等地下溫度線 的英文怎麼說

中文拼音 [děngdexiàwēndùxiàn]
等地下溫度線 英文
chthonisothermal line
  • 等 : Ⅰ量詞1 （等級） class; grade; rank 2 （種; 類） kind; sort; type Ⅱ形容詞（程度或數量上相同） equa...
  • 下 : 下動詞1. （用在動詞后,表示由高處到低處） 2. （用在動詞后, 表示有空間, 能容納） 3. （用在動詞后, 表示動作的完成或結果）
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 溫度 : [物理學] temperature
  1. A method to calculate quantitatively the adsorption volume or adsorption space of per mass of adsorbent derived from both the adsorbed molecule volume and the maximum adsorbance of a solute in an adsorption isotherm under a given experimential condition is presented firstly for a solid / liquid adsorption system of the solute in a dilute aqueous solution. this method is suitable for not only mono - layer adsorption, but also mani - layer adsorption and micelle adsorpion of surfactant constructed by hydrophile and lipophile groups. therefore, the surface concentration of the adsorbate, cs, deduced from the adsorption volume is possessed of the meaning of true concentration, and the value of the patition coefficient of the adsorbate between solid and liquid phass, p, attained by the cs and the c, solution concentration of the adsorbate, can be accurate. the foregoing a set of calculations are presented for the solid - liquid adsorption systems consisted of the wool fiber and separately dodecyltrimethyl - ammonium bromide ( dtab ) and hexadecyltrimethyl - ammonium bromide ( ctab ) in this paper. this provides a strong basis for adsorption thermodynamic investigation of adsorbate

    對稀溶液中溶質的固/液吸附體系，首次提出了根據吸附分子體積和實驗條件下吸附等溫線中的最大吸附量計算單位質量吸附劑的吸附體積或吸附空間的方法.此法適用於單層吸附，也適用於多層吸附和具有親水親油結構的表面活性劑分子的膠團吸附.由此，吸附質的表面相濃度cs具有真實濃度的含義，相應地，計算得到的溶質的固/液分配系數p就有了準確值.分別計算由溴代十二烷基三甲銨（ dtab ）和溴代十六烷基三甲銨（ ctab ）與羊毛纖維構成的液/固體系分配系數等，為溶質吸附的熱力學研究奠定了基礎
  2. A transfer model is established, which can be used to study the interaction between the land surface physical processes of inhomogeneous region and the structure of atmosphere boundary - layer over urban and rural terrains. the model has simulated surface heat flux, surface temperature, temperature profiles, height of mixture layer and so on. and the differences between urban area, suburban area and rural area have been compared. this model mainly depends on the parameters below : surface albedo, surface roughness coefficient, moisture available coefficient of soil, thermal capacity and thermal diffusion coefficient of errain, cloudage. the result shows that this model can simulate the structure and eigenvalues of atmosphere boundary layer and their changes in a day. parameters used in this model aim at beijing city, and the time is at the beginning of september. to other cities, or other time, the parameters should be adjusted accordingly. in addition, being adjusted, the model can also be used for other homogeneous and inhomogeneous terrains

    模式主要依賴于以下參數和物理量：地面反照率下墊面粗糙度土壤的可含水量下墊面的熱容量和熱擴散系數雲量等參數。結果表明，本模式能合理地模擬不同地表熱量平衡地表氣溫混合層高度湍流交換系數湍流動能位溫廓線等，以及它們的日變化。該模式所取參數主要針對北京市，時間為九月初，對于其他城市，參數應作相應的調整。
  3. The gas feed automation system, which includes field instruments, gas feed controller, wireless remote supervising system, and so on, will realize following functions : gas flow measurement, gas pressure and temperature measurement, gas flow control, gas pressure regulation, intermittent gas lift, wireless remote monitoring, and etc. this paper will discuss the following content in detail : first part is introduction

    該自控系統包括現場變送儀表、氣舉配氣控制器和無線遠程監控等，主要完成天然氣流量計量、氣體壓力溫度檢測、天然氣流量控制、管道干壓調節、間歇氣舉以及遠程監控等功能。本文將會重點介紹以下內容：首先是概述部分，簡要介紹了氣舉採油技術和氣舉配氣系統的地位和現存問題，並介紹了配氣自控系統的主要性能和優點。
  4. This paper studies the application of inductively coupled plasma ( icp ) technology to the etching compound semiconductor insb - in film. by means of single probe and double probe, the ion density and electron temperature of chamber ( 30mm and 50mm in height respectively ) under varied process condition were diagnosed. the spatial distribution of the axial position of the two parameters and the varied curve that the two parameters varies with the power and air pressure are obtained

