磨光盤 的英文怎麼說
中文拼音 [móguāngpán]
磨光盤
英文
buffing disk-
The diameter is 50 centimetres, with pitch - dark as bottom, with red green, getting red various kinds of color paint draw out the pattern, is it make various kinds of butterfly and flowers line kind to carve silver thin slice and then, paste in painting childing smooth of polishing with big paint, after being dry, overall xiu several of paint is it show silver pattern to grind and then, make pattern and paint bottom up to the same pingdu, in addition push the light and become exquisite and flat to take off the flower disc of lacquer ware
直徑50厘米,以黑漆為底,用紅、綠、紅等各種色漆繪制出圖案,再將銀薄片刻製成各種蝴蝶與花卉等紋樣,用大漆粘貼在打磨光滑的漆胎上,待乾燥后,全面髹漆數層再經研磨顯出銀花紋,使花紋與漆底達到同樣平度,再加推光就成為精美的平脫漆器花盤。The ruddy brick floor smiled up at the smoky ceiling ; the oaken settles, shiny with long wear, exchanged cheerful glances with each other ; plates on the dresser grinned at pots on the shelf, and the merry firelight flickered and played over everything without distinction
赭紅的磚地,朝著煙霧繚繞的天花板微笑;使用日久磨得鋥亮的橡木長凳,愉快地互相對視;食櫥上的盤碟,沖著碗架上的鍋盆咧嘴大笑;而那爐歡暢的柴火,閃爍跳躍,把自己的光一視同仁地照亮了屋裡所有的東西。Particular requirements for grinders, polishers and disk - type sanders
研磨機拋光機和盤式砂輪機特殊要求The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine
用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌:用xrd進行原料物相分析,及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度;用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性;用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化;用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試;採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定;用萊次偏光顯微鏡( pm )測試固體潤滑劑的硬度;用材料試驗機測試固體潤滑劑的抗壓強度等。Safety of hand - held motor - operated electric tools. part 2 : particular requirements for grinders, polishers and disk - type sanders
手持式電動工具的安全.第2部分第3節:電磨拋光機和盤式砂光機的特殊要求Safety of hand - held motor operated electric tools - part 2 : particular requirements for grinders, polishers and disk - type sanders ; amendment 1
手持式電動工具的安全.第2部分第3節:電磨拋光機和盤式砂光機的特殊要求.補充件1Particular requirements for battery - operated grinders, polishers, and disk - type sanders
由蓄電池供電的研磨機磨光器和盤形砂輪機特殊要求30 of diameter, black, silver slice flat to take off 5 petals, carve the silver thin slice to make into the lily petal line kind, paste in polishing smooth painting the foetus with the paint, after being dry, overall xiu several dozen of paint is it show silver pattern to grind and then, make pattern and paint bottom up to the same pingdu, in addition push the light to become exquisite and flat to take off the lacquer ware
五朵花圓盤,直徑30厘米,黑地,銀片平脫五朵花瓣,將銀薄片刻製成百合花瓣紋樣,用漆粘貼在打磨光滑的漆胎上,待乾燥后,全面髹漆數十層再經研磨顯出銀花紋,使花紋與漆底達到同樣平度,再加推光則成為精美的平脫漆器。The edge of the disc had been machined flat / smooth
圓盤的邊緣已用機器磨平[光]Non - ground steel wire can be supplied with wire rod, inside diameter : 1800mm ; weight : 500 - 1000kg. special products can be supplied according to the agreement
不磨光鋼絲可盤卷供貨,內徑1800mm ,盤重500 - 1000kg ,特殊要求可協議供貨。A revolving stone disk used for grinding, polishing, or sharpening tools
砂輪用來打磨、打光或磨利工具的旋轉石盤The cmp experiment was carried out systematically on litao3 wafer. the polished surface foughness and material removal rate in different polishing conditions were measured and the effects of polishing pad material and its condition, pressure, rotating speed of the polishing plate, the type and size of abrasive, and the properties of the polishing slurry on the surface routhness and material removal rate were analysed in details
通過對鉭酸鋰晶片的化學機械拋光過程的實驗研究,通過測量鉭酸鋰晶片在不同拋光條件下的表面粗糙度和材料去除率,詳細分析了拋光墊材料和狀態、拋光壓力、拋光盤轉速、磨料種類及粒度、拋光液組成等幾個因素對拋光表面質量和材料去除率的影響規律。A kind of polishing wheel installed in the equipments imported from germany or czechoslovakia and in the polishing machine for crystal glass decoration, which is made from high flexible macromolecule, aluminum oxide and cerium oxide
一種安裝在德國、捷克進口設備以及國內自主研發的水晶玻璃飾品研磨機上的拋光盤(輪) ,它是由高彈性和高強度的高分子材料與很鋒利的拋光性能極佳的氧化鋁、氧化鈰等軟質磨料進行混合反應而製作。After blanting resin abrasive cloth into small blocks, glue them into a disc, it is suitable for buffing surface of workpiece, wildly used in minding and decoration industries
該產品選用樹脂砂布沖成小塊粘合而成的圓盤,打磨工件表面,廣泛應用於廠礦及裝飾行業。主要用在工件較狹窄且較深長的凹槽打磨拋光。Woodworking machines. disc sanding machines with spindle in fixed position. nomenclature
木材加工機械.主軸定位的圓盤式磨光機.專用術語Osc. arthur neubert gmbh polierscheibenfabrik - the delivery program covers brush tools, polishing and buffing discs and polishing rings as well as polishing tool and abrasive cords
是一家誠信的、高效能的生產商和服務商,該公司提供新型的、專門的產品,例如拋光劑、拋光粉、拋光膏、研磨膏,拋光環,磨具,磨料,砂輪;研磨盤,磨具。分享友人