節流閥組 的英文怎麼說

中文拼音 [jiéliúfázǔ]
節流閥組 英文
multiple-valve septum
  • 節 : 節構詞成分。
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 閥 : 名詞1 （指在某方面有支配勢力的人物或家族） established house or power group; a powerful person or...
  • 組 : Ⅰ名詞1 （由不多的人員組成的單位） group 2 （姓氏） a surname Ⅱ動詞（組織） organize; form Ⅲ量詞（...
  • 節流 : 1. （節省經費開支） reduce expenditure 2. [工業] orificing; choke; throttle down, throttle back; throttle
  1. The components of this system are a cross - flow finned - tube evaporator, cross - flow finned - tube gascooler, a reciprocation compressor, a gas - liquid seperator, a double pipe internal heat exchanger and a throttling valve

    系統由一個叉流翅片管式蒸發器、一個叉流翅片管式冷卻器、一臺往復式壓縮機、一個氣液分離器、一個套管式回熱器、一個節流閥組成。
  2. The improvement system is made up of the pressure sensor, flow sensor, displacement sensor, electro - hydraulic proportional flow control valve, power amplifier, data gathering board and computer. the platform can carry out testing the hydraulic parameters, processing the tested data, saving the processed data and drawing, adjusting the pressure automatically

    改造后的測控系統主要由壓力傳感器、流量傳感器、位移傳感器、比例節流閥、功率放大器、數據採集卡和計算機組成。改造后的實驗臺具有自動採集實驗數據、自動處理實驗數據、自動保存實驗數據、自動調節液壓系統負載壓力等功能，大大提高了實驗臺的工作效率、測試精度和智能化水平。
  3. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況，在回顧電梯液壓控制系統節能技術的基礎上，介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能控制系統研究」的基本原理，分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式；詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計，重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成控制閥組的設計等內容；最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。
  4. Straight moving type relief valves, mainly valve disc, valve body, spring - loaded, roof, regulation pole, conditioning nut, and other integral parts

    直動型溢流閥，主要有閥芯、閥體、彈簧、上蓋、調節桿、調節螺母等零件組成。
  5. The secondary combustion, which has better controllability, and plays the most pivotal role on the overall performance of a strutjet, so the paper detailedly studied and analyzed the mechanism of fuel ' s atomization, the mechanism of fuel ' s spray burning, vital spray burning models and the combustion ' s controllability, combined with the author ' s practical investigation in the rbcc lab, finally, the author got a most simple and feasible method to control the spraying burning of liquid kerosene - - to set up an adjusting valve in the fuel pipeline

    文中重點對燃油的霧化機理、燃油的噴霧燃燒機理、主要的燃燒模型和燃燒過程的可控性，展開了詳細地分析研究，並結合在rbcc實驗室的實際研究，獲得了對燃油噴霧燃燒進行調節的最簡單、可行的方法，即在燃油管路上設置流量調節閥。於是燃燒組織問題轉化為對該調節閥的開度如何施加適當控制的問題。
  6. This paper analyzes the steady - state characteristic of the two main components of the water hydraulic proportional throttle valve including slide valve and proportional solenoid, and analyzes the whole valve ’ s steady - state characteristic also

    論文分析了水壓比例節流閥的兩個主要組成部分? ? ? ?節流滑閥和比例電磁鐵的穩態特性，並對水壓比例節流閥整體的穩態特性進行了分析。
  7. Constant gas flow control box is composed of pressure stabilizing valve, pressure meter, flow control valve and flowrator, gas contain and regulating valve and so on

    恆氣流控制箱由穩壓閥壓力表流量控制閥和轉子流量表氣容和調節閥等組成。
  8. Its role to regulating valves and flow - combination hole equivalent to the slip road to the flow distribution requirements

    其作用相當于調節閥和等效孔板流量儀的組合，使各個支路的流量分配達到要求。
  9. Zt - b series welding type vacuum flow regulating valve fulfills the flow adjustment purpose by changing the size of the pipeline inner sectional area

    Zt b型系列焊接式真空流量調節閥是改變管道內截面積大小達到調節流量目的。適用溴化理冷熱機組管道。
  10. Combination flow regulator

    組合式流量調節閥
  11. The heatn0t p8rt is made up of the first nct and the second nat. by regulatng the valve of the first - net water - supply pipe, we can chmp the flux in the firstnet watersupply pipe in order to guaramee the supplied watcr ' s temperature of the second - not. in this text, according to the analysis of heat - supply condition of our country, we adopted the disttibute type and concentratc control of " suppleness cotltrol " system

    世界上比較成熟的供熱模式有前蘇聯模式和東歐模式，我國結合自己的實際國情，大部分城市集中供熱系統採用仿東歐模式，整個供熱系統由由熱源和熱網兩個部分組成，熱源為熱電廠供熱，熱網部分保證熱量的均勻分配，熱網又分為一次網和二次網，通過調節一次網供水管的調節閥，改變一次側的供水流量，從而保證二次側的供水溫度。
  12. This valve is a combined regulating and flow measurement device and must be installed with five diameters of straight pipe of the same nominal diameter as the valve and without intrusions upstream of the valve

    這種閥門是一種調節和流量測量的組合裝置，必須安裝在與閥門公稱通徑一致的直線管路，長度為五倍直徑的位置，使得閥門上游不會受到侵擾。
分享友人
分享到 Line

分享到臉書