穩態保持時間 的英文怎麼說

中文拼音 [wěntàibǎochíshíjiān]
穩態保持時間 英文
steady state residence time
  • 穩 : 形容詞1 （穩定; 穩當） steady; stable; firm 2 （穩重） steady; staid; sedate 3 （穩妥） sure; rel...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 保 : Ⅰ動詞1 （保衛; 保護） defend; protect 2 （保持） keep; preserve; maintain in good condition 3 （...
  • 持 : 動詞1 （拿著; 握著） hold; grasp 2 （持有; 保持） keep; hold 3 （支持; 保持） support; maintain 4...
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 時間 : time; hour; 北京時間十九點整19 hours beijing time; 上課時間school hours; 時間與空間 time and spac...
  1. Further investigated and analyzed composition structure and flow data that dsa ' s formation of image is systematic at first in this paper, carried on intact summing up to the data in the system, having given out the plan of design of high speed and large capacity data channel of digital formation of image system of x - ray ; deeper discussion of control way on sdram, give solution that many pieces of sdram works togetherses of realizing heavy capacity, designing of heavy capacity deposit board realize storing at a high speed to vision data by frame on the basis of this ; through further investigations of interface of pci bus, optimize back end state machine design and urge procedure making with lower, giving intact pci interface scheme that realize high speed dma data transmission and satisfy request of video transmitting ; further investigate the figure systematic design method of programmable logic devices, due to the difficult point of drifting about of enabled signal in fifo in common use and setting up and keeping of output signal, method has been proposed of improving stability of system making use of signal utilizing the phase locking ring in fpga to offer a lot of clocks to move thus realize coordinating the data between every module of system to transmit at a high speed by making use of fifo

    本文首先對數字減影血管造影（ dsa ）成像系統的組成結構和數據流向進行了深入研究和分析，並對系統中的數據流向進行了完整的歸納和總結，給出了x線數字成像系統中的高速大容量數據通道的設計方案；在對sdram的控制方式做了深入探討后，給出了實現大容量多條sdram共同工作的解決方案，在此基礎上設計了大容量幀存板實現對圖象數據進行高速存儲；通過對pci總線介面的深入研究，優化後端狀態機設計和低層驅動程序開發，給出了完整的pci介面方案實現高速dma數據傳輸，完全可以滿足視頻傳輸要求；深入研究了基於大規模可編程器件的數字系統設計方法，針對通用fifo使能信號漂移、輸出數據難于建立和保持等設計難點，提出了利用fpga中的鎖相環提供多個時鐘相移的信號來提高系統穩定性的解決方案，從而實現利用fifo來協調系統各模塊之間的數據高速傳輸。
  2. Control chart is a kind of charts that are used to analysis and determinate whether a process is in - control or not. it use a graph to illuminate the quality variations in production process, and help to find the sources of the variations - common causes or special causes. it is a useful statistical method to keep a process in a stable situation

    控制圖是用於分析和判斷工序是否處于控制狀態所使用的帶有控制界限的圖，它通過圖形的方法，顯示生產過程隨時間變化的質量波動，並分析判斷它是由於偶然因素還是由於系統因素造成的，從而提示管理者及時採取相應的措施，消除系統因素的影響，保持工序的穩定狀態而進行的動態控制的統計方法。
  3. During the temperature fields, the results indicate that the processing parameters such as the extrusion velocity, casting temperature, perform preheating temperature, die preheating temperature and so on are important for the temperature fields besides the dwell time. they are must be in concordance each other to the deforming zone is in the quasi - solid state, and the stable semi - solid extrusion is implemented. during the deforming fields, the hyperbolic sine thermo - rigid - viscoplastic fem model is selected according to the forming feature of the process, and the variations of the stress - strain fields are studied

