等量吸附熱 的英文怎麼說

中文拼音 [děngliángxībùrè]
等量吸附熱 英文
isosteric heat of adsorption
  • 等 : Ⅰ量詞1 （等級） class; grade; rank 2 （種; 類） kind; sort; type Ⅱ形容詞（程度或數量上相同） equa...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 吸 : 動詞1 （把液體、氣體等引入體內） inhale; breathe in; draw 2 （吸收） absorb; suck up 3 （吸引） a...
  • 附 : Ⅰ動詞1 （附帶） attach; add; enclose 2 （靠近） get close to; be near 3 （依從; 依附） agree to; ...
  • 等量 : equivalent; half-and-half
  1. A method to calculate quantitatively the adsorption volume or adsorption space of per mass of adsorbent derived from both the adsorbed molecule volume and the maximum adsorbance of a solute in an adsorption isotherm under a given experimential condition is presented firstly for a solid / liquid adsorption system of the solute in a dilute aqueous solution. this method is suitable for not only mono - layer adsorption, but also mani - layer adsorption and micelle adsorpion of surfactant constructed by hydrophile and lipophile groups. therefore, the surface concentration of the adsorbate, cs, deduced from the adsorption volume is possessed of the meaning of true concentration, and the value of the patition coefficient of the adsorbate between solid and liquid phass, p, attained by the cs and the c, solution concentration of the adsorbate, can be accurate. the foregoing a set of calculations are presented for the solid - liquid adsorption systems consisted of the wool fiber and separately dodecyltrimethyl - ammonium bromide ( dtab ) and hexadecyltrimethyl - ammonium bromide ( ctab ) in this paper. this provides a strong basis for adsorption thermodynamic investigation of adsorbate

    對稀溶液中溶質的固/液吸附體系，首次提出了根據吸附分子體積和實驗條件下吸附等溫線中的最大吸附量計算單位質量吸附劑的吸附體積或吸附空間的方法.此法適用於單層吸附，也適用於多層吸附和具有親水親油結構的表面活性劑分子的膠團吸附.由此，吸附質的表面相濃度cs具有真實濃度的含義，相應地，計算得到的溶質的固/液分配系數p就有了準確值.分別計算由溴代十二烷基三甲銨（ dtab ）和溴代十六烷基三甲銨（ ctab ）與羊毛纖維構成的液/固體系分配系數等，為溶質吸附的熱力學研究奠定了基礎
  2. The investigation of a lot of parameters about treated sandstone, brick materials and earthen materials with fluorited polymers has been carried out, such as the formation of polymer, the penetration depth, porosity, capillary absorption and penetration coefficient, water uptake, compressive strength, drilling resistance, absorption isotherms of water vapor, water vapor diffusion, color changes as well as resistance to desegregation of water, frizzing - throwing cycles, worming - cooling cycles, and so on. in addition, the influence of salt crystallization, acid and base, and uv aging have also been assessed in order to better understand the protection effects and utilization possibility of two fluorinated polymers, mainly according to astm standard and the combination of international methods together with general technological

    分別以國家級文物保護單位的土質、砂巖和磚材文物樣品為對象，依據astm標準及國際通用文物保護研究方法與評估準則相結合，通過膠化物形成周期、滲透深度、孔隙度、毛細吸水和滲透系數、持水量、抗壓強度、抗鉆強度、吸附水蒸氣的能力、透氣性、外觀顏色等系列參數的測定，及凍融、冷熱循環、酸堿腐蝕后抗壓強度的衰減、可溶鹽對保護效果的影響、酸堿及光照對表面保護效果的影響，對兩種含氟聚合物及其與有機硅的共混物在文物加固保護和表面防護中的可行性和保護效果給予了系統研究。
  3. ( 1 ) for the first time, compositing the chemical compounds of alkaline - earth metal with the adsorption material, 13x molecular sieve, silica gel, and activated alumina to gain a series of composite adsorbents with good performance that higher adsorption capacity and lower regeneration temperature and suitable for adsorption refrigeration systems that can be driven by low - grade thermal energy

