管子與接頭 的英文怎麼說

中文拼音 [guǎnzijiētóu]
管子與接頭 英文
pipe and joints
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  • : 子Ⅰ名詞1 (兒子) son 2 (人的通稱) person 3 (古代特指有學問的男人) ancient title of respect f...
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • 管子 : [工業] tube; pipe; valve管子安裝 pipe installation; 管子扳手 bulldog wrench; 管子鋼 tube steel; ...
  • 接頭 : 1 (連接起來) connect; join; joint 2 (找人聯系) contact; get in touch with; meet 3 (了解情況...
  1. Pipe joints and elements for high density polyethylene pressure pipelines, types 1 and 2 ; pipe bends for butt - welding, dimensions

    1型和2型高密度聚乙烯壓力道用零件.對焊
  2. Pipe joints and elements for high density polyethylene pressure pipelines, types 1 and 2 ; injection moulded elbows for socket - welding, dimensions

    1型和2型高密度聚乙烯壓力道用零件.承插
  3. Pipe joints and elements for high density polyethylene pressure pipelines, types 1 and 2 ; injection moulded tee pieces for socket - welding, dimensions

    1型和2型高密度聚乙烯壓力道用零件.承插
  4. Mass spectrometry of synthetic hw - ma and rgd - hw are in full agreement with those speculated theoretically, which proves the success of peptide synthesis and refold. on isolated mouse phrenic nerve - diaphragm preparations, hw - ma can block the neuromuscular transmission in 35 minutes or so ( l 10 - 5 g / ml ), its biological activity shows 73 % decrease comparing with biological activity of native hwtx - i. it proves t hat the protein engineering of synthetic chimera hwtx - i has gained success to some extent, although it did not achieve our expectations. thus it proved that hwtx - i can be using as natural scaffold for protein engineering. and also emphasized the importance of " local stereo circumstances " of activity site when the foreign activity site was transferred into a natural scaffold

    濃度為1 / 1059 / ml的hw一ma突變體能可逆阻斷小白鼠隔神經書高肌的傳遞,阻斷時一間為35min左右,天然hwtx一i比較,生物學活性下降3一4倍,說明合成的突變體改造獲得了一定的成功,盡我們預期的目標有一定的差距,從而證明hwtx一i可以作為蛋白質工程研究的天然分骨架,同時也強調了往天然分骨架中轉移外源活性位點時維持活性位點「局部立體環境」的重要性。
  5. In this article, after the analysis of the type of the joint between the tube and tubesheet and relevant factors, the key stage in the fabrication and appropriate method for controlling the quality of the joint were presented

    通過分析換熱器型式及相關要素,提出了製造過程中的控制環節、控制方法。
  6. The squad leader sucks from a tube inside his helmet that connects to a water pack hanging from his back

    班長用盔內的吸吸了幾口水,這根懸掛在他背上的水袋相連
  7. Abstract : the paper presents a theoretical study on the thermal conductivity of frost formation on cooled flat plate under forced convection. taking the porous meditum as a physical model of frost layer, according to the theories of heat and mass transfer, the formula on heat conductivty of frost formation is derived

    文摘:研究水蒸汽凝華結霜過程在冷壁上形成的霜層的導熱系數,依據隨機多孔介質霜層模型,假設霜層是由孔隙空間冰晶骨架構成的多孔介質,其中孔隙空間由隨機毛細及連形成,濕空氣中的水蒸汽在霜層的孔隙空間中擴散輸運並凝華結霜,根據傳熱傳質學理論,導出霜層導熱系數關系式。
  8. It claims that taxation is a difficult point of electronic business, and points out fell main problems of taxation on the reference of methods of basic problems coped with electronic business by some international organizations and governments. on the base of this, it attempts to point out the basic clues of resolving the problems in commercial taxation of china today and our counter - measures and suggestions. and this can serve for the administration of taxation in china, promoting it to link with internation as soon as possible and become one of the strong countries, which is internationlization ineconomic information

    本文從分析電商務傳統商務相比較的現實優越性及發展電商務的基本條件入手,認為稅收問題是電商務的難點;並通過借鑒國際組織和各國政府對電商務稅收問題的基本處理作法,進一步提出電商務中的幾個主要稅收問題;在此基礎上,通過借鑒國際上對電商務稅收問題處理的基本經驗和作法,試圖提出解決現階段我國電商務稅收問題的基本思路和應採取的對策建議,以期使我國稅收理盡快國際相軌,迎趕上國際經濟信息化發展的新浪潮。
  9. Pipe joints and elements for high pressure polyethylene pressure pipelines, types 1 and 2 ; turned and pressed reducing sockets for butt - welding, dimensions

    1型和2型高密度聚乙烯壓力道用零件.對焊
分享友人