節電開關 的英文怎麼說

中文拼音 [jiédiànkāiguān]
節電開關 英文
battery-conserving switch
  • 節 : 節構詞成分。
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 關 : Ⅰ動詞1 （使開著的物體合攏） close; shut 2 （圈起來） shut in; lock up 3 （倒閉; 歇業） close down...
  • 節電 : economize on electricity; save electricity; dimout
  1. Pre - data gathering module achieves the collection and communication of sixteen - route temperature signal. speed measuring and controlling module realizes the control of refolw soldering transfer speed by manipulating transducer. on - off outputting module fulfills calefaction control of calefaction tube by solid state relay. above position operator software programs by delphi, and realizes pid parameter automatic timing and no - oversnooting temperature control. software has friendly interface, convenient operation, complete functions

    前置數據採集模塊完成16路溫度信號的採集和通訊；速度測量模塊與速度控制模塊通過控制變頻器來調節迴流焊的傳輸速度；開關量輸出模塊通過固態繼電器對加熱管進行控制；上位機軟體採用delphi編程，實現了pid參數自整定以及無超調的溫度控制。
  2. The load current is handled directly by the controller through semiconductor switching devices.

    負荷電流由調節器通過半導體開關元件直接控制。
  3. This paper presents a method that chopping wave is done by switch devices which consist of three - level resistance regulating module and intelligence power module ipm, and which realizes constant - current discharge of storage battery. to achieve the intelligence control of the drive protection and the discharge process of ipm, the paper designs circuit formed by igbt threshold drive pulse pwm signals. ipm fault - blocking protection circuit and microcomputer 80c196. the devices can accurately control the 0 ~ 150a discharge current and the discharge time of the storage battery and calculate the releasing power

    實現蓄電池恆流放電過程智能控制是蓄電池放電裝置發展的必然趨，本文提出了一種通過三極電阻調節模塊和由智能功率模塊ipm為開關器件進行斬波從而實現蓄電池恆流放電的方法。為達到對ipm的驅動保護和放電過程的智能控制，文中設計了igbt門極驅動脈沖pwm信號形成電路和ipm故障封鎖保護電路及由單片機80c196為核心的微機控制器。本裝置能夠對蓄電池進行0 150a放電電流及放電時間的精確控制及釋放容量的計算。
  4. In power system full dynandc simulation software, the adndttance matrixes of fault branches are adopted in the fault models to simulate arbitrary symmetrical and unsymmetrical faults, by use of contraction technique for adndttance matrix the multi - faults and the randomly occurred faults can be processed. the feature of this method is that the arbitrary multi - fault occurred in a branch can be simulated without any additional branches or buses to be added, thereby, the ca1culation efficiency and the expedience of usage are improved

    本文提出採用故障支路導納陣處理復故障計算，該演算法可以對一條支路發生任意重故障進行處理，而不需要增加支路或節點，克服了目前常用的電力系統機電暫態程序在處理復故障時，一般要按照事先預想的故障類型以及故障和操作發生的位置增加新的節點和小開關支路的問題。
  5. Our main products are micro barometer low pressure gauge low pressure capsule gauge vacuum pressure with low pressure gauge pressure gauge with electrical contact shock - proof electric contact gauge stainless steel pressure gauge dry and glycerin filled pressure gauge normal pressure gauge freon pressure gauge oxygen - acetylene pressure gauge stainless steel vacuum pressure gauges series diaphragm seal pressure gauge diaphragm pressure gauge with electrical contact pp diaphragm seal pressure gauge shock - proof pressure gauge with electrical contact diaphragm seal pressure gauge explosion - proof electric contact pressure gauge minitype pressure gauge accurate pressure gauge test pressure gauges as well as pressure gauge switch pressure separator tube pressure gauge radiator double - metal thermometer all the products can meet both national and international stands,

    一般壓力表氣壓表抗震壓力表充油壓力表全不銹鋼壓力表膜盒微壓表電接點壓力表冷媒壓力表真空壓力表壓力真空表隔膜壓力表微型壓力表差壓表微差壓表絕壓表精密壓力表耐高溫壓力表蒸氣壓力表汽車燃氣壓力表醫用壓力表遠傳壓力表衛生型壓力表壓力表緩沖管壓力表冷凝散熱器壓力表翅片散熱器壓力表開關不銹鋼連接彎管不銹鋼連接軟管轉換接頭油壓連接頭壓力表針閥節流閥及過壓保護附件濾油網加油口油溫油麵計雙金屬溫度計等。
  6. With the stringent requirement of low output voltage and high output current, semiconductor diode is necessarily replaced by synchronous rectifier to minimum voltage drop. because the existed driving schemes can not drive srs properly, two novel driving schemes for synchronous rectifiers in magnetic amplifier post regulating circuit are proposed in this paper

    已有的同步整流管驅動電路主要面對多路輸出的主輸出電路，而應用磁放大器調節的輔助輸出電路同步整流管的驅動，現有的方法存在磁放大器調節與同步整流管驅動的失配，降低了開關電源的效率。
  7. Based on the thorough investigation of the post - regulation and efficiency in multiple output switching - mode power supplies, an optimal combination topology for multiple output switching converter is presented in this thesis, which is consisted of forward converter with active clamp ( fac ), synchronous rectification ( sr ) techniques and magnetic amplifier technique ( magamp )

