穩定偏移 的英文怎麼說

中文拼音 [wěndìngpiān]
穩定偏移 英文
steady drift
  • : 形容詞1 (穩定; 穩當) steady; stable; firm 2 (穩重) steady; staid; sedate 3 (穩妥) sure; rel...
  • : Ⅰ形容詞1 (平靜; 穩定) calm; stable 2 (已經確定的; 不改變的) fixed; settled; established Ⅱ動詞...
  • : Ⅰ形容詞1 (不正; 歪斜) inclined to one side; slanting; leaning 2 (只側重一面) partial; prejudi...
  • : Ⅰ動詞1. (移動) move; remove; shift 2. (改變; 變動) change; alter Ⅱ名詞(姓氏) a surname
  • 穩定 : 1 (使穩定) stabilize; steady 2 (穩固安定) stable; steady 3 (物質的性能不易改變的作用) stabi...
  1. We can use the mm5 model in definite time, definite area weather forecasting. we conclude that : : the moving route of this necw in its developing progress was direct - south along latitude, the cold air is rough, and just this made the rough vertical velocity ; the necw southern moving and conflicting with the west pacification sub - tropical high makes rough jet steam. the plenty south - west warm and wet air made by the jet stream gave the rainstorm demanded vapor ;. the rough vertical velocity by jet stream is a main reason in this rainstorm ; the mm5 model uses four - direction analysis data as its input, this avoids some errors occurred in observe and transfer, thus made the result more useful

    綜合分析認為: ( 1 ) 、這次冷渦在其發生發展過程中,其動路徑是沿經圈直線南壓,攜帶的冷空氣勢力較強,形成槽后較強的垂直運動; ( 2 ) 、西太平洋副熱帶高壓北位置與東北冷渦南壓形成的急流軸,把源源不斷的西南暖濕氣流輸送到遼西地區,也就是急流軸的左前方位置,為這次暴雨的產生提供了充足的水汽來源; ( 3 ) 、低空急流不但為暴雨輸送水汽,其造成的較強的垂直環流也是產生強降水的一個主要原因; ( 4 ) 、 mm5模式以四維同化資料作為初始場,最大限度地避免了觀測誤差可能造成的積分不,提高了模擬結果的參考價值。
  2. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉膜表面形貌:用xrd進行原料物相分析,及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度;用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱性;用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉膜表面的元素組成、價態變化;用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試;採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測;用萊次光顯微鏡( pm )測試固體潤滑劑的硬度;用材料試驗機測試固體潤滑劑的抗壓強度等。
  3. Through the theory of light radiation and intensity, we can use the fewest leds to satisfy the luminous intensity demand. through image segmentation theory, we can accurately pick module up from the test stripe when it is put in wrong directions. through image processing theory, we can acquire correct information and avoid the bad effects from the asymmetric chemistry reaction and instability of the devices

    用光的輻射和強度理論,我們計算出了獲得足夠圖像強度所需的最少光源;用圖像分割理論,我們在試紙條傾斜放置或有垂直方向上的時,準確地提取出了各模塊的數據;用平滑濾波和均值濾波理論,我們濾除了由於反應不均勻及硬體設備不帶來的噪聲;用交遇區設計線性分類器的方法,我們降低了有限樣本設計線性分類器帶來的誤差,提高了檢驗準確度。
  4. Comprehensively discuss the issues in application, adaptive condition and performance, propose a fast arithmetic of forward modeling and depth migration in common shot gathers with one - way acoustic wave equation based on vrselrf, and verify the arithmetic by numerical simulation. concisely discuss the cause of the creation of evanescence and the problem of lateral amplitude discontinuity result from it. fourthly, use the reflectivity model, computed to describe the fracture model, with the formula of computation reflectivity based on elastic - acoustic approximation, and the wavelet model computed by the method, wavelet creation with fourier transform, we proposed, in conjunction with vrselrf wavefield extrapolation operator

    第三,將頻率波數域的變參考慢度rytov近似廣義屏波場延拓運算元( vrselrf )應用於疊前與疊后正演模擬、疊前與疊后深度,對演算法應用中應注意的問題、適用范圍、性能等作了較為全面的論述;提出了基於vrselrf的單程聲波方程共炮記錄正演模擬和深度快速演算法,並通過數值模擬試驗對演算法進行了驗證;簡要地討論了倏逝波的產生原因及其帶來的橫向振幅不連續性問題。
  5. The power angle characteristics are acquired and compared with the unsaturated curves. it is concluded that the stability limit of the power angle is less than 90 degree. reactive power regulating curves are calculated and compared with those curves when saturation effect is not considered, the result is that u type curves are deviated to the right