    在溫度場的模擬中，模擬結果表明，保壓時間是影響製件成形質量的關鍵因素之一，擠壓速度、液態金屬澆注溫度、預制體預熱溫度和模具預熱溫度等工藝參數對溫度場的影響也很大，需進行參數之間的協調，只有當變形區內部始終維持準固態時，才能實現穩定的液-固擠壓成形過程；在變形場的模擬中，根據液態浸滲擠壓的成形特徵，選用了雙曲正弦剛-粘塑性有限元計算模型，研究了變形過程中應力應變場的變化規律，研究了模角對變形和金屬流動的影響及變形力的變化過程和其影響因素。
  4. The results indicated that after cold stress the zc - 7901 cell can keep calcium homeostasis, while the cbs cell can only regulate the level of ca2 + in a restricted degree for short time, with the time of cold stress becoming longer, the equilibrium of ca2 + was disturbed

    但隨著低溫時間的延長， ca2 』水平又增加。可見草魚細胞內的ca2 』在低溫脅迫時仍能保持一種穩態平衡，而淡水白鯧在較短時間（ 24h ）內能保持鈣的穩態平衡，但隨著低溫時間的延長，這種平衡遭到破壞。
  5. The following algorithms have been proposed and tested in the thesis : 1 frequency selective fading : combine the isomorphism between the input space and the output space and propose a new approach to blind equalization of the channel. compared with conventional methods, the new approach offers lower computational complexity, better performance, and more robust against the over - determination of the system order ; 2 time selective fading : a new approach to the equalization of time selective channel based on the zero - forced equalizer is proposed which is more simple in its structure of algorithm ; 3 time - varying channel : using the instantaneous mean value changes of the output signal to extract the information of channel variations and model it using ar model, kalman filter is then employed to track channel variations, it bears faster ability in tracking the variation of tv channels ; based on the isomorphism between the inputs and the outputs and some of the approaches using in mimo system, a new algorithm of equalization of simo time - varying channel is proposed, which also share the merits of being robust against the over - determination of the system order ; model the time - varying channel using the multi - resolution decomposition wavelets, and then a blind identification method based " on the model is proposed ; at last, a new model for equalization and identification of mimo system is proposed

    主要工作在以下幾個方面： 1 、針對頻率選擇性衰落通道：結合輸入輸出空間同構關系提出一種新的頻率選擇性通道均衡方法，與傳統方法相比，該方法計算量更小，收斂速度更快，性能更優，且對系統階次的過確定表現穩健，具有實際均衡應用價值； 2 、針對時間選擇性衰落通道：提出一種基於迫零均衡的時間選擇性通道均衡方法，演算法結構簡單； 3 、針對時變色散通道：利用瞬態均值曲線提取通道時變信息，對之ar建模，利用卡爾曼濾波器跟蹤時變通道抽頭變化，可以快速跟蹤通道變化；基於輸入輸出空間之間的同構關系以及多輸入多輸出系統的處理方法，提出了新的單輸入多輸出色散時變通道均衡與識別演算法，同樣具有對通道階次過確定保持穩健的優點；結合小波多解析度分析提出一種基於小波模型的通道盲識別演算法；研究時變的多輸入多輸出系統的盲均衡與盲反卷積問題，給出一種時變系統處理模型。
  6. Two conclusions about suspending control system are given in this paper : 1. the single suspending system controlled by parameter self - turning control algorithm has better performance when the mass of single point suspending system, the resistance of electromagnet and the suspending gap are variable ; 2. the single suspending system controlled by global asymptotic stability control algorithm is global asymptotic stability and can restrain the stochastic noise

    通過對採用上述控制演算法的懸浮系統的理論分析和模擬研究，主要得到了以下幾方面結論: 1 .當系統懸浮質量、電磁鐵電阻和額定間隙參數變化時，設計的參數自校正控制演算法可使系統的動態性能指標保持在設定的指標; 2 .設計的全局穩定控制演算法，能夠保證二級結構單點懸浮系統的全局漸近穩定，且對隨機噪聲干擾有一定的抑制作用。
分享友人
分享到 Line

分享到臉書