空氣混合室 的英文怎麼說

中文拼音 [kōngqìhúngěshì]
空氣混合室 英文
aerating chamber
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 混 : 混形容詞1. （渾濁） muddy; turbid2. （糊塗; 不明事理） foolish; stupid
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 空氣 : 1 （大氣） air; atmosphere 2 （氣氛） atmosphere 3 （氣閘） air brake4 pneum ; pneumo ; pneumat ;...
  • 混合 : （攙雜在一起） mix; blend; mingle; admix; mixture; mix up; interfusion; commixture; blending; cre...
  1. While working, the air with dust enters into the sedimentation chamber via wind entrance, dust with large size granule will fall because of sudden expand of the aeriform cubage, then the air will pass the water area of arc boards of the two sides to stir the water. then air with dust will be mixed with water forming water curtain at the exit, fine powder will be collected, purified air will be discharged by blower fans via breakwater and wind exit

    工作時含塵空氣從進風口進入沉降室由於氣體的體積驟然膨脹，大顆粒粉塵沉集下來，然後空氣經過兩側弧形板間的水域並將水攪動含塵空氣與水充分混合在出口處形成水幕，較細的粉塵捕集下來，凈化后的空氣經擋水板和出風口由風機排走。
  2. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  3. Washed air purifier working principle : siphon and using centrifugal principle will be mixed in water pure plant essential oils inhaled through its siphon principle the motor base coaxial centrifugal turbines in the bottom of straw through exchanges cover a very high - speed rotary motor, reuse centrifugal principle, will be mixed in water pure plant essential oil spray bottle in the form within a water film bile, the dust in the air and inhaled bacteria in water purification at the same time after the indoor air insufflation, quickly and efficiently by removing indoor toxin biological, dust, cigarette smoke, the smell, virus

    水洗空氣清新機工作原理：是利用虹吸以及離心原理；將混合於水的純植物精油通過虹吸原理吸入其電機底座的同軸離心渦輪下部的吸管中，通過交流罩極電機高速旋轉，再利用離心原理，將混合於水的純植物精油噴在瓶膽內形成一層水膜，將空氣中的灰塵以及細菌吸入水中，同時將經過凈化的空氣吹入室內，快速有效地去除室內的有毒素生物、灰塵、煙味、臭味、病毒等。
  4. Air mixing chamber

    空氣混合室
  5. Compared with the traditional mixing ventilation, displacement ventilation, a new concept in air - conditioning system, has showed several remarkable advantages : it improves indoor air quality, consumes less energy, and has better economical efficiency

    置換通風系統作為一種新型的通風方式，與傳統的混合通風相比，在許多場合具有明顯的優勢：例如，能提供更好的室內空氣品質、節約能耗以及經濟效益顯著等等。
  6. Displacement ventilation and cooled ceiling system as a measure has been widely used in public buildings and office buildings because it not only can provide better indoor air quality, but also is an energy saving ventilation system

    置換通風與冷卻頂板混合系統作為一種新的通風方式，被越來越廣泛的應用於公共建築和民用建築，因為它不僅能提供更好的室內空氣品質，同時也是一種節能的通風方式。
  7. Planar laser induced fluorescence ( plif ) was used to study the spray / wall impinging in constant volume vessel. the experimental result show that when fuel spray impinging on the plane wall, wall jet was formed while fuel impinging on a plane wall with a bump, when the wall jet meet the bump, a secondary jet can be formed. some parameters affecting the secondary spray were studied, including bump height, the secondary impinging distance, impinging distance and injector parameters

    對傳統燃燒室和bump燃燒室內燃油空氣混合過程進行了對比研究，發現燃油撞壁以後在傳統燃燒室壁面形成壁面射流，這一層燃油濃度很高，很難與空氣混合，而在bump燃燒室內，壁面射流遇到bump后，會在空間形成二次射流，二次射流進一步能快速與空氣充分混合。
  8. Planar laser induced fluorescence ( plif ) and multi - dimensional cfd software was used to study the fuel - air mixing process in traditional combustion chamber and bump combustion chamber, the experimental and simulated result agree well in room condition. the fuel - air mixing process in high pressure and temperature in traditional and bump combustion chamber were compared. the result show that fuel and air can mix more quickly in bump combustion chamber than in traditional combustion chamber, fuel - air mixture in bump combustion chamber is more homogenous than in traditional chamber

    進一步對高溫高壓下傳統燃燒室和bump燃燒室內燃油空氣混合好壞進行了對比研究，提出了衡量燃油與空氣混合好壞的三個指標，發現bump燃燒室內燃油能在更大的體積內與空氣混合， bump燃燒室內燃油比傳統燃燒室內燃油分佈相對更均勻， bump燃燒室內燃油濃度耗散率為傳統燃燒室內燃油耗散率2 . 8倍，能更快與空氣混合。
  9. The last or main injection pulse is set around tdc. when the diesel spray impinging on the combustion wall, the bump around the combustion chamber wall can strip off the wall jet and form a secondary spray in combustion chamber, so the fuel and air can mix well and homogenous

    在主噴射時刻，利用燃燒室壁面的bump迅速剝離壁面射流，在空間形成二次射流，二次射流進入燃燒室空間后，再一次與空氣混合，形成相對均勻的稀混合氣。
  10. A two - dimensional double diffusive laminar mixed convection, displacement ventilation, is fully investigated by the means of heat and contaminant transport structures to see the effects of the heat and pollutant sources and the external mechanical ventilation

    作者以二維層流雙擴散混合對流模型? ?置換通風? ?進行了數值模擬與分析，並利用上述對流可視化技術來觀察熱源、污染源、外部機械通風三個因素對室內空氣環境的影響。
  11. B ) applying the multi - fluid model to study premixed combustion in the combustor with the fluid being separated into 11 components, the air / fuel ratio being taken as the dominating attribute

    採用了多流體模型來對燃燒室中的預混湍流燃燒進行數值模擬，根據燃料空氣混合比把燃燒室內的混合氣體分成11種流體； c
  12. A few layers of temperature measuring nets was fixed in the furnace in the test - bed. the distribution of the concentration of diffenent temperature air was gotten through measuring the distribution of the temperature in the furnace. finally, the mixture situation in reburning area and burnout area were gotten totally

    即主氣流和燃盡風採用室溫氣流，再燃天然氣採用高溫空氣模擬，在爐內布置多層測溫網路，通過測量爐內溫度場的方法獲得爐內再燃風、燃盡風及主氣流的混合濃度場，從而定量反映出爐內再燃區及燃盡區的混合情況。
分享友人
分享到 Line

分享到臉書