等離子流束 的英文怎麼說

中文拼音 [děnglíziliúshù]
等離子流束 英文
current column
  • 等 : Ⅰ量詞1 （等級） class; grade; rank 2 （種; 類） kind; sort; type Ⅱ形容詞（程度或數量上相同） equa...
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 束 : Ⅰ動詞1 （捆; 系） bind; tie 2 （控制; 約束）control; restrain Ⅱ量詞（用於捆在一起的東西） bundle;...
  • 離子 : [物理學] ion
  1. Finally, the characteristics of ion curren extraction in different conditions are simulationed with magic software, and the parameter of best emission surface is obtained

    最後，採用magic程序對高頻離子源不同引出參數下的束流引出特性進行了數值模擬，得到了獲得最佳的引出離子束所要求的等離子體發射面參數。
  2. The feasibility that kaufman ion source is applied in reactive ion beam etching is discussed. etching characteristics of materials, including pr, cr, quartz, are investigated. the etch rate and mechanisms of such materials are measured and analyzed as a function of ion energy, ion beam density and ion incidence angle in pure ar and chf3, respectively. the etch rate has shown a square root dependence on variation versus

    深入研究了光刻膠、鉻薄膜、石英等光學材料離子束刻蝕特性，分別以ar氣和chf3為工作氣體，研究光刻膠、鉻薄膜、石英等的刻蝕速率隨離子能量，束流密度和離子入射角度的變化關系，得到刻蝕速率與影響因素的擬合方程，為掩模的製作工藝路線提供了實驗依據和理論指導。
  3. The control of beam halo - chaos becomes a critical problem in the development of high intensity accelerator. efforts to remove the halo by collimation have been largely unsuccessful since the halos almost always regenerate. the mechanisms of halos are complex, such as nonlinear resonances and chaotic behavior etc. considering this, professor fang jin - qing who works in china institute of atomic energy pointed out that the theory of chaos control can be used to control beam halos. he presented the method to control halos by using nonlinear functions, which means nonlinear function g is added to the right of ion radial self - edlctric force equation and some nonlinear function are selected to control beam halos in simulations. in paper [ 69 ], controllerg = - 0. 15sin ( rmax - am ) 2 was used and the halo intensity was decreased to 0. 1078, the halos are removed partly

    束暈?混沌的控制是新一代強流加速器研製的關鍵問題，隨著強流離子束應用前景的日趨廣闊而日益成為研究的熱點。傳統機械限束器因無法解決束暈的再生而收效甚微，因為束暈的形成有著其內在動力學機制?非線性共振以及混沌等。基於此，中國原子能科學院研究員方錦清將混沌控制的理論和方法開創性的運用於束暈?混沌的控制上，提出了控制束暈?混沌的非線性控制策略，即在粒子徑向所受束自生場力方程的右邊加上非線性控制函數g ：並選取一些非線性函數如等進行了控制的模擬研究，將束暈強度控制在0 . 1078左右，取得了初步的控制效果。
  4. In the section of fabricating technology, i first discuss the ion beam technology. through the analysis of the effects of each parameter on the surface smoothness, profile fidelity and linewidth resolution in the process of ion etching, the suitable angle of incident ion beam, ion energy, density of ion beam and time of etching are selected combining the actual status of the mask

    在製作工藝的研究方面，首先研究了離子束刻蝕技術，通過對離子束刻蝕過程中各個參數對刻蝕元件的表面光潔度、輪廓保真度和線寬分辨的影響分析，結合掩膜的實際情況選擇出了合適的離子束入射角、離子能量、束流密度和刻蝕時間等參數。
  5. Investigation of plasma drift velocity vs time in intense electron beam diode

    強流脈沖電子束二極體等離子體漂移速度的研究
  6. The paper mainly focused on the beam transport part of asipp key laboratory of ion beam bioengineering and it ' s component elements, for example, van de graff accelerator, bending magnet, magnetic quadruple lenses, beam shutter, collimator and so on. the laboratory has performed the milestone achievement that is beam passed the hole of lo ^ m diameter in experiments. many experimental results are discussed by theories according to experiments

    本文重點討論了中科院離子束生物工程學重點實驗室單粒子束裝置的束流傳輸部分，對主要部件進行了詳細的討論，如：靜電加速器、偏轉磁鐵、磁四極透鏡、束線開關、瞄準器等，實驗中已取得束流穿過10 m小孔的標志性成果，並運用相關理論結合具體實驗分析了實驗結果。
  7. Using the two - stream fluid model, the linear dispersion relation is derived assuming a two - dimensional spatial geometry. two cases are considered, one is that the 2d spatial geometry is defined by the plane containing the two counterstreaming electron populations and the perturbation wave vector ( referred as the xy plane ), and the other is that the geometry is defined by the plane being vertical to the two counterstreaming electron populations ( referred as the yz plane )

