空氣流速 的英文怎麼說

中文拼音 [kōngqìliúsù]
空氣流速 英文
air rate
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 空氣 : 1 （大氣） air; atmosphere 2 （氣氛） atmosphere 3 （氣閘） air brake4 pneum ; pneumo ; pneumat ;...
  • 流速 : [機械工程] velocity of flow; strength; [水文] current velocity; current speed; flow rate流速管 pi...
  1. Airflow volume, velocity, and uniformity tests

    空氣流量、流速和均勻性測試。
  2. The author takes consider of the aerial condensability. according to newton ’ s second law and gas equation, it is elicited to the gas pressure distributives in the drill pipe

    通過壓力分布圖可知，截面突變導致壓力發生突變，空氣流速在該處最低，因此，最小風量採用截面突變處風速計算。
  3. Ventilation for buildings - instrumentation requirements for air velocity measurements in ventilated spaces

    建築物的通風.通風空間的空氣流速測量儀器的要求
  4. And experimental study on the heat transfer performance and pressure drop characteristic of the process of bubbling evaporative cooling are carried. as there are so little attention and studies on the process bubbling evaporative cooling about heat transfer in the world at present, this paper mainly deals with the effects of the different bare tower velocity, weir height, heat flux density and plate perforation geometries on the heat transfer coefficient and the pressure drop of the process of air flowing

    由於目前國內外對鼓泡蒸發冷卻過程在換熱方面的關注和研究較少，本文對不同空塔速度、不同堰高、不同熱流密度、多孔板的不同幾何尺寸對換熱系數及空氣流動過程阻力的影響進行了實驗研究及理論分析，總結了本實驗條件下換熱及阻力的實驗關聯式。
  5. The paper analyses the particle radial separating speed in inertia field and the dropping speed in the gravity field, determines the relations among the separating critical diameter, the rotate speed of screw, airflow speed and the radial size of separating interface, establishes and work out the separating diameter which value the separating effect of the new equipment

    根據物料的空氣阻力與離心分離理論分析了離心力場中粒子徑向分離速度及重力場中的粒子沉降速度，確定分離臨界粒徑與螺旋轉速、氣流速度及分離界面徑向尺寸等之間的關系建立了並求出了衡量此種新機型氣固二相流分離效果的衡量指標? ?分離粒徑。
  6. Coarse material is conveyed by a stream of air to variable speed whizzer-separator.

    粗料由空氣流輸送到變速風力選粉機那裡。
  7. The air flow is slowed down by the friction with adjacent objects

    空氣流動的速度會因周圍物件摩擦而減慢。
  8. The wall sticking of dry powder is concerned to geometric figure of cyclone chamber, roughness of wall, velocity of air and static charge

    乾粉表面粘附與塔壁的幾何形狀、粗糙程度、空氣流速、靜電力等有關。
  9. Through having done field surveys in the campus of chongqing university, this paper tested classroom indoor and outdoor climate parameters in june, july and september of 2005, it used questionnaire to acquire subjects ’ thermal sense, draft sense and humidity sense in classroom each month, and programmed composition to compute predicted mean vote and compared pmv with the field testing results of mean thermal sensation vote. it is discovered that pmv is overvalued the college student ’ thermal sensation in chongqing. it finds that people in chongqing adapt to the typical summer hot and winter cold sweltering weather

    對重慶地區高校教室的現場調查，測試了重慶大學2005年六月、七月和九月教室室內外熱環境參數，通過採用問卷主要掌握了受測對象教室里的冷熱感、氣流感和潮濕感，通過編製程序求得預測平均熱感覺評價pmv的值，比較pmv和問卷調查得到的平均熱感覺mtsv ，發現pmv預測值高估了重慶地區高校學生的熱感覺，這里的人群對重慶這種夏熱冬冷地區比較典型的悶熱氣候具有一定的熱適應性，對現場問卷調查的結果進行分析，得出了室內空氣溫度、氣流速度、相對濕度與人體主觀感覺之間的回歸曲線，發現重慶地區高校學生熱中性時的空氣溫度為25 . 5 ， fanger根據歐美人群調查得到的公式計算出的預測熱感覺為中性時的空氣溫度為25 . 0 ，兩者相差0 . 5 。
  10. In order to discuss the quantifiable relation of air speed with human comfort and physiology stress, 20 subjects each in winter and summer of 2005 were exposed different air speed, and they had done some physiological testing and questionnaire

    室內的熱舒適性問卷調查得知，夏季空氣流速的改變使得人體所感知的熱感覺、氣流感、濕度感和熱環境滿意度都有很大的變化，說明在夏季風速的提高可
  11. The distribution of the gas - flow speed is measured at a position 1cm away from the outlet ( the end with larger air - gap ). it is illustrated that the gas - flow speed keeps increasing from the out surface of the inner sleeve to the inner surface of the outer sleeve, and then it decreases gradually

    測量了楔形氣隙流體出口（大間隙埠）外1厘米處空氣流速大小的分佈，發現空氣流速自轉子（內筒）壁面處開始逐步增大，至定子（外筒）壁面處達到最大值，隨后開始減小。
  12. According to the features of air - conditioner in truck, four main factors have been confirmed in the text which will affect body " s heat comfort : temperature of blowing the face, temperature of blowing the feet, velocity of air flow, average temperature of radiation. the index of pmv - ppd has also been selected as the method of evaluation for the heat comfort

