箍標 的英文怎麼說

中文拼音 [gūbiāo]
箍標 英文
wraparound label
  • 箍 : Ⅰ名詞（緊緊套在物體外面的圈） hoop; ferrule; band Ⅱ動詞（用竹篾或金屬條捆緊; 用帶子之類勒住） bin...
  • 標 : Ⅰ名詞1 [書面語] （樹梢） treetop; the tip of a tree2 （枝節或表面） symptom; outside appearance; ...
  1. This was the first result the cooper was looking for.

    這是老箍桶匠所要求達到的第一個目標。
  2. The cyclo - hoop effect which steel tubular has exert to the concrete shows the character of heterogeneous in the arch rib section, the same to the axial direction. the paper verifies the change of the material poisson ration and the concrete grade will make the cyclo - hoop effect obvious alteration, the change of the cyclo - hoop effect and the stress redistribution of the section produced by the shrinking and creeping of the concrete and the expensive concrete on the section

    在鋼管混凝土拱肋斷面上，鋼管對內填混凝土的環箍效應具有非均勻性，在拱軸方向上環箍效應也呈現非均勻性。驗證了材料的橫向變形系數、混凝土標號等參數的變化將引起環箍效應的明顯改變；混凝土的收縮、徐變和膨脹混凝土的應用導致鋼管混凝土的環箍效應發生變化並使截面的應力發生重分佈；並總結了其變化的基本規律。
  3. Railway transport equipment. fitting 140 mm tyres for standard gauge rolling stock

    鐵路運輸設備.標準軌距鐵路車輛用140毫米輪箍的安裝
  4. The company is specialized in producing the utility boiler pipe auxiliary, the construction pipe hangers, ferrules, wire netting stands, air conditioner netting covering, and all kinds of stamping components and non - standard components

    公司專業生產電站鍋爐管道輔件，建築管道支吊架抱箍，金屬網架空調網罩及各種沖壓件非標標準件。
  5. On the contents of two sides abovementined, this paper attempts to do some initial researches from three angles as follows : 1, the analyses of anti - seismic features on longitudinal direction of the aqueduct l ) the seismic longitudinal effects are small. the vibrant characters are decided from the structure integration and rigidness of piers and main arch - ring of the aqueduct, so the following measures should be taken in order to weaken and isolate seismic influence : properly broadening the section sizes and adopting the high class concrete, lowering the height and barycenter of building, setting hoop steel bars so as to increase the plasticity of the concrete which can absorb the seismic energy and prevent the damages due to stress centralization on the linkages and changing place

    本文試圖就上述的這兩大方面的內容，從以下三個角度進行了初步研究： 1 、縱槽向抗震性能分析1 ）湯峪河吊桿拱支承結構的縱槽向地震效應較小；吊桿式拱架結構動力特性取決于槽墩和主拱圈的剛度，以及結構的整體性，故適當加大構件截面尺寸或提高砼標號，盡量降低結構的建築高度和重心，在構件連接和變截面處增設梗脅，按照約束混凝土的要求來加強箍筋的配置，增加砼的延性，以克服地震時構件連接和變截面處的應力集中造成的坡壞，並吸收大量的地震能量，從而起到隔震，減震的效果。
  6. Standard test method for transverse tensile properties of hoop wound polymer matrix composite cylinders

    環箍繞制的聚合物基體合成材料圓筒的橫向抗拉性能的標準試驗方法
  7. Standard test method for transverse compressive properties of hoop wound polymer matrix composite cylinders

    環箍繞制的聚合物基體合成材料圓筒的橫向抗壓縮性能的標準試驗方法
  8. Rolling stock. marking of wheels and tyres

    鐵路車輛.車輪和輪箍標記
  9. Diaphragm type chemical seal " quick coupling ", process connection : union nut or thread neck to din 11 851, sms -, idf -, apv rjt - norm or clamp

    快裝型膜片化學密封，過程連接：聯管螺母或din 11851 sms - idf - apv rjt -標準的螺紋頸或卡箍。
  10. At first, development of various cracks carefully recorded and strains on both the rebars and the stirrups were measured in detail, together with the deflections of the beam. in such a way, correlation between the measured strain profiles of the reinforcement and the observed cracking development of each specimen was pursued. principal factors contributing to the cracking pattern and failure mode were figured out as a result

    首先，通過單調靜力加載試驗研究，對梁的裂縫延伸和開展、縱筋應變、箍筋應變、梁的撓度等指標進行了細致的量測，試圖追蹤每一試件在裂縫發展及破壞過程中縱筋應變狀態的變化和裂縫發展程度的相關性，進而總結出有腹筋約束梁裂縫開展及鋼筋應力分佈的一般規律。
  11. Rolling stock. marking of the axles, wheels, tyres and wheels sets. definition of the marks

