磨料膠合劑 的英文怎麼說

中文拼音 [móliàojiāogějì]
磨料膠合劑 英文
abrasive cement
  • 磨 : 磨動詞1 （摩擦） rub; wear 2 （研磨） grind; mull; polish 3 （折磨） grind down; wear down [out]:...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  1. When fillings is other materials ( unprocessed montmorillonite, powder coal ash, co - composite of powder coal ash and organo - montmorillonite, co - composite ofcarbonizing calcium and organo - montmorillonite ) in the binder and content of organo - montmorillonite in the binder is five percent decided by tensile - shear experiment, tensile - shear strength of binder is up to tiptop ; at the same time, this paper carries out abrasion experiment, and, by comparison, concludes abrasion property of coating is optimum when content of organo - montmorillonite in the binder coating is five percent, and observes abrasion sample under set

    當膠粘劑中填料為其它物質（未處理蒙脫土、粉煤灰、粉煤灰和有機化蒙脫土共復合、碳化鈣和有機化蒙脫土共復合）時，通過拉伸剪切試驗確定膠粘劑中有機化蒙脫土含量為5時，膠粘劑的拉伸剪切強度最高；同時進行了沖蝕磨損試驗，通過比較得出，當膠粘劑塗層中有機化蒙脫土含量達到5時，塗層的耐沖蝕磨損性能最佳，並對沖蝕磨損試樣在掃描電子顯微鏡（ set ）上進行觀察。
  2. The valve ports of the basic material pump, the curative agent pump and proportioning pump all adopt the special alloy with zero leakage

    塗膠機基料泵，固化劑泵及比例泵的高壓閥口，均採用零泄特殊合金研磨製造。
  3. Our rubber roller products are complete in series and meet all the specifcation requirements. they are used in printing houses, paper mills, dye - works, textile mills, plastic processing works, steel rolling plants, timber ( plank ) processing works, office automation equipment, etc. gd xinli produces water rollers, uv rollers, rollers that can resist different kinds of chemical solvents, rollers that can resist acidalkaline, polishing rollers, polyurethane rollers, etc. the annual amount of production reaches 120 tons

    規格品種齊全，適用於印刷、造紙、印染、紡織、塑料加工、軋鋼、膠合板（木材加工）和辦公自動化設備等。例如水輥、 uv輥、耐各種化學溶劑膠輥、耐酸堿膠輥、磨光輥、聚氨酯膠輥等。年產量達120噸。
  4. The grade composite, road performance and its mechanism are systemically studied. 1 ) the aggregate grade of ogfc is studied through the volume method base on the analysis of the aggregate grades. then the grade is verified and the relation between the grade and pore rate is studied statistically, the typical grades of ogfc are developed ; 2 ) the reasonable pore rate of ogfc is studied on the basis of the balance of mechanics and function performance ; 3 ) the mineral fiber is added to the ogfc mixes to increase asphalt content, thus the anti - water performance of ogfc mixes are improved ; 4 ) high viscous asphalt fit for the preparation of ogfc is prepared through composite modification by sbs and rubber powder ; 5 ) the mechanics mechanism of ogfc is studied in the paper, it shows : asphalt paste, as well as the coarse aggregate skeleton, is essential to the mechanics of ogfc

    在分析各國ogfc級配的基礎上，運用礦料體積法進行ogfc級配設計，用正交實驗對礦料級配進行了優化設計，運用數理統計方法分析礦料級配和孔隙率之間的關系，並回歸出礦料關鍵篩孔通過率與ogfc骨架空隙結構關系的數學方程，進而提出了ogfc的合理級配；通過對不同孔隙率典型級配混合料的性能研究，綜合力學和功能性能，得出了ogfc的合理孔隙率范圍：針對高速公路面層對ogfc力學性能方面的要求，本文從瀝青膠結材料、纖維穩定劑兩方面對ogfc的性能進行改善：通過sbs和橡膠粉復合改性的方法開發出了適合ogfc的高粘度改性瀝青，摻加聚合物纖維，提高ogfc的最佳瀝青用量，進而改善了混合料的高溫性能和抗水損害性能，優化設計出能滿足高速公路路用性能，車轍動穩定度達5000次/ mm以上，動融劈裂強度比90 ，透水系數31ml / s ，並具有防滑降噪功能的開級配瀝青磨耗層（ ogfc ）混合料。
  5. 2 resin with bad wetness systems, and non - thixotrpic grind materials. operate as following process : add the paint material and the solvent - add surface active agent if adopt - add the pigment stir, make it disperse or grind to the needed granularity

    2對于非觸變性研磨性磨料，潤濕性差的樹脂體系操作如下：加油漆和溶劑混合加入表面活化劑如果採用加入顏料攪拌分散或研磨分散到所需細度加預凝膠攪拌分散至所需細度稀釋至所需粘度。
  6. 1 resin with bad wetness systems such as epoxy resin, polyester, alkyd, acrylic resin, use compound with the surface active agent, and the thixotropic grind materials can be acceptable. operate as following process : add paint material all kind of resin and the solvent - add the organic bentonite pre - gel, stir enough - add the pigment, stir and disperse enough - dilute

    1潤濕性比較差的環氧，聚酯，短油酸樹脂，丙烯酸樹脂等與表面活化劑合用，且觸變性研磨料科被接受的情況下，按照以下步驟操作：加油漆和溶劑混合加入有機預凝膠充分攪拌分散加入顏料充分攪拌分散稀釋。
分享友人
分享到 Line

分享到臉書