利用延拓結構研究了可積的非均勻推廣的海森堡鐵磁鏈方程。
  10. By associating the spin vector of the inhomogeneous generalized heisenberg ferromagnet with the binormal to a moving curve in minkowski space, the corresponding equivalent coupled inhomogeneous integrable equation is present

    通過將非均勻推廣的海森堡鐵磁鏈的自旋矢量取為閔可夫斯基空間中曲線的次法矢量，得到相應的耦合的非均勻可積方程。
  11. The control tactics of space voltage vector are investigated, and the simplified algorithm which judges the sector location of reference vector and calculates switch operation time is put forward. by analyzing the current hysteresis control, the relation between switch frequency, and hysteresis bandwidth and input inductance of pwm rectifier is deduced. by applying instantaneous power theory, the principle of pwm rectifier power control is analyzed, and the direct power control by matlab toolbox through estimating active power and reactive power with virtual flux is realized, and the simulation results prove that it is correct

    對常用空間電壓矢量控制策略進行分析，提出了給定參考矢量所在區間判斷的簡化方法，以及電壓矢量作用時間的求取方法；分析了電流滯環控制策略，推導出開關頻率與滯環帶寬以及整流器輸入電感之間的關系；應用瞬時功率理論分析pwm整流器功率控制原理，通過虛擬磁鏈估計有功功率和無功功率，用matlab實現了直接功率控制，並驗證了該控制方法的正確性。
  12. According to the characteristics of dtc ( direct torque control ) in induction machine, this paper analyzed the estimation error of flux linkage and torque, and introduced an improved method of flux estimation, a compensation method based on low - pass filter

    摘要根據感應電機直接轉矩控制的特點，對低速下磁鏈觀測誤差產生的原因進行了分析，給出了一種磁鏈觀測的改進方法低通濾波器補償法。
  13. This paper gives the fundamental equation of electric circuit of switched reluctance generator ( srg ). the phase flux linkage, indutance and phase current of srg are discussed based on unsaturated magnetic circuit

    給出了開關磁阻無刷發電機的相電路基本方程，分析了基於不飽和磁路條件的相磁鏈、相電感和相電流。
  14. This paper also use non - linear feedback decoupling theory to decouple die vector - control close - loop system into linear decoupling of rotor speed and rotor flux linkage subsystems. the speed regulator and flux linkage regulator of these two linear subsystems can be designed with classical linear theory

    本文同時還應用非線性反饋解耦理論將矢量控制的閉環系統分解為線性化的轉速子系統和轉子磁鏈子系統，兩個子系統中的速度調節器和磁鏈調節器可按線性理論設計。
  15. In the paper, a speed estimator based on artificial neural network is designed according to the principle of direct torque control, the speed estimator is optimized by genetic algorithm, and the parameters of pid speed adjuster is also optimized by genetic algorithm. a stator linkage and torque observer based on stator resistance estimator using fuzzy neural network is also designed. eventually, the intelligent control of direct torque control system is implemented

    本文根據異步電動機直接轉矩控制原理，在應用人工神經網路進行速度辨識的基礎上，利用遺傳演算法對神經網路速度辨識器進行了優化設計；運用遺傳演算法對pid速度調節器的結構和參數進行了整合；在採用模糊神經網路對電機定子電阻辨識的基礎上，進行了定子磁鏈及轉矩的觀測，為最終實現無速度傳感器直接轉矩控制系統的智能控制創造了條件。
  16. Considering the system ' s wide speed range and ipm ' s switching frequency ' s top limit, the variable flux linkage locus structure control has been executed in the full speed adjusting range

    考慮到系統調速范圍寬和逆變器開關頻率的限制，在全頻域採用分段變磁鏈軌跡結構的控制方法。
  17. Based on the theory creation of space voltage vector ' s polygonal flux linkage locus, freewill partition of the ideal flux circle is realized by the software method. furthermore, different polygonal flux linkage locus ' s fluent switching point is also found, which overcomes the motor " switching failure and improves the speed adjusting dynamic performance

    在充分研究磁通軌跡法原理的基礎上，採用軟體方法實現了任意多邊形磁鏈軌跡的生成；並找出了不同磁鏈軌跡間的平滑切換點，解決了切換時的電動機失步問題，提高了系統轉速調節的動態性能。
  18. The dissertation deals in details with the basic principle of direct torque control. according to the faults of traditional direct torque control and the requirement of an induction motor ' s control strategy change the method of regulating stator flux to make its path approximate to a circle as possible as could. to get quickly torque control, use a three - value regulator

    本論文介紹了電動機直接轉矩控制的基本原理，並根據傳統直接轉矩控制存在的缺點以及對電動機調速性能的要求，改變對定子磁鏈的調節方式，使定子磁鏈軌跡近似為一圓形，對轉矩採用三值調節器進行調節，以實現轉矩的快速調節。
  19. The accurate calculation of the input voltage and the compensation for the dc - offset error and the variation of the stator resistance are important factors in practical implementation of the integration since they can cause a drift in the stator flux linkage trajectory and furthermore deteriorate the quality of torque control

    因此，輸入電壓的準確計算、直流漂移量的補償以及定子電阻變化的補償都是影響積分計算準確性的重要因素，這些誤差會導致定子磁鏈軌跡的偏移，進而降低系統轉矩控制的性能。
  20. In the control software, the object - oriented method is used for doing system analysis and study. furthermore, the message - driven mechanism is used in the control software research and design. the instantaneous zero vector inserting space vector pwm theory is adopted to control the permanent magnet synchronous machine as the driver motor in the control software

    軟體採用面向對象的程序設計方法對系統進行分析與研究，將消息驅動機制應用於控制軟體的設計和開發之中，在控制軟體中採用瞬時零矢量插入磁鏈軌跡法（電壓空間矢量法）來控制永磁同步電機。
分享友人
分享到 Line

分享到臉書