立即響應式 的英文怎麼說

中文拼音 [lìjíxiǎngyīngshì]
立即響應式 英文
on-demand
  • 立 : 動1 （站） stand; remain in an erect position 2 （使豎立; 使物件的上端向上） erect; stand; set up...
  • 即 : Ⅰ動詞1 （靠近; 接觸） approach; reach; be near 2 （到; 開始從事） assume; undertake 3 （就著） pr...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 立即 : immediately; at once; promptly; off hand
  1. According to the special shape and operate requirements of the torpedo, the structure and moulding process of the torpedo shell are established, in which the body and overlay block with grooves are moulded by fiber winding, and close moulding respectively with the adhesive by limited stop compression. in the light of the selection of raw material system, composite system with outstanding performance are defined, based on which the mechanical properties are tested., with the overall consideration of structural characters and design demands, the main factors which may have effects on the strength and stability ( including stiffness section dimension, stiffeners space, skin thickness and skin lay angle ) is optimized one by one for the structure design parameters on the base of the fem model of skin, stiffness and layover block by fem. as a result, the prototype with 1 : 1 proportion and its structure and lay optimization design are completed. the moulding technology for polyurethane foam moulding the stiffened shell is obtai ned in terms of the design, manufacture moulding, experimental mould and tooling

    依據在研產品特殊的外型結構和使用要求，確定了該型號水雷復合材料殼體的具體結構形式和復合成型工藝路線，即由纖維纏繞工藝成型主體異形件，閉模成型帶通槽外貼塊，用限位加壓工裝實現粘接的工藝路線；通過對原材料體系的篩選，確定了綜合性能較好的復合材料體系，以此為基礎進行了力學性能測試；運用有限元方法，建立了蒙皮、筋條和外貼塊的分析模型，綜合考慮結構特點和設計要求，對影響結構強度與穩定性的主要因素（包括筋截面尺寸、筋間距、蒙皮厚度、蒙皮鋪層角度）分別進行了結構設計參數的優選，最終完成了復合材料異形耐外壓殼體1 : 1樣件和縮比實驗件結構及鋪層優化設計；完成了聚氨酯泡沫胎成型內置加筋殼體的成型工藝技術研究；對縮比件進行外壓性能測試，並給出了應力、應變測試結果。
  2. Section iii proposes a possible organization of a reactive power market, a regional reactive power market established according to the distribution of the load and the reactive supply. the regional reactive power market is composed of a reactive energy market based on marginal pricing and a reactive capacity market based on a reactive regulating capacity payment. the cases in section iv, based on the market organization proposals and the reactive bid structure previously presented, performed on a five - bus system and the ieee 14 bus system, are used to analysis the effects of active bid, voltage control and power factor on the reactive marginal price

    本文首先回顧了電力市場發展的歷史和現狀；然後對市場中的定價方法和無功輔助服務的內容及特點進行了總結，並介紹了一些國家的無功輔助服務市場模式和交易方法；接著立足我國國情，提出了單邊開放電力市場下的無功市場框架：即根據負荷和無功源的分佈特點建立區域無功市場，各區域無功市場又由相應的無功電量市場和無功容量市場組成；並提出了該無功市場模式下的機組報價模型和基於報價的以系統總購電費用最小為目標的無功電價計算方法；最後用一個5節點系統和ieee14節點系統進行了實例分析，初步研究了發電機有功報價、系統電壓控制以及負荷功率因數對無功電價的影響，得出了一些有借鑒意義的結論。
  3. This article describes a way of special ultrasonic system which monitors thermal stress in seamless welded rails. this monitoring system is a non destructive testing system, which adopts avr mcu and high - precise time chip processing as the core of it, and adopts the critically refracted longitudinal wave as the object of measuring. my studying focuses on the theory of the monitoring system, which will be listed in this arctile : according to the snell theory, the theory of motivating of critically refracted longitudinal wave is described in details, and the finite element software is used to emulate the propagating course. the formulas of calculating the pts of swr are taken from the acoustoelasticity theory, and the calculating the parameters is introduced. according to assemble materials, three kinds of ways of monitoring the pts of swr using critically refracted longitudinal wave are described, which are measuring the sound - time in changeless distance, ultrasonic critical - angle refractomery and frequency spectrum, the first way of ways is used in this experiment system. the factors, which effect the monitoring system, are assaid in some degree based

    本文的研究工作重點在無縫焊接鋼軌溫度應力測量系統的理論模塊，包括根據snell原理，研究極限折射縱波的激發機理，並使用有限元軟體ansys進行模擬;根據聲彈性理論以及公式推導出計算無縫焊接鋼軌中的溫度應力的公式，並對其中參數的求解方法進行介紹;根據收集的資料，介紹了三種使用極限折射縱波測量無縫焊接鋼軌溫度應力的方法，即固定距離測量聲時法、臨界角折射法和頻譜分析法，本實驗系統使用的是第一種;根據實驗經驗以及相關資料，分析了影響極限折射縱波測量溫度應力的幾個因素，並提出了相應的解決方法;根據實驗系統的需要，獨立設計並加工出相關配套的實驗設備，包括實驗鋼塊、有機玻璃楔塊、固定件、載荷外框裝置等。
  4. In chapter 4, two basic models of market exchange are enumerated. one is the power pool model and the other is the bilateral exchange model. the ttc and atc calculation models in the influence of bilateral exchange are established