    利用單探針和雙探針診斷30mm高反應室和50mm高反應室在各種工藝條件下的離子密度和電子溫度，得到這兩個參數在反應室軸向位置的空間分佈、隨功率和氣壓的變化曲線、頂蓋接地和反應室體積對它們的影響，結果表明離子密度為10 ~ 8 10 ~ （ 10 ） cm ~ （ - 3 ） ，電子溫度在4 10ev之間；當頂蓋接地時，該處的等離子體密度明顯大於不接地；在同樣條件下， 50mm高反應室內的離子密度明顯大於30mm高反應室。
  5. Aim : to analyze the mechanism, thermadynamic theoretical basis, dynamic mechanism and influencing factors of thermally induced phase separation ( tips ) in order to completely grasp the factors affecting the size, distribution and form of pores, so that the adjusted range of pore can be widened and the preparation of porous membrane can be repeated and controlled. methods : considering from the structural characteristics of tissue engineered materials, the methods of preparing porous membrane using tips technique, the hermadynamic theoretical basis, dynamic mechanism and influencing factors were analyzed, the problems and investigative directions in the future were also analyzed. tips technique is a process of phase separation of polymer homogenous solution under quenching, and it is suitable for diameter and structural form of the micropore materials prepared using tips are closely correlated with the kind and dispensing proportion of polymer attrnuant, polymer concentration and polymer molecular mass, etc. conducted, including determination of polymer - solvent system phase diagram, study of form and appearance of porous membrane of different thickness, study of form and appearance of porous membrane prepared with systems of different x, which is the parameter of polymer - solvent interaction

    目的:分析熱致相分離成膜過程的機理、熱力學理論基礎、動力學機制以及影響因素，以便充分掌握影響孔度大小、分佈、形態的因素，使孔度調控范圍得以拓寬，使多孔膜的制備能重復可控.方法:從組織工程材料結構特點出發，分析熱致相分離聚合物多孔膜的制備方法及該法成膜的熱力學理論基礎、動力學機制以及影響因素.並分析實驗中存在的問題及今後的研究方向.結果:以熱致相分離法可制備聚合物多孔膜.熱致相分離法制備多孔膜是高聚物均相溶液在淬冷條件下發生相分離的過程，它適用於上臨界共溶溫度型聚合物一稀釋劑二元體系.熱致相分離法成膜的過程，可以認為是旋節線機理佔主導地位.熱致相分離法制備的微孔材料，其孔隙率、孔徑大小、結構形態與聚合物稀釋劑的種類、組成配比、聚合物濃度、聚合物分子量等因素密切相關.結論:可採用熱致相分離技術制備多孔膜，通過改變不同的成膜條件可獲得一系列不同孔徑尺寸和孔徑分佈的多孔膜材料.對熱致相分離成膜過程中聚合物-溶劑體系的相圖測定，不同厚度的多孔膜形貌研究，不同x （聚合物-溶劑相互作用參數）體系所制備的多孔膜形貌等需深人研究
  6. ( 2 ) because of t he variability of rock subjected to outside action, three new conceptions : postive damage basic damage and negative damage, are suggested, which can deal with the condition that rock density became large. ( 3 ) the present damage variables based on ct number mostly include ct average number of the rock without damage, which is difficult to measure, so a new damage variable, which includes the average ct number is proposed, on the other hand, strain equal theory is generalized because the one put foreword by lemaitre is not good enough to use. ( 4 ) a axial damage constitutive equation is proposed and testified. ( 5 ) with the circle times, the damage propagation laws of two different rocks, subjected to circle of freezing and thawing, are studied, and in the analysis process, traditional analysis method including average ct number and is used, some important conclusions are reached : inner damage of soft rock containing a large mount of apertures is largely propagating with the time increasement of circle, however, at the preliminary time, the hard rock containing a small mount of aperture is a little propagating, at late time, the influence become large ; ( 6 ) zone separation and statistics frequency put forward is used to analysized the three different damage propagation in the open circumstance, when they are subjected to the different circle times of freezing and thawing, in which the temperature variability is linear, different freezing rate, and different freezing temperature, and no water is supplied during the test

    在研究過程中本文主要做了以下工作： （ 1 ）針對巖石損傷變化較小時，運用ct均值和方差分析不方便的缺陷，本文提出運用對ct數范圍劃分區段的方法，根據各區段統計頻率的變化規律來分析損傷擴展狀況； （ 2 ）針對巖石受到外部作用的多變性，本文提出了基準損傷，正損傷，負損傷的概念，在某種程度上考慮了巖石受到外部作用時的壓密情況； （ 3 ）現有的基於ct數的損傷變量大多需要用到巖石基體的ct均值，這實際上是很難觀測到的，因此本文建議了一個可運用巖石初始狀態ct均值的損傷變量，由於現有的勒邁特教授應變等價原理使用上的不便，本文在其基礎上進行了推廣； （ 4 ）建議了一個可用巖石初始狀態ct數和彈性模量的單軸損傷本構方程，並用算例進行了驗證； （ 5 ）對兩種不同巖石在開放環境下受到凍融循環作用且融化過程中補水時，內部損傷隨凍融循環次數增加的擴展規律進行了探討，主要運用了常規的ct均值和ct方差的分析方法進行分析，試驗發現：對于孔隙率和含水率較高，密度和強度較低的軟弱巖石，凍融循環次數對損傷結構的擴展有明顯的影響，而對于孔隙率和含水率較低，密度和強度較高的硬巖，凍融循環次數對其損傷結構擴展初期由於含水率低的原因，影響不是太大，而後期由於水補給后，含水率較高的原因，凍融影響逐漸增大； （ 6 ）運用了本文提出的區段劃分和統計頻率的方法，深入地分析了開放環境下的線性溫度變化的凍融循環次數，凍結溫度，凍結速度不同巖石作用時，其內部損傷隨凍融循環次數，凍結速度和凍結溫度變化的擴展規律，需要指出的是除了在試驗前飽水外，凍融過程中沒有補水。
分享友人
分享到 Line

分享到臉書