端面齒廓 的英文怎麼說
中文拼音 [duānmiànchǐkuò]
端面齒廓
英文
tra verse tooth profile-
Leaves papery, oval in outline, 6 - 7cm long and 8 - 11 cm wide, base rounded or subtruncate, trilobed or sometimes 5 - lobed ; lobes triangular - ovate, rarely ovate - oblong, apex acute or acuminate, margin serrulate, with appressed acute teeth, sometimes entire near base, glabrous or with tufted hairs at vein axils abaxially ; petiole 2 - 3 cm long, glabrous
葉紙質,輪廓闊卵形,長6 - 7厘米,寬8 - 11厘米,基部圓或近截平, 3裂或有時5裂,裂片三角狀卵形,有時卵狀長圓形,頂端漸尖,邊緣有疏而銳利地鋸齒,有時近基部全緣,兩面無毛或下面脈腋有簇毛;葉柄長2 - 3厘米,無毛。As both the meshing point and ball ' s center are on the given cylinder, a general method for developing the cam ' s profile is studied. it is proved that the profile of positive and negative transmission is unique if the face gear, the difference between face tooth number and ball number and the diameter of ball are the same. the concrete expression of meshing cam on given spatial cycloid profile, and the characteristics of the profiles are discussed
論文的主要工作包括: 1 、根據嚙合點和鋼球中心軌跡均在同一圓柱面上的特點,研究了給定端齒齒廓條件下求解凸輪齒廓的一般方法;論證了在給定端齒、齒差數和鋼球直徑相同的條件下,正負齒差嚙合齒廓的唯一性;討論了端齒為球面擺線時,凸輪齒廓的具體表達式,並研究了該齒廓的性質。Based on conjunction theory, the models for gear manufacturing is developed, and the equation of the gear surface is gained by the equation of rack cutter. the contact line in manufacturing and the tooth profile of the gear is also discussed based on the equation of the gear surface
本文首先基於齒輪嚙合原理,建立了齒輪加工的模型,由刀具曲面方程推導出被加工齒輪的齒面方程,並進一步推導出齒輪端截面的齒廓方程和齒輪刀具接觸線方程。Transverse tooth profile
端面齒廓分享友人