    對高能束流和電子迴流構成的雙流系統，建立冷等離子體流體模型，採用簡正模分析方法，分別考慮擾動波矢在平行於電流傳播方向的平面（記為xy平面）上和在垂直於電流傳播方向的平面（記為yz平面）上這兩種情況，推導了不穩定性的色散關系。
  8. ( 3 ) chapter v. plasma characteristics of rf ion source is investigated. a zero - dimensional numerical dynamic colisional radiative atomic and molecular ( cram ) model is suggested to simulate the microphysical process. all species " population number densities in plasma are calculated in non - thermodynamics equilibrium condition, and proton content in extracted ion current are measured with 60 ? magnetic analyzer

    （ 3 ）提出了高頻離子源等離子體的零維cram模型（ collisionalradiativeatomicandmolecularmodel ） ，計算了非平衡態（ nte ）下等離子體中分子、電子、離子、基態原子、激發態原子等粒子濃度，並在zf - 200kev中子發生器上，用60磁分析器實驗測定了引出束流的質子比。
  9. The authors present the review on dry sliding friction and wear behaviour of particle reinforced aluminum matrix composites in recent years, including friction behaviours, wear mechanisms and applications of these composites

    離子注入是一種新興的束流表面強化技術，離子注入陶瓷材料可使其表面的力學性能如斷裂韌度、硬度、彎曲強度、摩擦學性能等得到改善，它為解決結構陶瓷韌性不足、摩擦磨損率較高等問題開辟了新的技術途徑。
  10. To make pic ( particl - in - cell ) simulations. to set up models of guns and magnetic field and simulate them in the vacuum and plasma, respectively. we found that plasma held back part of space charge effects and improved trajectory of electrons. but beam would oscillate and became instable as accretion of plasma density. by simulating again and again, we draw a conclusion magic could n ' t work when plasma density was more by far than beam electron density. at last a four - stage depressed collector was simulated

    建立電子槍和聚焦系統模擬模型，分別在真空和填充等離子體條件下進行模擬。發現填充等離子體能補償部分空間電荷效應，改善電子束包絡軌跡，提高電子的流通率，但是隨著等離子體密度的增大，束電子會出現振蕩不穩定性，遺憾的是通過反復多次模擬發現本文所用粒子模擬的代表性軟體magic無法用於模擬等離子體密度遠高於束電子密度的情況。
  11. High speed water jet special machining utilizes the beam of water with very high dynamic energy to cut materials, therefore it actually belongs to the machining tool of high energy beam

    摘要高速水射流特種加工是利用具有很高動能的高速（超音速）水射流束來沖蝕材料，從而實現材料切削，屬于高能束加工范疇，是一種可與激光、等離子體、電子束加工方法媲美的新型切割加工工具。
  12. In this dissertation, with the aid of many types of constructive transformations and symbolic computation, some topics in nonlinear waves and integrable system are studied, including exact solutions, painleve integrability, backlund transformation, darboux transformation, symmetry ( similarity reduction ), conditional symmetry, lax integrable hierarchy, liouville integrable n - hamilton structure, constraint flow, involutive system, lax representation, r - matrix, separation of variables and integrable couplings. chapter 2 and 3 are devoted to investigating exact solutions of nonlinear wave equations : firstly, the basic theories of c - d pair and c - d integrable system are presented

    本文以構造性的變換及符號計算為工具，來研究非線性波和可積系統中的一些問題：精確解（如孤子解、周期解、有理解、 dromion解及compacton解等） 、 panileve可積性、 backlund變換、 darboux變換、對稱（相似約化） 、條件對稱、 lax可積族、 liouville可積的n - hamilton結構、約束流、對合系統、 lax表示、 r -矩陣、變量分離及可積的耦合系統
  13. Plasma immersion ion implantation ( phi ) seems to be an alternative approach to reduce the manufacture cost of soi wafers due to its large ion current and independence of implantation time to the wafer size

    等離子體離子注入（ p ）技術由於其強束流和大面積注入方式而有希望在soi材料制備方面獲得突破。
  14. Under a certain magnetic field, the density and stability of anode plasma determines the ion current density and its fluctuation

    在確定磁場強度下，陽極等離子體密度和穩定性決定了引出離子束流密度的大小及其波動幅度。
  15. The fast control power supply ( fcps ) of the tokamak is a dc supply with huge capacity to provide rapid magnetic field constraint to the plasma

    在托克馬克裝置中對等離子體進行磁約束的快控電源裝置是一個大容量直流電源。
  16. Improved plasma confinement by modulated toroidal current on ht - 7 superconducting tokamak

    7超導托卡馬克調制電流改善等離子體約束
分享友人
分享到 Line

分享到臉書