第一度裂傷 的英文怎麼說

中文拼音 [dìyīdùlièshāng]
第一度裂傷 英文
first degree laceration
  • 第 : Ⅰ助詞（用在整數的數詞前 表示次序） auxiliary word for ordinal numbers Ⅱ名詞1 [書面語] （科第） gr...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 傷 : Ⅰ名詞1 （人體或其他物體受到的損害） wound ; injury 2 （姓氏） a surname Ⅱ動詞1 （傷害） injure; h...
  • 第一 : first; primary; foremost; first and foremost
  • 裂傷 : lacerated wound; laceration
  1. The knowledge on the properties of used materials is urgently needed for reasonable life - prediction and life - distribution. as cylinder bolts are concerned, they often rapture at the first tooth - root resulting from lower high temperature strength of their material and higher stress. since bolts operate at high temperature environment, creep skew and damage causing their failure are important factors that can not been neglected

    就汽缸螺栓而言，由於螺栓材料的高溫強度偏低，預緊力過大，常常在螺栓的第一齒根部位發生蠕變脆性斷裂，因其長期在高溫環境下工作，蠕變變形和蠕變損傷是其失效的一個不可忽略的重要因素。
  2. Thirdly, in term of the results of testing and calculation, the displacement and libration, the difference of altitude, the flexibility and strain of crane - beams are all generally analysed, especially the reason why the crane - beams are attaint is lucubrated, and the reasons why the trigging pole is ruptured, the upper wingspan is damaged, the orbital movement, the exceptional incline of colums are open out, which has instructional significances that improve the design of the steel frame of the coke made by dry flameout

    第三，根據檢測和計算結果，對鋼框架的位移和振動、框架高差、吊車梁撓度和應變等進行了全面的分析，特別對吊車梁系統的損傷原因進行了深入分析，揭示了制動桿件斷裂、上翼緣磨損、軌道竄動、柱異常傾斜等一系列損傷現象的原因，對于改進干熄焦鋼框架的設計有著直接的指導意義。
  3. The second chapter analysis the way how to decide the length of the limiting flaw. according to the theory of fracture mechnics and damnification mechnics, and the author lakes two way for calculating the length of the limited flaw, in finally, two calculation result is identical, so we can draw a conclusion that the method that we used in the past is in consistent with reality

    本文第二章分析了如何應用斷裂力學和損傷力學知識，用兩種不同的求解方法來確定臨界裂紋的長度，計算分析發現兩者結果一致，這說明我們所使用的確定臨界裂紋長度的方法和實際情況是一致的。
分享友人
分享到 Line

分享到臉書