磁電機驅動 的英文怎麼說

中文拼音 [diàndòng]
磁電機驅動 英文
magneto drive
  • : 名詞1. [物理學] (磁性; 能吸引鐵、鎳等的性質) magnetism 2. (瓷) porcelain; china
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : machineengine
  • : 動詞1. (趕) drive (a horse, car, etc. ) 2. (快跑) run quickly 3. (趕走) expel; disperse
  • 電機 : (任何產生和應用電能的機器 特指發電機、電動機) any power generating or power driven machine esp ...
  • 驅動 : [機械工程] drive; prime mover
  1. Finally, because high - speed power solenoid valve is one of the most important executive parts in the electronic control diesel engine and the performances of diesel engine are strongly related to the solenoid valve, the response performance of the solenoid valve is investigated. the response performance of the solenoid is influenced by many factors, such as driving voltage, electric driving unit etc. in order to have high excitation voltage and in low maintaining voltage, a high - low voltage electric driving unit is designed, and in order to make the solenoid valve close more rapidly, an active free - wheeling circuit and a bootstrapping circuit are designed in the electric driving unit, too. in the high - low electric driving unit, high voltage and low voltage are supplied by the dc - dc device and by the accumulator respectively

    高速強力閥的響應性能除了與閥本身的結構和材料有關外,與壓、路的設計密切相關,本文通過分析,首先開發出一種高低壓路,高壓源是山升壓式dc - dc原理獲取的,低壓由蓄池本身提供,實現高壓強激和低壓維持的功能,路中採用有源續流柴汕中卜軌知介系統的設訓及其七川j敝略的叭究路進行續流,加誣了閥的關閉速度;採用自舉吐路,降低了場效應管對壓的要求。
  2. Ruichi " brandmagnetic pump is mainly made up of pumpbody, gears, magnetic combined bearing equiptment isolation cover, motor and so on. gear wheels joined with the inner magnetic steel are fixed in a hermetically sealed chamber which is made up of pumpbody and isolation cover. the motor powers the outer magnetic steel, the outer magnetic steel power the inner steel. gear sheels are made to try turn. thus dynamic hermetis seal is replaced by a static hermetic seal to get the result of importing medium wihtout leakages

    「瑞馳牌」力泵泵體主件是由和從場鋼杯組成性聯軸節外鋼和相聯為主件內鋼和葉輪相聯為被件當后通過力藕合葉輪同步工作泵的結構要點以靜密封取代密封使泵的過流部件完全處於密封狀態從而保證了介質和外界隔絕徹底解決了離心泵械密封一直解決不了的跑、冒、滴、漏之弊病。
  3. The magnetic mechanical engineering technology is a new high - level technology in the current world, which uses the permanent magnetism materials to engage in the research, development and production of the permanent magnetism effect parts, including the magnetization parts, magnetism - droved machinery, magnetoelectricity machinery and so on

    械工程技術是當前世界新興的高水平的一項學科技術,是應用永材料從事化器件、械和械等永效應組件的研究、開發、生產;並逐步實現技術產業化、產品社會化的系統工程。
  4. Being a sort of new principle micromotor in the fronitier of science. the ultrosonic motor ( usm ) is developed at recently twenty years. utilizing the stator surface particle elliptical motion excited by piezoceeramics, the usm is drived by friction force between the stator and rotor. compared with the conventional electromagnetic motor, the ultrasonic motor has the following features : high speed, high holding torque when power is off and so on. because of it ' s characteristics, the ultrasonic motor has obtained some widespread application in robots, precise instrument, house electronical appliance, sapceecraft automobile and micromechanism

    超聲波( ultrasonicmotor )是近二十年來發展起來的一種新原理,其原理不同於傳統的,它是利用壓陶瓷的逆壓效應使定子的表面質點產生橢圓運,通過定子和轉子之間的摩擦力轉子運。這種新型的與傳統相比,具有響應快、不受干擾、結構緊湊、低速、大扭矩、斷自鎖等優點,因而在微型械、器人、精密儀器、家用器、航天器、汽車等方面顯示出廣泛的應用前景。
  5. Practical design for controller of switched reluctance motor drive

    一種實用的開關控制器設計
  6. For the bldcm which has a general crest width of the back - emf waveform, two kinds of torque ripple conditions when drived by sine - wave current as well as by square - wave current are deduced based on the mathematical models. in addition, a comparison is carried out between these two conditions, which indicates that sinusoidal current driving is more favorable to minimizing the torque ripple when the crest width of the back - emf waveform is less than a certain value

    闡述了抑制齒槽轉矩措施對反勢波形的影響,利用無刷直流的數學模型推導並比較了任意平頂寬度梯形波反勢在正弦波和矩形波兩種下的轉矩脈情況,得出在梯形波平頂寬度減小到一定數值后採用正弦更有利於減小轉矩脈
  7. Digital signal processor ( dsp ) combined with repm bldcm, which build up a dc adjustable speed system, achieve to control multiple motor speed, positive and negative rotate, protect and fault exemine by a true single chip. design and present a electromagnetism scheme of repm bldcm used in electromotion chair drive system. select electronical components and chips in the drive board by contrast with variant drive mode. design the drive board principle picture, make a drive board pcb and debug it. design a principle picture with dsp core. workout the motor control code introduced popular programme modle. test the programme reliability and control performance by linking tms320lf2407 evm, pc, drive borad and the bldcm. the bldcm swatch is prepare experiment