    鐵路車輛.車軸輪輪箍和輪組的標記.標記定義
  12. Then the coupling beams with new reinforcement layout were made an inquiry into, and the improvement on the seismic behavior by coupling beams diagonally reinforced with a few rows in end regions was found out at last, based on the observations of the experimental phenomena and the analysis of the measurement result, and by the comparison of seismic behavior by making use of hysteretic response, ductility and energy dissipation behavior, a conclusion is presented : the code for design and construction of reinforced concrete high - rise structures ( the draft asked for advise hi 2000 ) ca n ' t ensure that the coupling beams have fairly good seismic ductility ; the result of improvement of the seismic ductility of the coupling beams by the increase hi stirrups besides the strengthen of longitudinal detailing reinforcement was n ' t obvious ; the coupling beams diagonally reinforced with a few rows in end regions have fairly good mechanisms, and the ductility and the behavior of energy dissipation are better than conventionally reinforced concrete coupling beams, so it is suitable to te tised in short coupling beams

    本文通過對三根小跨高比（均為l h = 1 . 0 ）剪力墻洞口連系梁在低周反復荷載作用下的試驗，了解了嚴格按《鋼筋混凝土高層建築結構設計與施工規程》 （ 2000年徵求意見稿）設計的連梁具有的抗震性能，研究了採取增大連梁配箍量同時加強縱向構造筋的方案對抗震性能的影響，並進一步對新的配筋形式的連梁進行了探討，了解了在連梁梁端配置多排交叉斜筋方案對連梁抗震性能的改善。通過對試驗現象的觀察和量測結果的分析，利用荷載?位移滯回曲線、延性和耗能性能等指標對各個試件的抗震性能進行了比較，最後得出結論： 《鋼筋混凝土高層建築結構設計與施工規程》 （ 2000年徵求意見稿）不能保證小跨高比連梁具有較好的抗震延性：通過增大連梁配箍量同時加強縱向構造筋的方案對改善連梁的抗震延性的效果不太明顯；梁端配置多排交叉斜筋的連梁具有相對較好的受力性能，其延性和耗能性能等各項性能指標均優于普通配筋連梁，宜在深連梁中採用。
  13. In order to determine the relations between the four main bond - anchoring factors - concrete strength, concrete cover thickness, steel shape embedment length and the ratio of the transverse hoops - and the bond strength, and establish the bond - slip constitutive relations, 16 standard push - out test specimens were designed, and 4 comparison specimens were additionally designed to find the difference of the bond performance between the web, inside and outside of flanges the steel shape

    設計了16個型鋼混凝土標準推出試件，以考察混凝土強度、型鋼的混凝土保護層厚度、型鋼埋置長度及橫向配箍率四個主要錨固條件與粘結強度的相互關系和型鋼混凝土粘結滑移本構關系；設計了4個對比試件，以考察型鋼翼緣內側、外側和腹板與混凝土粘結性能的區別。
  14. Wall ties. recommendations for design of wall ties

    墻腰箍.第2部分:墻腰箍設計的推薦標準
  15. Cigar band paper

    雪茄煙標箍用條紙
  16. The auction closes on may 12

    開標是臺票三萬箍。
  17. The objective function is the cost of anti - slide pile " s per meter ; the constraint conditions are the strength of anti - slide pile " s normal section and inclined section, the ratio of reinforcing design and the size of section in the design code ; the design variables are the height of section, the area of reinforcement and the amount of hoop. and the optimization model is solved by 0. 618 method

    本文提出的優化設計方法，以樁單位長度的總造價為目標函數，以規范對單筋梁的正、斜截面強度，配筋率及截面尺寸等要求為約束條件，以樁截面高度，抗彎縱筋面積，抗剪箍筋數量等為設計變量，來建立優化模型，並用0 . 618法進行求解。
  18. 2. the suffering failure of columns within yield hinge regions and classified standard are expressed in detail to end the confusion of expression and application in the subject area in china

    從混凝土及箍筋應力水平等條件出發，提出縱筋屈服后框架柱破壞形態的分類標準；縱筋屈服后框架柱破壞形態可分為彎曲破壞及彎曲剪切破壞等形式。
  19. Standard specification for labeling and marking of cuffed and uncuffed tracheal tubes and related treatments intended for use during laser surgery

    激光外科學用套箍和未套箍氣管導管及有關治療的標記和標志的標準規范
  20. The specimens of rpc filled in steel tube short columns were studied, and their characters of deflection were analyzed. the tested cures of loading - displacement relationship of rpc filled in steel tube short columns were given and the characters were discussed. a formula for predicting the ultimate bearing capacity of rpc filled in steel tube short columns under axial compression was derived from the limit equilibrium method

    分析了鋼管活性粉末混凝土短柱的變形特點，模擬了鋼管活性粉末混凝土結構的三種加載方式，探討了該組合結構的工作機理，分析了試件受荷時的變形特點，給出了試件的實測荷載-變形曲線，並分析了套箍指標、加載方式等對鋼管活性粉末混凝土軸心受壓時的荷載-變形曲線的影響。
分享友人
分享到 Line

分享到臉書