穩錘 的英文怎麼說

中文拼音 [wěnchuí]
穩錘 英文
equipoise
  • : 形容詞1 (穩定; 穩當) steady; stable; firm 2 (穩重) steady; staid; sedate 3 (穩妥) sure; rel...
  • : Ⅰ名詞1 (一種古代兵器) a metal ball with a handle or chain used as weapon; mace2 (秤坨; 像錘的...
  1. Landslide is a geological hazard with serious losses. it is very important to research the controling methods. slide - resistant pile, which has many advantages such as high adaptability, little interference to landslide and geological environment, short construction time, high silde resistance, is a main method to control landslide. pneumatic down - the - hole hammer is a drilling method with many advantages. its features, such as wide application range, high hole quality, no circulating medium, low operation regulations, and drilling big diameter rock hole, fit to construct slide - resistant pile. according to the requirement of silde - resistant pile construction, this paper analyses feasibility that pneumatic dth hammer drilling applies to construct slide - resistant pile on the basis of introducing the features of pneumatic dth hammer. then an applied example is given

    滑坡是一種危害極大的地質災害,它的整治方法研究具有重要意義.抗滑樁是一種適應性強、對滑坡定性和地質環境干擾小、工期短、抗滑能力強的滑坡整治方法.風動潛孔鉆進是一種具有許多優點的鉆進方法,它的許多特點,如成孔質量高、應用范圍廣、無液體循環介質、鉆進規程參數小、可實現大直徑基巖鉆孔等都適合於抗滑樁施工.文章在介紹風動潛孔鉆進特點的基礎上,根據抗滑樁施工要求,分析了風動潛孔用於抗滑樁施工的可行性,並舉出了其應用實例
  2. Forging hammer is an important device, which is used to forge roughcast in machine shops. when forging hammer works, violent vibration produces, so the precise instruments and equipment around ca n ' t run normally, the stability and longevity of the workshop structure may lower, furthermore, the health of people hurts. the damping to forging hammer foundation is all through the ages a hot question for discussion

    是機械工廠中一種對毛坯進行鍛造加工的重要設備,但鍛工作時產生的極大振動,不僅嚴重影響周圍精密儀器、設備正常運行,降低廠房建築結構的定性及其使用壽命,而且是一種危害人體健康的工業公害,因而鍛隔振歷來是一個熱門研究課題。
  3. The optimum design of the beat back - impact crusher is proposed, which aims at the highest efficiency of the machine work. the optimum designed mathematics model of the main structural dimension of the crusher ( m, xc, s, w 2 > ir ) is built with restraining conditions such as force condition, energy condition, hammer steady condition, no moving interference, strength of spin axle and bearing condition, upper limit and lower limit of the design variant condition etc. finally, an example is give to illustrate the efficiently of the method proposed

    在綜合考慮影響破碎機效率的各因素的情況下,提出了滿足以力,能量,定性,幾何條件,不發生運動干涉,轉子軸和滾動軸承的強度等約束條件,建立了包含破碎機關鍵參數(頭質量m ,軸心o到銷軸頭接觸距離r ' ,四川大學碩士學位論文頭質心到銷軸與頭接觸點的距離拙,頭與巖石碰撞到銷軸與頭接觸點的距離s ,轉子的速度。
  4. It is means that gahc would be harmless to the stability of other generators, when it is used to reduce the ste of local generator. the simulating tests of gahc used on steam turbine and hydro turbine had been done in single machine system and multi - machine system. the results of simulating tests show that the generator stability could be improved by gahc, it is harmless to the stability of other generators in multi - machine system

    在單機系統和三機無窮大系統中對汽輪發電機和水輪發電機的gahc控制進行了模擬實驗,模擬實驗結果驗證了: gahc提高了汽輪發電機和水輪發電機抵抗三相短路故障擾動沖擊的能力; gahc在多機系統中對其它發電機的定性不會產生危害作用;水輪機的gahc克服了水效應對定性的危害作用。
  5. Based on physical experiments, establishing mathematical model, carrying on theoretical calculations, and contrasting experimental results with theoretical ones, it turned out that under the same initiate flow rate, the quicker the closing of the ball valve, the longer the stable time when the liquid gets to vaporizing pressure, and the bigger the water hammer in water interception collision ; under the same closing velocities of the ball valve, the larger the initiate flow rate, the longer the stable time when the liquid gets to vaporizing preesure, and the bigger the water hammer in water interception collision

    在試驗研究的基礎上,建立了含氣水數學模型,進行數值計算,並與試驗結果進行了比較,結果表明,在管道初始流量相同的情況下,球閥關閉速度越快,液體達到汽化壓力凡時定的時間越長,彌合水壓力也越大;在球閥關閉速度相同的情況下,管道初始流量越大,液體達到汽化壓力凡時定的時間越長,彌合水壓力也越大。
  6. The outputs of tests on the thin plate under different inputs have been investigated for testifying the system. different solutions have been compared according to the frequency - spectrum characters and structure modal parameters. it is indicated that the solutions in this paper are consistent with the solution of the fea methods

    以薄鋼板為實例,探討了不同激勵條件下,包括正弦態激勵、正弦慢掃描、單次擊和隨機擊激勵,薄鋼板振動系統的響應情況,以頻譜特性和模態參數為參考,將各種方法的求解結果作了比較,結果表明:本系統得出的結果與有限元解具有一致性。
  7. The mousetrap must contain a solid base to attach the four other parts to, a hammer that clamps down on the mouse, a spring which gives the hammer the necessary power, a holding bar which holds the now energized hammer in position, and a catch to which the holding bar is secured, holding the hammer in coiled tension

    一個捕鼠器必須有一個堅固的底部,用來安裝其餘四個零件,包括一個擊打老鼠的子,一個給子足夠力度的彈簧,一支用來承托上了彈簧的子的竿,和一個用來定這支竿的把手,使得定在彈簧的拉力下。
分享友人