等溫等壓系綜 的英文怎麼說

中文拼音 [děngwēnděngzōng]
等溫等壓系綜 英文
isothermalisobaric ensemble
  • : Ⅰ量詞1 (等級) class; grade; rank 2 (種; 類) kind; sort; type Ⅱ形容詞(程度或數量上相同) equa...
  • : Ⅰ形容詞(不冷不熱) warm; lukewarm; hot; gentle; mild Ⅱ名詞1 (溫度) temperature 2 (瘟) acute ...
  • : 壓構詞成分。
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : 綜名詞[紡織] (織布機上使 經線交錯著上下分開以便梭子通過的裝置; 綜片) heddle; heald
  1. The subject for different process technology and surface treatment of crank takes tracking checkout for its internal stress, analyses relation of jumping measurement, deformation measurement, recovery measurement and stress change, finds the reason and usual law of jumping overproof of crank. through cold pressure alignment, hot pressure alignment, support aged alignment and so on methods for 42crmo steel crank, the subject checks change of stress in the process of alignment and change of tissue and property after alignment for crank, and gives comprehensive evaluation for every alignment technology, then give safe and feasible technology parameter

    本課題主要是對不同加工工藝及不同表面處理過程的曲軸,對其內應力進行跟蹤檢測,分析各工藝過程中跳動量、變形量、恢復量與應力改變的關,找出曲軸跳動量超差的原因和一般規律。通過對42crmo鋼曲軸進行「常力校直」 、 「熱力校直」 、 「支撐時效校直」方法的校直,檢測校直過程中曲軸應力的變化及校直后組織和性能的改變,進而對各校直工藝進行合評價,給出安全可行的工藝參數。
  2. The primary theory of absorption and desorption was also explained. the effects of primary process parameters, such as hydrogen pressure, time and temperature on the magnetic properties of ndfeb have been researched. the structure and magnetic properties have been analyzed by means of optical metallographic microscopy, scanning electronic microscopy, x - ray diffraction analysis, infrared oxygen detector and magnetic properties measurement

    本文設計了燒結ndfeb的氫爆制粉設備,對設備調試以及使用過程中出現的主要問題進行了簡要的說明,提出了一列解決方法;闡述了吸氫、脫氫的基本原理;研究了氫氣力、通氫時間、氫爆基本工藝參數對磁性能的影響;利用金相顯微鏡和掃描電子顯微鏡, x射線衍射分析,紅外線測氧分析及合磁性測量儀手段分析了材料的組織結構和磁性能。
  3. For the ceramic materials, the effects of additives such as pbo, b2o3, co2o3, mno2, cr2o3, sb2o3 on the electrical properties of bismuth - free zno - glass varistor were studied. the glass phase formed mainly by pbo and b2o3 during sintering process could decrease the sintering temperature, improve grain uniform growth and inhibit grain second growth. nonlinear property could be improved by properly adding co2o3, mno2, and cr2o3

    對瓷料而言,統研究了非bizno -玻璃料配方體中pbo 、 b2o3 、 co2o3 、 mno2 、 cr2o3 、 sb2o3添加劑對敏電阻電性能的影響規律,其中, pbo 、 b2o3在燒結過程中形成的玻璃相,可降低燒結度,促進晶粒均勻生長,抑制晶粒二次長大, co2o3 、 mno2 、 cr2o3做為非線性添加劑,適量添加可提高樣品的非線性, sb2o3做為改性添加劑,在燒結過程形成的尖晶石相可細化晶粒,抑制晶粒二次生長,改善樣品的合電性能。
  4. Begin with the comparation of two widely used methods producing the strontium titanate, the oxalate decomposition method shows its advantage hi the microstructure and future performance. the effect of caco3 is studied, and so is the effect of the donor dopant, such as nb2o5, y2o3 and la2o3. the dopant of tio2 is also considered, which involve ti / sr ratio, sintering temperature, oxygen partial pressure, donor dopant, grain growth and future electric performance

    從對比草酸鹽分解法和固相合成法這兩種制備srtio _ 3主晶相的方法開始,在予合成料的制備過程中分析了施主nb _ 2o _ 5 、 y _ 2o _ 3 、 la _ 2o _ 3以及caco _ 3所產生的影響;在tio _ 2摻雜的問題上,合考慮了ti / sr比、燒結度、氧分、施主摻雜、晶粒的微觀生長與成瓷后的元件宏觀電性能之間的相互關
  5. Abstract : emphasis is put on the recent development concerning the catalytic oxidation of methane to oxygenates by heterogeneous catalysis and liquid catalysis. for heterogeneous catalysis, the choice of catalysts, reaction temperature and pressure, oxygents, additives, reactors and reaction mechanism are summarized. different research systems of liquid phase oxidation of methane are reviewed

    文摘:本文對甲烷催化氧化制含氧化合物的研究,從多相催化和液相催化兩個方面進行了述;對多相催化的研究從催化劑的選擇、反應度、反應力、氧源、反應添加物、反應器及反應機理方面進行了總結,液相氧化的研究則對不同的研究體進行了詳細的述。
  6. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    統可通過沉積參數的精確控制,以控制沉積過程,減少金剛石膜生長過程中的缺陷,並採用光纖光譜儀檢測分析離子體的可見光光譜以監測微波離體化學氣相沉積過程;利用微波對材料的選擇加熱特性,通過構造效方程,並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中,建立了非均勻離子體度場合模型、復合介質基片材料的復合度場模型及復合介質材料度場攝動模型,為mpcvd的基片加熱統設計提供了一條全新的技術路線以指導基片加熱材料的制備,並對基片加熱材料進行了設計和優選,以獲取大面積均勻的度場區,甚至獲得大於基片臺尺寸的均勻度區;作為研究重點之一,開展了微波離體化學氣相沉積金剛石的成核與生長研究,統地研究了在( 100 )單晶硅基片上mpcvd沉積金剛石膜的實驗過程中,基片預處理、甲烷濃度、沉積氣、基體不同實驗工藝參數對金剛石薄膜質量的影響,分別用raman光譜、 x射線衍射( xrd ) 、掃描電鏡( sem ) 、紅外透射光譜( ir ) 、原子力顯微鏡( afm )對薄膜進行了表徵,確立了該統上mpcvd金剛石膜的最佳的實驗工藝參數。
  7. By the research on the raw materials, the mix proportion, the concrete temperature control in outlet, in transport and in placement, the cure and the post - cooling water, the synthetic measures for rcc dam construction in high temperature and the enforcement methods on basis of the computation and experience of jinghong hydropower station are presented in this paper

    本文通過對原材料及配合比、混凝土出機口度控制、運輸過程度控制、澆築過程的度控制以及混凝土澆筑後的養護和冷卻通水列研究,提出景洪電站高氣條件下大壩碾混凝土連續施工的合措施,並在計算和已有經驗的基礎上給出具體實施方法。
  8. This system has various kinds of sensors, such as pressure, temperature, electric current, voltage, controlling synthetically, etc. after a sensor does not work or takes off the line, other sensor of on - the - spot equipment will serve as the commander or the controller. so the system does not be influenced with for some sensor ' s trouble. this is the best advantage of control system based on fieldbus

    由原集散控制統( dcs )升級為fcs統,本文所討論的統有力、度、電流、電合控制各種傳感器,當一個傳感器失靈或脫線后,其它有關傳感器會自動擔任指揮員或調度員,統不會因為某一節點的故障而影響整個統的運行,這是基於現場總線控制統( fcs )的優勢。
分享友人