    通過對同步發電機各種運行曲線的計算,在已有文獻的基礎上更進一步分析了鐵磁材料飽和以及磁場畸變對同步發電機運行特性和參數的影響;求出了空載特性曲線和零功率負載特性曲線,在不同的電樞電流下計算得到的波梯電抗不同;求出了功角特性曲線,與不計飽和時的功角特性曲線相比較,功角極限小於90 ;求出無功調節曲線,與不計飽和時相比較, u型曲線向右
  6. In this paper, in order to solve the difficulties in the rain pipe construction in jianyu road of yulin city, the pipe - pushing technique for the hand - type tool pipe in the sand soil layer has been researched by experiments in which many practice problems were considered such as the movement and deformation of sand soil, the difficulties for the pipe to enter the scheduled work soil, the collapse of excavation surface, the departure of pipe center and the difficulties to correct this departure. by both the calculations for the stabilities of back - supporting soil body and excavation surface and the theoretical analysis on the reasons for the departure ' s producing, some construction techniques were introduced and adopted in this paper which include not only the change and reinforcement to both the back - supporting soil body and the scheduled work soil body but also the settings of pipe cap, lattice and correcting system on the head of the tool pipe

    本文針對榆林市建榆路雨水管道中遇到的技術難題,進行手掘式工具管砂土層頂管法施工技術試驗研究,在研究中考慮砂土層存在的后靠土體位、變形,工具管難以進入出洞土體,挖掘面易坍塌、管道中心易差及難糾等問題,通過對后靠土體和挖掘面的計算及差產生原因的理論分析,提出並採用后靠土體換填加固,出洞土體換填加固,以及在工具管頭部設置管帽、格柵、糾系統等技術措施
  7. Because mz interferometric optical fiber gyroscope has bigger nonreciprocal phase, the system thermal stability, polarization noise and the error caused by the fluctuation of light source is particular analysed, some effective methods is proposed such as : using the " quasi - white - light " interferometry and the fiber polish technology accurately to control the fiber length, using depolarization light to minish the polarization error, and using temperature control, optical power control and depolarizer to stabilize the output of the light source

    結合mz干涉式光纖陀螺的存在較大非互易相的特點,著重從其溫度性、振噪聲以及光源波動引起的誤差三個方面分析了抑制噪聲、提高檢測精度的方法,提出了:採用「準白光」干涉測量法結合光纖研磨技術精確控制光纖長度差的辦法;採用非振光源抑制振噪聲的方法;採用溫度控制、功率控制以及消器實現化陀螺光源的方法。
  8. In this thesis we analyze in detail the influence, created by random change of the optical wave polarization, on the output of the interferometer. then several principles of eliminating polarization - induced fading are introduced, and the principle that inserting two faraday rotator mirrors into the end of michelson fiber interferometer to eliminate the fading is analyzed in detail. this method can eliminate polarization - induced fading without additional signal processing, and make the output of the sensor stable

    其中,本文詳細分析了光波振態的隨機漂對干涉儀輸出的影響,介紹了目前幾種消振衰落技術的原理,著重討論了在光纖michelson干涉儀末端加兩個法拉第旋轉鏡的消振衰落的原理,該方法不需要任何附加的信號處理就可以消除振衰落,使干涉儀輸出
  9. Their characteristics of geochemistry, stable carbon isotopic excursion, genetic model are still hot topics to geological field

    其地球化學特徵、碳同位素、成因解說及模式等問題一直是地質學界關注的熱點。
  10. Abstract : to the barycenter offset type self - in - phase vibration screen, thispaper educes the condition that its self - in - phase is existent, analyzes and discusses the steady condition that the self - in - phase existence by establishing the dynamic differential eguation. then combining the design practice, the paper gives the calculating and analysis to the movement condition of the barycenter offset self - in - phase vibration screen

    文摘:通過建立重心式振動篩的動力學微分方程,得出其自同步存在的條件,分析討論了自同步存在的性條件,並結合設計實踐,對重心式自同步振動篩的運動狀況進行了計算分析。
  11. On the base of the fujian power system that has the special configuration of " large power generator with small power system " in 2000, constructs power system models of fujian and fujian interconnected with other parts, does a lot of calculation and analysis and simulation, researches the security mechanism and rule of the fujian special power system interconnected with large power system. the above connection can keep security and stability and can make obvious benefits, but when the transmission power reach to excessive quantity the main power grid will increases interconnected flow - in or flow - out exchange power load. the power operation state tended to instability ; the infirmable interconnection make s the damp infirmable

    本文以2000年前後具有「大機組小電網」特殊結構的福建電力系統為背景,建立了福建電力系統及其與外部互聯的數學模型,開展大量的模擬計算分析,研究了「大帆組小電網」電力系統與大容量電力系統互聯弱的安全性的機理和規律:前述互聯可以安全運行,取得顯著效益,當傳輸功率達到一量后,主網架增加了送出或吸收互聯交換功率的負載,系統運行狀態向性水平有所下降的方向轉;聯絡弱使阻尼弱,聯絡線小幅低頻振蕩和大幅低頻振蕩易被激發,聯絡線一旦重載斷開,系統高周或低調嚴重。
  12. Then based on the cyclostationarity of ofdm symbol, a synchronization algorithm for the joint estimation of timing offset and frequency offset is proposed and discussed in detail

    並在此基礎之上提出了一個基於循環平的ofdm和頻率的聯合估計演算法。
  13. The take - off should be performed straight up from the landing area, at a constant rate of climb, with little lateral deviations

    由降落區內將直升機垂直起飛,保持的上升速度,上升的過程中允許輕微的橫向
分享友人