管形閥 的英文怎麼說

中文拼音 [guǎnxíng]
管形閥 英文
tube valve
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  • : 名詞1 (指在某方面有支配勢力的人物或家族) established house or power group; a powerful person or...
  1. Cleanup corrosive substance in pipe such as internal water, clean oil, methane hydrate, ferric oxide, carbide dust, carbon bisulfide, hydrosulphurice acide, etc. ; reduce corrosion damages to inner wall of pipeline caused by corrosive substance ; clarify pipe route again ; inspect pipe deformation ; check perfectness ratio of valves along pipe ; decrease working backpressure

    清除線內部積水、輕質油、甲烷水合物、氧化鐵、碳化物粉塵、二硫化碳、氫硫酸等腐蝕性物質;降低腐蝕性物質對道內壁的腐蝕損傷;重新明確線走向;檢測線變;檢查沿線門完好率;減小工作回壓。
  2. Needle valves have nps / internal pipe threaded ends

    配置nps內螺紋連接埠。
  3. Note : when valve is installed above a horizontal line or on a vertical line, on steam service, equalizer pipe must have a water seal loop

    注:如果在蒸汽應用場合,門安裝在水平道的上方或在垂直道上,則必須配置平衡成水密封迴路。
  4. Flanged wall valves, at right angles, for controlling gas appliances, with tapered rotating section, for built - in brass piping and with g 1 2 connection

    煤氣控制裝置.裝配式黃銅路和連接節的錐轉動截面帶法蘭直角壁
  5. Stem : the tee - head disc - stem connection prevents lateral strain on the stem for smooth, easy operation. accurately cut threads engage the yoke sleeve for positive control of disc position

    桿: t瓣-桿連接防止施加在桿側面的應力,確保操作平穩順暢容易。軛架套準確的螺紋連接有助於瓣位置的調整控制。
  6. Graphical symbols for piping systems - valves and control regulation actuators

    路系統的圖符號門和控制元件
  7. Note : when regulator is installed above the line or in a veritcal line on steam service, the control pipe must have a loop to form a water seal to prevent steam from contacting the diaphragm

    注:在蒸汽應用中,如果調節安裝在道的上方或安裝在垂直道上,則控制道必須有一個迴路,以成水密封,防止蒸汽接觸隔膜。
  8. Body ? streamlined flow path minimizes pressure drop. butt weld, venturi or flanged ends provide piping alternatives

    體?流線流道,最大限度減少壓降。對焊、縮喉或法蘭連接埠幾種可供選擇的連接方式。
  9. Valves for domestic water supply ; tapered union nipples nominal pressure 10 ; survey

    家用供水道的門.公稱壓力10的錐子接頭.概述
  10. Gravity ball check valves are converted to foot valves by replacing the union nut and end connector on the receiving end ? seat end ? of the body with an f. v. screen housing assembly

    重力球止回可以變為底,只需在接受埠-體的座埠,用一個f . v .濾網殼組件更換接頭螺母和埠連接件即可。
  11. Conical seating at an angle to flow is self aligning, tight and always closed in a no - flow situation. even in vertical ( flow - up ) pipe runs, this valve provides exceptionally tight shutoff

    圓錐座與流向具有一定的角度,能夠自行調整,在無流體狀態下能夠始終緊密關閉。甚至在垂直(流向朝上)道上,這種門具有特別緊密地關閉特性。
  12. Open needle valve " a " high side and vent needle valve to vent air from bypass hose

    開啟針「 a 」高端和排氣針,從旁路軟排放空氣。
  13. Flanges and their joints. circular flanges for pipes, valves, fittings and accessories, pn designated. part 2 : cast iron flanges

    法蘭及其連接.按pn標識的接頭和附件的圓法蘭.第2部分:鑄鐵法蘭
  14. Flanges and their joints - circular flanges for pipes, valves, fittings and accessories, pn designated - copper alloy flanges

    法蘭及其連接件.標注pn的門配件和附件用圓法蘭.銅合金法蘭
  15. Flanges and their joints - circular flanges for pipes, valves, fittings and accessories, class designated - copper alloy flanges

    法蘭及其連接件.標注等級的門配件和附件用圓法蘭.銅合金法蘭
  16. Flanges and their joints - circular flanges for pipes, valves, fittings and accessories, pn designated - aluminium alloy flanges

    法蘭及其連接件.按pn標注的門配件和附件用圓法蘭.鋁合金法蘭
  17. Flanges and their joints - circular flanges for pipes, valves, fittings and accessories, class designated - aluminium alloy flanges

    法蘭及其連接件.標注等級的門配件及附件用圓法蘭.鋁合金法蘭
  18. Flanges and their joints - circular flanges for pipes, valves, fittings and accessories - part 1 : steel flanges, pn designated ; german version en 1092 - 1 : 2001

    法蘭及其連接件.門配件和附件用圓法蘭
  19. Connect bypass hose between vent needle valve and loosely connect to test cock no. 1

    在排氣針上連接旁路軟,並將其鬆散連接到測試旋塞1號上。
  20. Install a needle valve in the control line. if uneven pressure should cause the regulator to pulsate, its action can be stabilized by throttling the valve

    在控制線上安裝一個針。如果不穩定的壓力導致調節波動,則這種波動通過對門節流將穩定下來。
分享友人