    本文根據載貨汽車空調的特點，確定了影響人體熱舒適性的四個主要因素，即吹臉溫度、吹腳溫度、空氣流速、平均輻射溫度，並選定pmv - ppd指標作為熱舒適性的評價方法。
  13. The relation between thermal environment parameters for instance air temperature, relative humidity, air velocity and thermal sensation or thermal comfort has been studied in all environments. the differences of thermal sensation or thermal comfort in this environments and pmv - ppd are researched too

    並分析了在實際空調環境下、自然通風環境下和實驗空調環境下空氣溫度、濕度、空氣流速、環境輻射溫度等參數對人體熱感覺和人體熱舒適的影響;並將人體熱感覺和人體熱舒適與pmv - ppd指標進行了比較分析。
  14. The results show that : the lose of pressure is small when air velocity and the longth of honeycomb potter heat storage bed are varied ; but the switch time of air and the bulk of storage bed play important roles as regard its dynamic thermal performance

    結果表明：蜂窩型陶瓷蓄熱體換熱器的壓力損失隨著空氣流速以及蓄熱體長度的不同而變化，但總體上說，其壓力損失並不大；四通換向閥的換向周期和蜂窩陶瓷蓄熱體換熱器的體積等是影響其溫度效率和熱回收率等熱性能的重要因素。
  15. When in experiment, the air was heated by the film heater installed on the above and below surface of channel, adopting various air velocity of flow, test import ' s and export ' s temperature, wall temperature, fluid flux and the drop of pressure, and the other parameter. adopting nu and nu0 to analyze the baffle ' s situation of heat transfer and fluid flow, which baffle was holed various diameters

    實驗時，通過矩形通道上下壁面敷設的電加熱膜加熱通道空氣，改變空氣流速，測試不同工況時的進出口溫度、壁面溫度、流體流量和壓力損失等參數，並採用無量綱努謝爾特準則數nu 、 nu _ 0等分析了設置不同開孔折流板的換熱與流動情況。
  16. Under the function of big pressure and dynamic load, the grains may be moved which may cause the soil body distortion. at present, the relatively ripe methods of drill in gravel layer are mostly double - wall drill pipe reverse circulation drilling, auger stem breast wall drilling and down - the - hole hammer follow down drilling

    論文根據jsl ? 30型礫石鉆機潛孔錘同心跟管鉆具結構，採用程序計算得到了鉆桿內各深度處壓力分佈、鉆頭壓力降、環形空間壓力分佈及空氣流速分佈。
  17. It tell us : the abrasive capability of fly ash ; the similar calculation of ash erosion ; the calculation of ash erosion in the tube in turn and tube out of turn ; the reason of tube abrasion for gas flue ; the influence of air parameter for fly ash erosion ; the influence of changing temperature ; the influence of the flue gas composition, etc. next, it advances the solving measure ; reduce the flue gas velocity ; reduce the concentration of fly ash ; responsible construction : replace smooth tube with spiral tube ; use the new material of abrasion ; fuel desulfurization ; reduce so3 of flue gas ; raise flue gas temperature, making it up the dew point ; use the abrasion - resistance material to resist abrasion

    討論了飛灰磨損性能、管壁受飛灰沖蝕的近似計算、灰粒對順列管和錯列管的磨損計算、煙氣走廊引起對流管束的磨損機理、空氣動力參數對飛灰沖蝕的影響以及受熱面壁溫變化及煙氣成份對飛灰磨損的影響等問題。接著提出了解決的措施：降低平均煙氣流速；降低飛灰濃度；使用鰭片管、螺旋翅片管代替光管；選擇合適的結構及排列方式，減少煙氣中so3的含量；提高受熱面壁溫使之大於煙氣的露點溫度；採用抗腐蝕材料作受熱面等防腐蝕的措施。
  18. The performance of supersonic inlet determines the pressure and the air flux in combustor, then affect the work of ramjet

    超聲速進氣道的性能優劣決定了補燃室流場內的壓強和空氣流量，進而影響到沖壓發動機的工作性能。
  19. The paper introduces the basic principle of the inducement type ventilation in the province of aerodynamics : disturbed characteristic of high - speed cascade can effectively leads quiescent air around it and drive air flow, compares and analyzes the traditional ventilation type and inducement ventilation type applied in underground garage in the facets of airflow organization, practicability and economy, coming to the conclusion that the inducement type ventilation is applied to the underground garage in the facets of economy, practicality and high efficiency

    摘要介紹了誘導式通風利用空氣動力學中高速噴流的擾動特性，能夠有效地誘導周圍靜止的空氣，帶動空氣流通的基本工作原理，就傳統通風方式和誘導通風方式，在地下車庫應用中的氣流組織、實用性、經濟性等幾個方面做了比較，分析認為，誘導式通風因其經濟、適用、高效的特性適合在地下車庫應用。
  20. Ventilation for buildings - calculation methods for the determination of air flow rates in dwellings

    建築物通風.測定房屋中空氣流速的計算方法
分享友人
分享到 Line

分享到臉書