窄帶接收機 的英文怎麼說

中文拼音 [zhǎidàijiēshōu]
窄帶接收機 英文
narrow band receiver
  • : 形容詞1. (橫的距離小) narrow 2. (心胸不開朗; 氣量小) petty; narrow 3. (不寬裕) hard up; badly off; short of
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • : Ⅰ動詞1 (把攤開的或分散的事物聚集、合攏) put away; take in 2 (收取) collect 3 (收割) harvest...
  • : machineengine
  • 接收機 : receiver; radio set; receiving set; receiving machine接收機保護設備 reprod; 接收機保護裝置 receiver protector
  • 接收 : 1 (收受) receive; reception; accept; [電學] receipt; receiving 2 (接管) take over; expropriat...
  1. The signal format of gps is analyzed, the principle models and mathematical models are established, the ber performance is analyzed in a channel interfered with wide - bandwidth awgn, narrow - bandwidth awgn, transmitted signal, single - tone signal respectively. based on the results above interference methods are discussed and simulated. then the performance of code acquisition and code trace of a digital gps receiver are discussed. the modem of linkl 1 and link4a are modeled and their ber performances are analyzed and simulated in channel s interfered with awgn, single - tone signal and multi - tone signal respectively

    建立了jtids的發終端的數學模型,分析它在噪聲干擾、相關干擾、互相關干擾下的誤碼性能,提出較佳的干擾方法和干擾碼型,並進行模擬模擬;分析了gps的信號格式,建立了gps的原理框圖模型、信號數學模型,並對其在寬噪聲干擾、噪聲干擾、轉發干擾、單頻干擾等情形下的誤碼性能進行了分析比較,提出相對較佳的干擾方法,並做了計算模擬,針對一數字式gps中擴頻碼捕獲與跟蹤環的特性進行分析;建立了link11和link4a數據鏈調制解調數學模型,對它們在噪聲干擾、單音干擾、多音干擾等下的誤碼性能進行分析,最後對干擾情況進行了模擬模擬。
  2. By making full use of favourable narrow - band tracing filter character of pll and by combining the merits of dds such as super fine frequency resolution 、 high frequency accuracy 、 very fast frequency hoping with it, the pll / pll + dds frequency synthesizer presents wide band high quality source and super small frequency hoping step. while the electronically tuned filter abates the image interference and notably improves the selectivity. the theorem of frequency synthesizer and center - frequency - fixed filter is simply but adequately introduced first in this paper

    課題中所採用的pll或dds pll鎖相頻率合成方法充分發揮鎖相環良好的跟蹤濾波特性,並結合dds的高頻率解析度、高頻率精確度和高速頻率捷變等優點,分別實現了系統所要求的高質量寬本振源和小步長頻率捷變;採用電調諧選頻技術,則大大改善了的選擇性和抗干擾能力。
  3. The receiver works on active mode and passive mode in different time. in active mode, the receiver is narrow - band and high sensitive, and if phase - lock technology is used to stabilize receiving frequency. and in passive mode, the receiver is an all - power millimeter wave radiometer with periodic calibration to improve measure precision

    採用分時工作體制,在主動工作方式時為的高靈敏度毫米波中採用中頻鎖相技術,簡化了毫米波鎖相來的困難;在被動工作方式時為全功率型的毫米波輻射計,這種輻射計在每次測量后都採用兩個標準源對輻射計定標,實現周期定標,消除因系統增益波動和有效本噪聲波動來的測量誤差,提高測量測量精度。
  4. According to the ideology of software radio theory, the realization of intermediate frequency ( if ) digitalized direct sequence spread spectrum ( dsss ) receiver is one of the focuses in dsss communications study. it is of great value to deploy narrowband interference ( nbi ) suppression techniques in if digitalized dsss receiver for commercial and military applications

    根據中頻數字化這一軟體無線電思想實現擴頻是目前擴頻通信研究的熱點,在中頻數字化擴頻體系結構內研究干擾抑制技術具有重要的商業和軍事應用價值。
  5. The above waveforms discussed are to synthesize the wb or uwb with narrow band pulses. assuming the transmitting uwb linear frequency modulation ( chirp ), dechirp processing is introduced, and the method involved to obtain high resolution by reducing the if bandwidth is presented. furthermore, dechirp processing used to sar imaging is discussed, and the processing steps are described

    < wp = 4 >以上研究的兩種信號形式都是通過子脈沖串相參合成的方法來獲得超寬回波信號,本文還探討了去斜率( dechirp或stretch )方法,分析了去斜率降低中頻寬、 fft獲得目標一維距離像的原理,並探討了線性調頻去斜率合成孔徑雷達成像,給出了具體實現步驟。
  6. For the receiver which uses the intermediate frequency real signal output manner, a good frequency plan should guarantee the transition band of the “ spectrum blocks ” which produced by the sampling as wide as possible, so as to ease the burden of the base - band signal processing to the minimum level. it has not been particularly analyzed in the former references about receiver design, and the main

    在以往有關設計的文獻中很少對此進行過詳細的分析,其主要原因是大多數系統的信號寬較(通常在2 、 3mhz以下) , fif和fs受到的限制較少,可以很輕易的保證采樣之後各「譜塊」有足夠的過渡寬。
分享友人