    第四章歸納總結電力市場交易模式的兩個基本類型即pool模式和雙邊交易模式；建立雙邊交易影響下ttc和atc計算模型，設計相應演算法和程序，以上海電網為例進行模擬。
  5. Its effective implementation calls for the establishment of an equal, independent, highly - efficient arbitral procedure in our state, the publicizing of our arbitral legislation and procedure, the opening of legal service market and the adoption of wto dispute - settling mechanism. after we enter wto and wto agreements come into force, our arbiration system will be greatly influenced by economic globalization whith requires the reformation of our arbitration system to eradicate the remining influence of planned econoncy to suit the market economy model, the opening of our arbitral practice by employing foreign arbitral rules directly and providing references for other states, and the rapid development of our arbitration system in every aspects ( hardware or software ), amo ng which the lining up with the internation - al arbitration is the most inportant aspect caused by entering wto

    前一方面論述了wto協議的有效實施要求我國建立獨立、公平、高效的仲裁製度；要求我國公開仲裁立法與仲裁程序；要求我國適用wto的爭端解決機制；要求我國開放法律服務市場等內容，后一方面重點論述了wto協議實施后，即我國加入wto后，經濟全球化帶給我國仲裁製度的影響，要求我國仲裁製度進行改革，刪除計劃經濟體制的殘余影響，以適應市場經濟模式；要求我國仲裁實行開放，包括直接引用外國仲裁規則進行仲裁，也包括我國仲裁規則被外國引用；要求我國仲裁事業加快發展，在硬體與軟體方面不斷改進，其中與國際接軌是加入wto后完善我國仲裁製度的必然要求。
  6. This enables seamless integration of sibus into any existing websphere mq functionality, keeping the impact of its introduction to existing legacy applications to a minimum

    因而可以將sibus無縫整合到現有的websphere mq功能中，以便它的引入可以立即影響現有的舊應用程式。
  7. Based on the summary of previous evaluation methods, this paper points out the shortcomings of them, then draw the theory of artificial neural network into risk evaluation, through an example of some kind of investment project and the training and examination of a group investigation sample, it sets up the artificial neural network model. at last, this model is applied to the real case of an engineering project to evaluate its risk level and satisfactory result is made ; in the fifth chapter of this paper, the main risk factors that affect the economic appraisal of the engineering investment project are described through the form of relationship chart. then it is proved by way of deduction of formula that the risky influence that is brought by inflation must be considered in the engineering investment project

    本文在對以往評價方法進行歸納總結的基礎上，指出其中存在的不足之處，將人工神經網路理論引入到風險評價中，以某一類投資項目為例，通過對一組調查樣本的訓練和檢測，建立了工程投資項目風險評價的人工神經網路模型，並通過實例對模型進行了驗證，取得了滿意結果；在本文第五部分，對影響工程投資項目經濟評價的主要風險因素以關系圖的形式進行了描述，然後通過公式推導證明了在工程投資項目中應該考慮通貨膨脹帶來的風險影響，接著在分析以往建立的經濟評價凈現金流量表達式存在不足的基礎上提出了另外一種方式的表達式，即凈現值解析模型，對該模型的求解進行了詳細的說明，並分析了如何恰當的選擇各風險變量的概率分佈，最後在考慮投資者風險偏好的前提下，提出了工程投資項目新的風險度量模型。
  8. The project to the construction phase quality control for research themes in a more systematic research 。 this defines the basic concepts of the project quality control and analysis of its main features, expounded china ' s project quality control model history and analysis of the traditional model of quality control deficiencies 。 in the use of statistical methods for more analysis and appraisal of the basis of this proposed backward quality control model is the low quality of project one of the major reasons why, in our current management system, project quality control model should be to implement the " prevention " and " people - oriented " reform direction perspective ; 5 affecting the quality of the project, namely, human factors, material factors, mechanical factors, factors and methods for the comparative analysis of environmental factors that control the quality of the construction phase, these five factors in essence controls the process ; establish quality assurance system. 。 in a detailed analysis of quality control in the construction phase of a project to the specific implementation of hainan, on the basis of quality control should be put forward " people - oriented " to the quality of work and ensure the quality of processes, promote project quality 。

    本文界定了工程項目質量控制的基本概念並分析了其主要特點，闡述了我國工程項目質量控制模式的歷史沿革，分析了傳統質量控制模式存在的弊端。運用統計方法進行了分析論證的基礎上，本文提出了落後的質量控制模式是工程項目質量低下的重要原因之一，在我國現行管理體制下，工程項目質量控制模式應以實施「預防為主」 、 「以人為本」為改革方向的觀點;對影響工程質量的五個方面，即人的因素、材料因素、機械因素、方法因素和環境因素進行了比較分析，指出施工階段質量控制，實質上就是對這五個方面的因素實施控制的過程;建立質量保證體系。在詳細分析了施工階段質量控制在海南某工程的具體實施情況的基礎上，針對性地提出了「質量控制應『以人為本』 ，以人的工作質量保工序質量，促工程質量」的觀點。
分享友人
分享到 Line

分享到臉書