端面 的英文怎麼說

中文拼音 [duānmiàn]
端面 英文
end face; end plane; end surface; head face; side surface; terminal face
  • 端 : Ⅰ名詞1 （東西的頭） end; extremity 2 （事情的開頭） beginning 3 （門類; 方面） item; point 4 （原...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  1. Xm ) trundle needle, trundleing the post thrust bearing trundles the needle through the roll part of the body, cylinder roller and thrust maintain shelf and the thrust bed down the livestock to make up, trundleing needle and the cylinder roller is subjected to the shelf maintaining that the thrust maintains and guides. moreover thrust bed down the livestock against the difference, shaft, the pedestal encircles and employs in company, fix module shaft shoulder end face and the shell opening back plane dimensional tolerance, geometry accuracy, rigidity, axial is moved up and down, coarse degree ought to accord with the internation ， national standard stipulation demand

    滾針，滾柱推力軸承由滾動體滾針，圓柱滾子及推力保持架和推力墊圈組成，滾針和圓柱滾子受到推力保持的保持架引導，並與不同的推力墊圈，軸，座圈一起使用，安裝組件的軸肩端面和外殼孔底面的尺寸公差，幾何精度，剛性，軸向跳動，粗糙度應符合國際，國家標準規定的要求。
  2. Chuck for grinding hole and end face of bevel gear

    磨圓錐齒輪孔和端面用的卡盤
  3. Two sets of back - to - back assembled mechanical seal bia, and together with a shared spring can form a double mechanical seal

    由二套bia機械密封背靠背安裝，共用一個彈簧可組成一套雙端面機械密封型式。
  4. Laminated wood plastics. compreg determination for brinell hardness of end

    木質層積塑料.端面布氏硬度的測定
  5. The ultrasonic dynamic contact of bolt - clamped transducer and rigid plane are modeled using hertzian contact theory, and the analyzing results reveal that the nodal plane of the bolt - clamped transducer is levitated in normal direction by the ultrasonic dynamic contact action, and the real area of contact of bolt - clamped transducer and rigid plane decreases in the same time

    首先利用赫茲接觸理論建立了夾心式換能器和剛性平面的超聲動態接觸模型。通過對模型進行分析、求解表明，在縱向超聲頻率動態接觸作用下，換能器節面位置產生了上浮，換能器端面與剛性平面的動態真實接觸面積比靜態時減少了。
  6. Results showed that the temperature, temperature gradient and thermal stress at the exit surfaces of the cws ceramic nozzle were higher than that of other part of the nozzle

    結果表明：在陶瓷水煤漿噴嘴的出口端面存在較大的溫度、溫度梯度和熱應力。
  7. Transverse diametral pitch

    端面徑節
  8. The innovative dishing ring not only possesses end - face sealing capacity, but also has some radial seal and clean function

    改進的碟形密封圈不但具有端面密封能力，而且將具有一定的徑向密封和擦拭功能。
  9. The dishing ring seals belong the end face sealing parts, and act as sealing by some axial compression. because of different distribution of internal pressure and temperature, the friction inside the end - face is also different at all area

    碟形密封圈屬于端面密封元件，依靠一定的軸向壓縮量進行密封，由於端面內壓力分佈、溫度分佈不均，端面內的摩擦狀況也不是處處相同。
  10. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  11. Since the glass is in compression, it cannot extend appreciably beyond the ends of the eyelet.

    因為玻璃處于壓縮狀態，玻璃不能明顯地延伸到超過座孔的端面。
  12. It is well established that facet damage is caused by the optical flux density at the laser facet and that it is not a function of the operating current.

    業已明確肯定，端面損傷是由激光器端面的光流密度引起的，並且不是工作電流的函數。
  13. In order to considering the affections of the adjacent zone out of the girdler section, the internal - forces of two end surface which were obtained by the horizontal shaft system analysis are exerted on each model respectively. moreover, the weight, cable force and prestressing forces including girder longitudinal, diaphragm transverse and inclined web vertical directions are considered

    考慮到梁段以外附近區域的作用，在其兩端面上施加了由平面桿系結構分析所得的端面內力，另外，索力和預加力（梁縱向、橫隔梁橫向、斜腹板豎向）也施加在相應的位置，分析了箱形主梁在自重、索力和預應力作用下的空間應力效應。
  14. The spindle supporting structure of micropipette grinding apparatus eliminated the influence upon the end wobble of grinding plate effected by motor

    磨針儀主軸支承結構消除了電機對磨盤端面跳動的影響。
  15. For the tip - to - face roof stability, chock - fram type powered support only be applied to hard top - coal, shield - type powered support and chock - shield - type powered support can be applied to three top - coals

    通過分析，為保證端面頂板穩定，支撐式液壓支架僅適用於頂煤為硬煤的條件下，掩護式和支撐掩護式支架在三種頂煤條件下均可以適用。
  16. The end of the hole is hemispherical.

    小孔端面成半球狀。
  17. Facial nerve - hypoglossal nerve anastomosis, no matter what reason place causes facial nerve loss, want to be able to find facial nerve far end only, the person that facial muscle does not have fiber denaturation, but will at least near side of nerve of partial motion fibrous carries as far as facial nerve side to carry be identical

    面神經-舌下神經吻合術，不論什麼原因所引起面神經損傷，只要能找到面神經遠端，面部肌肉無纖維變性者，可將至少有部分運動纖維的神經近側端與面神經遠側端吻合。
  18. Grinding parts : including the ends, surface rings, trifle furrow, inclined plane, opening and etc

    研磨部位：包括端面周面斷屑槽溝斜面孔穴等加工研磨。
  19. Analytical solution of the residual stress when the inflexion of the retaining ring is on the top

    兩炮喇叭口爆炸成形強化護環拐點在上端面時殘余應力的解析解
  20. Next, in order to comprehand the electromagnetic characteristics and the dynamic characteristics of the new type of magnetic micromotors, the dissertation applied the concept of the magnetic scarlar potential of the irrotational magnetic fields and set up the mathmatic model for the inner magnetic field of the new type of motors from the basic equations and the boundary conditions of the motor magnetic field. oh the basis of the mathmatic model, the dissertation analized the various qualities of the magnetic field of the air gap between the rotor and the stator and gave a detailed calculation of the air gap ' s magnetic potential, magnetic field intensity, magnetic induction, the shape of the magnetic scarlar potential level surface, the distribution of the magnetic circuit, the magnetic induction the self - inductance and the mutual inductance of the coils

    其次，為全面了解這種新型電磁電機的電磁特性和動力特性，本文從電機磁場的基本方程及其邊界條件出發，應用無旋磁場的標量磁位概念，建立了端面搖擺式電磁微電機內部磁場的數學模型，並以此為基礎，詳細分析了電機氣隙磁場的各方面性質，對氣隙磁場的磁標位、磁場強度、磁感應強度、等磁位面形狀、電機工作磁路的分佈、電機的工作磁通量以及激勵繞組的自感和相互之間的互感進行了詳細的分析計算。
分享友人
分享到 Line

分享到臉書