    首次將堿土金屬化合物及其鹽類與傳統吸附材料13x分子篩、硅膠和活性氧化鋁等復合，制取具有較高吸附量和較低再生溫度的適合於以低溫熱能驅動的吸附製冷過程的一系列優良復合吸附劑。分別在自製的吸附製冷、除濕製冷模擬實驗裝置上，測得該系列復合吸附劑與水和乙醇組成的吸附製冷工質對的吸附製冷性能以及除濕製冷性能均優于傳統吸附劑（ 13x ，硅膠和活性炭） 。
  4. Some conclusions have been made in the following. that the value of toc is 0. 2 % may be regarded the low evaluation value of marine carbonate souce rock at the stage of high to over mature. according to the content of bitumen in source rock and reservoir, gas generation quantity, the maximum absorption gas quantity and geology analogy

    通過對儲層和烴源巖中瀝青定量統計分析、烴源巖生氣熱模擬、最大吸附氣實驗測定及地質類比法等綜合研究認為在鄂爾多斯盆地有機碳為0 . 2可作為高?過成熟的海相碳酸鹽巖有機碳下限標準。
  5. Antibody, which was coated to ps - mpm by using immunology method, reacted to special corresponding antigen. the heat change in the adsorption process of antibody to mpm and the reaction process to antigen were measured by using microcalorimetry. the adsorption mechanism and the special reaction were analyzed, which established the primary base of profound study on the aspect of biology application for mpm

    本文採用免疫學方法，在聚苯乙烯磁性微球表面包覆了抗體，並與武漢理一1幾大學碩十學位論文特定的抗原發生特異性反應，利用tamair等溫微量熱檢測儀測量了微球與抗體吸附過程及與抗原發生特異性反應過程中的熱量變化，探討了微球與抗體之間的吸附機理和與抗原之間的特異性反應，為更為深入地研究磁性微球在生物方面的應用奠定基礎。
  6. The fe3o4 nano - particles were converted from hydrophilic to oleophylic by being modified by oleic acid. the heat change in the adsorption process of fe3o4 nano - particles to oleic acid was measured and discussed by using microcalorimetry. the adsorption mechanism was analyzed

    本文採用油酸作為表面活性劑對fe _ 3o _ 4納米粒子進行了改性，實現了fe _ 3o _ 4由親水性向親油性的轉變，並利用tamair等溫微量熱檢測儀研究了在不同溫度下，油酸與fe _ 3o _ 4吸附過程中的熱量變化情況，討論這個過程中熱量的變化，分析了兩者之間的吸附機理。
  7. A number of factors will affect efficiency of the biosorption, and these factors were studied in chapter three, including the ph value, initial biomass loading and content of heavy metal ions, ion strength of the solution, etc. although the research for new and innovative treatment technologies has focus attention on the metal binding capacities of various biomass, the exact interaction between the ligands of the metal uptake process and the description of the thermal properties of the biosorption remain essentially unknown

    藻類對重金屬離子的吸附效率受藻類細胞表面及溶液的物理化學狀態的影響，本文從ph 、藻粉的起始含量及重金屬離子的起始濃度、離子強度等四個方面做了研究。第四章是大型海藻生物吸附平衡的熱力學研究，我們對平衡數據做了langmuir方程的回歸分析，得到了兩種海藻吸附各重金屬離子的最大吸附容量；我們還以cu為例研究了溫度對吸附容量的影響，並計摘要算了其吸附熱。
  8. The activated alumina manufactured in ou factory has a large capacity of absorption, high surface area, high strength and thermal stability. it can be widely used as an absorbent, desiccant and catalyst carrier in chemical, pertochemical, fertilizer, oil and gas industries

    我公司生產的活性氧化鋁具有吸附容量大、比表面積大、強度高、熱穩定性好等特點，可廣泛應用於化工、石化、天然氣和化肥等工業中作吸附劑、乾燥劑及催化劑載體等。
分享友人
分享到 Line

分享到臉書