    本論文闡述了方波稀土永無刷直流的原理及數學模型;設計並給出了一種座椅用稀土永無刷直流設計方案;對採用何種方式進行了對比分析;對路進行了元器件選型、原理圖設計、制板及調試;有針對性的闡述了dsp在本系統應用中所涉及到的功能模塊;設計了以dsp為核心的控制路原理圖;以模塊化的軟體編程思想編制了控制軟體;通過tms320lf2407目標板、上位板及的聯調,證明了系統可行。
  8. The subject of this thesis is to study ironless moving coil linear permanent magnet synchronous motor and the major works in this thesis are summarized as follows : 1 ) two analytical formulas are derived by concentrated current method and distributed current method to determine the magnetic field due to pm, based on the current model of pm. besides, two method ( magnetic charge method and solution by laplace equation method ) are also introduced with comparing their advantages and disadvantages. then the effects of the motor parameters on the flux distribution are discussed

    本文對空芯圈式直線同步進行了深入細致的研究,內容包括: ( 1 )採用流模型推導出兩種計算永極二維氣隙場的解析公式(集中流法、分佈流法) ,同時介紹了兩種永氣隙場計算方法(荷法,直接求解拉氏方程法) ,分析各種方法的優缺點,討論參數對氣隙密的影響; ( 2 )介紹了單層同心繞組的布置方式,根據安培定律推導出空芯圈式直線永同步的靜推力計算公式,分析靜態力?位移特性; ( 3 )建立空芯圈式直線永同步態模擬模型,模擬不同方式下、穩態運行時力、速度、位移的變化情況。
  9. On the aspect of the dynamic character, the electrocircuit model of the motor is being realized on the pspice environment. the transient character of the pmlsm under the sinusoidal power is reached using the pspice model at circuit level, the results are compared with those using time - stepping fem

    態性能方面:建立了的pspice模型,在pspice環境下對進行正弦波下瞬態特性的模擬,並與以場分析為基礎的時步有限元態模擬分析進行了比較。
  10. Magnetos. flange mounting and drive

    .凸緣安裝和
  11. Based on comparison of several motor candidates, doubly salient permanent magnet ( dspm ) motor is a good choice for it ’ s outstanding performance. similar to conventional drive system, dspm brushless dc motor ( dspm - bldcm ) is composed of dspm motor and it ’ s controller. the controller is made up of three - phase full - bridge inverter, driver, dsp control unit and etc. for high power system, every switch of three - phase inverter is actually made up of four mosfets in parallel

    在充分考慮國內外不同的液壓泵的基礎上,本文選用了雙凸極永作為整個系統的本體,並配以控制器(控制器包括三相橋式功率變換器、路、 dsp主控單元、流采樣及預處理和位置采樣及預處理等主要部分)組成整個液壓泵系統。
  12. The apace vector pwm has the character of wide linear range, little higher harmonic and easy digital realization, so it is being widely used in pmsm driver system

    摘要空間矢量pwm調制,它具有線性范圍寬、高次諧波少、易於數字實現等優點,在新型的永同步器中得到了普遍應用。
  13. The background of this dissertation is the gantry synchronous control problem of numerical control gantry - moving type milling machining center drived by two linear permanent magnet synchronous motors with the same parameters. theory of dynamic precision synchronization traverse and research of realization methods for linear servo dual position loops system is researched

    以兩臺永直線同步的數控龍門移式鏜銑加工中心同步控制問題為背景,對直線伺服雙位置環態精密同步進給理論和實現方法進行研究。
  14. Research on permanent magnet wheel motor system for electric vehicle

    汽車用輪式永磁電機驅動系統的研究
  15. A novel pm motor drive system for electric vehicles with wide speed range

    一種新型車用寬調速永磁電機驅動系統
  16. Switched reluctance motor ( sr ) is a new - type drived - electromotor system which develops rapidly since 1980. the structure of the srd is simple

    開關型系統( switchedreluctancemoter ,簡稱sr)是20世紀80年代迅猛發展起來的一種新型調速系統。
  17. In this paper, the development trend of micro - electronics equipment, the progress situation of precision work stage for laser photolithography equipment and the research and evolution of magnetic levitation technology in china and other countries are discussed generally. the main function, the demand of technical index and key technology of laser photolithography work stage are introduced simply. the magnetic levitation technology and the work principle of linear motor are stated, and the design and analysis method of mechatronics cad / cae for magnetic levitation precision stage is presented

    本文綜述了微子製造設備發展趨勢及其精密工作臺如光刻工作臺的國內外發展現狀及懸浮技術研究進展,簡要介紹了光刻工作臺主要功能、技術指標要求、組成及關鍵技術,概述了懸浮技術及直線的工作原理,著重研究用一體化cad cae集成技術設計、分析懸浮精密定位工作臺的方法,闡明了應用cad cae技術研製懸浮精密定位工作臺的現實意義。
  18. Permanent magnet brushless dc motor is selected for pump driving, a neutral simulator of back - emf is set up for rotor position sensing solution instead of sensor, which proved to be right in theory

    本論文敘述了一種智能、高效的光伏水泵系統,系統採用無位置傳感器的永直流無刷水泵。
  19. We can foresee the further development about pmbldcm and its control system with the price debased of permanent magnet material and manufacture of rotor. pmbldcm may have a wonderful foreground in many fields

    可以預見,隨著永材料和子器件的價格的進一步降低,以及無刷直流的理論研究和實踐應用的不斷完善和提高,永無刷直流及其控制系統將在很多場合有廣泛的應用前景。
  20. We designed and realized the experiment of testing the characteristic of propulsion and levitation force of lsm. the characteristic curve of propulsion and levitation force - power angle is measured and the effect of excitation on propulsion force and levitated force of motor is analyzed. the analytical result is compared to that of experiments

    論文設計並進行了直線同步力和懸浮力特性實驗,測量了力和懸浮力與功角的特性關系,分析了勵性能對力與懸浮力的影響。
分享友人