積灰 的英文怎麼說

中文拼音 [jīhuī]
積灰 英文
ash buildup
  • 積 : Ⅰ動詞（積累） amass; store up; accumulate Ⅱ形容詞（長時間積累下來的） long standing; long pending...
  • 灰 : Ⅰ名詞1 （物質燃燒后剩下的粉末狀的東西） ash 2 （塵土; 某些粉末狀的東西） dust 3 （特指石灰） lime...
  1. Prevent dust bin of coal mill deduster from accumulating dust

    煤磨除塵器灰斗積灰的預防措施
  2. High temperature resistant measure is taken to extend its service life significantly in comparing with the tube still hot air furnace, whereas, cross brushing of heat sink by the smoke and negative pressure smoke exhaust are used to ensure a clean heat exchanging position with stable thermal performance

    該爐採取了耐高溫措施，從而使其壽命比列管式熱風爐大大延長，並採用了煙氣縱向沖刷散熱片和負壓式排煙方式，換熱部分不積灰塵，無須清理，熱性能穩定。
  3. The article takes a 600mw natural cycle drum boiler ( soot blow using steam ) as investigating object, establishes soot accumulation loss and soot blowing energy loss models for its water cooling wall, superheater, economizer and air preheater respectively, set up instructions for soot blower operating. simulating calculation results are compared with site data to verify usefulness of key models. the article introduced the operation optimizing design of soot blowers of yanzhou no2 power plant based on theoretical research

    本文以600mw汽包自然循環鍋爐（蒸汽吹灰）為具體分析對象，分別建立其水冷壁、過熱器、省煤器、空預器的積灰損失和各受熱面吹灰能量損失的模型，建立相應的吹灰器運行規則指導，對設計中的關鍵模型問題，通過模擬計算及與現場數據作比較的方法，驗證其可用程度。
  4. The bottom of your samples are quite rough, which will result in the accumulation of dust

    並且我們認為我們開發的模具質量比你們寄給我們樣品的質量要好一點，你們給我們的底部比較毛躁，容易積灰塵。
  5. During the discussion of the coefficient which signifies the degree of fouling and slagging, traditional coefficient is abandoned. to the heat surfaces of convection, the coefficient of enthalpy difference is advanced, and to the water - cooled walls, the coefficient of temperature difference is adopted

    對于對流受熱面，本文摒棄了傳統的灰污特徵參數，提出了用焓差灰污系數來反映積灰、結渣程度；而對於水冷壁，在背面溫差法的基礎上又引進了溫差灰污系數。
  6. Slag and ash deposit on coal - fired boiler in thermal power plant not only decrease the boiler efficiency and the plant economy, but also are hidden trouble of many safety accident. and sootblowing is an effective and common means to account for this problem

    電站燃煤鍋爐積灰結渣不僅會降低鍋爐效率、影響經濟性，而且更是多種安全事故的隱患，而採用吹灰器吹灰是解決這一問題最常用最有效的方法。
  7. This paper has analyzed and synthesized the problems of burning heavy viscosity petroleum about injecting steam boilers in liaohe oil field. the heat balance experiments on injecting steam boilers burning heavy viscosity petroleum is made first. the main causes of low thermal efficiency and heat lose of flue gas are the poor effect of atomization and burning with old - fashioned oil nozzles, worse ash gathered on. heat exchange surface and high temperature of flue gas

    本論文在分析綜述了遼河油田注汽鍋爐燃用高粘度稠油時存在的問題的基礎上，首先對燃用稠油的注汽鍋爐進行了正、反熱平衡試驗，分析了注汽爐熱效率偏低、排煙熱損失偏高的主要原因是原噴油嘴改燒高粘度稠油時霧化和燃燒效果差、換熱面積灰嚴重、排煙溫度太高。
  8. No, you ' re gonna box it up so it can iay in storage gathering dust

    不，你可以把他們放起來積灰塵
  9. Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  10. The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  11. It ' s all just been collecting dust

    現在卻都放在那兒積灰
  12. Research on the dynamic characteristic of ash deposition in boilers burning coal and coal water slurry

    煤和水煤漿爐內結渣積灰動態特性的研究
  13. Poor : heavy accumulation of dirt, grease, mold, or other foreign material on any surface

    差：許多表面都有積灰、或油脂、或長霉、或有其他異物。
  14. Evalution and analysis of enhance heat transfer and mitigating soot performance of inside - tube coil inserts

    管內螺旋線圈插入物強化傳熱及抗積灰性能的評述與分析
  15. 5, little resistance and little weight. each performance is better than the compensation device of other materials

    5阻力小，重量輕不積灰，各種性能優于其它材料的補償裝置
  16. After discharge the moment made by heavy hammer and rocker will drive disc close quickly to realize locking air

    一旦積灰卸去后，重錘與搖桿產生的力矩使閥板迅速關閉，實現鎖氣。
  17. During operation of coal fueled power plant boiler, heat exchange surfaces will be polluted by soot accumulation. this seriously weakened the heat transfer capability from gas to working fluid

    在電站燃煤鍋爐的運行過程中，受熱面必然會產生積灰污染，這就大大削弱了煙氣對工質的傳熱能力。
  18. Through verifying, there exist strong bonding force oxide attached on inside and outside wall of low temperature superheater tubes, and ashes are deposited between tubes, which result in producing thermal deviation

    經檢驗，低溫過熱器管內、外壁附著結合力較強的氧化物，管間積灰，導致熱偏差產生。
  19. After the optimizing system is put into operation, online calculating results and operation effect is analyzed, pointing out that the base for the whole boiler soot blow optimization is the minimum loss of soot accumulation and energy consumption of soot blowing, the base for water cooling wall soot blow optimization is the combustion house outlet gas temperature difference, the base for a single heat exchange surface soot blow optimization is the degree of its soot accumulation

    並對優化系統在線運行后，取得的實時計算結果和實際效果進行了分析，著重指出積灰和吹灰的經濟性最佳可作為整個鍋爐吹灰優化的決策依據，爐膛出口煙溫差可以作為爐膛吹灰優化決策的依據，受熱麵灰污程度可以作為單個對流受熱面吹灰優化決策的依據。
  20. The original design was intermediate vapor 42t / h, but the actual output is 30 - 35t / h, at the same time the temperature and pressure of the vapor are unstable, it affects the economic efficiency, the reason were the collecting dust on the heat area and serious corrision, they led to the decrease of the boiler load, and need stop to washing the dust, the article deals with the reform of the exhaust gas boiler, at the basic of the design condition, after thermo calculation, flute gas, resistence calculationand strenth calculation, the structure of the heat surface had been rearranged, then the proof calculation was done

    原設計產中壓蒸汽42噸時，但投運后只產30 - 35噸時，並且蒸汽溫度和壓力均不穩定，影響到經濟效益。其原因是受熱面積灰和腐蝕嚴重，影響傳熱使鍋爐負荷下降，不能長時間運行，需停產清理積灰。本論文針對此余熱鍋爐的技術改造，在給定設計條件基礎上，通過熱力計算，煙氣阻力計算和強度計算，對鍋爐受熱面結構重新布置，然後再作校核計算。
分享友人
分享到 Line

分享到臉書