    本文通過研究分析近年來多路輸出開關電源輔助輸出電壓調節和提高效率的方案，面對開關電源朝著輸出低電壓大電流方向發展的趨勢，提出多路輸出開關電源新的拓撲優化組合模式? ?有源鉗位正激變換器、同步整流技術、磁放大器。
  8. If you turn down the volume level of the amplifier too low, the auto power on / off function may activate, causing the subwoofer to enter power saving mode

    您如果把放大器的音量電平調得太低，自動電源開關功能即可能會被激活（打開） ，而使副低音揚聲器進入節電模式。
  9. The environment - preserved and high efficient power switch design not only saves energy but completely solve the problem of ac noise interference

    綠色環保、高效的開關電源設計，既節能，又徹底解決交流聲噪音干擾問題。
  10. For a class of series - wound active power line conditioner the design approach law of a new fuzzy integral sliding mode variable structure control is presented. this method adjusts power electronic switch in order to achieve anticipated balance volt, finally makes active power line conditioner not only possess good robustness of variable - structure control and decrease vibration to the most but also increase the steady state precision. series - wound aplc adopted this control method possesses good dynamic and steady state performance

    針對串聯型有源電網調節器運用變結構控制策略，調節電力電子開關模式，以獲得預期的平衡電壓，對串聯型有源電網調節器提出了模糊積分變結構控制方法，使串聯型有源電網調節器既保持了常規滑模控制強魯棒性的優點，又減弱了滑模控制的抖振，提高了系統的穩態精度，使系統具有良好的動態和靜態性能，模擬試驗表明該控制策略是一種十分有效的控制方法。
  11. Firstly. operation principle of induction heating is introduced and the actuality of the power supply for induction heating is summarized. then, the scheme of structure of the power supply is established : uncontrolled rectifier and buck chopper constitute dc circuit. in this part, operation principle of a kind of soft switching buck chopper is presented mainly and the conclusion that the power semiconductor devices operate in soft switching is also illustrated by analysing the operation principle of all stages ; series resonant inverter is selected as inverter circuit via comparing the advantage and shortcoming of parallel resonant and series resonant. moreover. the work principle of series resonant inverter is analysed and the calculating method of the best dead time is put forward as well

    文中首先介紹了感應加熱電源的工作原理並綜述了國內外的研究現狀。接下來分析並制定了電源主電路的構成方案：在對比幾種功率調節方式的基礎上選擇了不控整流加斬波調壓作為直流部分。在這部分里，重點研究了一種軟開關buck變換器，通過分析各階段的工作原理說明了開關器件如何工作在軟開關狀態；對于逆變器部分，在比較了串、並聯逆變器優缺點的基礎上選擇了串聯諧振逆變器，並詳細分析了串聯逆變器的工作原理，提出了最佳死區的計算方法。
  12. Voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  13. Abstract : voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    文摘:採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  14. Switches for appliances - part 2 - 4 : particular requirements for independently mounted switches

    電器開關.第2部分第4節:針對獨立安裝開關的特殊要求
  15. According to the request of the standard in electric industry in china named " on line check and test rules of analog and digital control system of power station ", every system is tested, and according to technological guides and operation rules, static and dynamic trial are required to be done, the quality of adjust, and response time also adapt to the requirement

    機組整套試運以後，各控制系統逐步投入。依據中華人民共和國電力行業標準《火力發電廠模擬量、開關量控制系統在線驗收測試規程》的要求進行測試，並按照技術指標及運行導則要求均做過靜態、動態特性試驗，調節品質、響應時間均符合要求。
  16. After the construct of the motion simulation model, genetic algorithm is used to do the adjustment of pid parameters of the control system of the joint motors, integral separation pid control and angle error analysis is finished, and three force / torque sensors, touch sensors, distance sensors and photoelectric switches are calibrated and installed

    在建立了機器人關節控制系統模型后，使用遺傳演算法對其關節電機控制系統進行pid參數整定，進行機器人關節的積分分離的pid控制策略和轉角誤差的理論分析，並進行了機器人三維力/力矩傳感器、接觸傳感器、測距傳感器和光電開關的標定與安裝。
  17. Electromechanical switches for use in electronic equipment ; part 4 : sectional specification for lever toggle switches ; section 1 : blank detail specification ; identical with iec 61020 - 4 - 1 : 1991

    電子設備的機電開關.第4部分:閘刀開關分規范.第1節
  18. Electromechanical switches for use in electronic equipment - part 6 : sectional specification for sensitive switches - section 2 : detail specification for one pole, unsealed subminiature sensitive switches, 250 v maximum, 5 a maximum electrical rating

    電子設備用的機電開關.第6部分:敏感開關分規范.第2節:額定最大電壓250v ，最大電流5a的單級不密封超小型開關的詳細規范
  19. According to research by energy star, if every american home replaced just one light bulb with a compact fluorescent bulb, we would save enough energy to light more than 2. 5 million homes for a year and prevent greenhouse gases equivalent to the emissions of nearly 800, 000 cars

    讓冰箱遠離陽光和暖氣出風口，並打開恆溫器旁邊的省電開關及清理冷凝管，這些訣竅將有助於節省能源，同時有益於環保。
  20. The power adopt pwm switch technic design, it compose of professional ic, and high reliability

    本電源採用脈沖寬度調節（ pwm ）開關技術設計，由專業積體電路組成，可靠性高
分享友人
分享到 Line

分享到臉書