粗度曲線 的英文怎麼說

中文拼音 [cūdùqūxiàn]
粗度曲線 英文
roughness curve
  • 粗 : Ⅰ形容詞1 （長條東西直徑大的） wide （in diameter）; thick 2 （長條東西兩長邊的距離寬的） wide （i...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  1. Comparing with the neutral cave on the smooth plane that was thumb - like and opened at the bottom, the neutral caves on the plane with single roughness elements were closed circles. with the growing of roughness element s height, the closed circle became smaller

    實驗中發現與光滑平板邊界層的下端開放式的拇指型中性曲線相比較，有粗糙元平板的中性曲線為封閉式的環形曲線，隨著粗糙元高度的進一步增加中性曲線收縮為更小的閉合環。
  2. Which contrast you create, the length of the ascenders and descenders, the rhythm, the blackness of a type, the strength of the curves and the bowls, etc

    例如採用怎樣的粗細對比，上伸部和下伸部的長度，字體的節奏，黑度，曲線和字碗的力度，等等。
  3. Worn surfaces of sliding pairs were characterized by scanning electron microscopy ( sem ). chemical compositons on the worn surfaces were analyzed by energy dispersion x - ray analysis ( edax ), and profiles and suface roughness of the worn surfaces were measured by stylus profilmetry

    用掃描電子顯微鏡（ sem ）對磨痕表面形貌進行了分析，用能量色散x射線分析（ edax ）對磨痕表面進行化學成分分析，並用表面輪廓儀測定了磨痕表面粗糙度和磨痕表面輪廓曲線。
  4. Standard test method for measurement of vehicular response to traveled surface roughness

    測量車行道路面粗糙度的行車響應曲線的標準試驗方法
  5. By using the aperture curve and roughness curve, the author of the dissertation has put forward the concepts of frequency hydraulic aperture and frequency roughness for the first time. of the two concepts, the first or frequency hydraulic aperture has got some advantages of its own in the seepage analysis

    3 、本文首次利用寬配和糙配曲線，提出頻率隙寬和頻率粗糙度的概念，特別是頻率水力隙寬的提出，為解決現有隙寬應用中出現的局限性具有極大的幫助作用。
  6. It is validated that the numerical methods can absolutely predict the flow in the microchannels. the flow field around the roughness and the pressure drop of midline along flow direction are analyzed. it ' s found that the range of the pressure drop change relate to the magnitude of relative roughness, the distance between two parallel planes, the re number and ratio of the size of roughness and the distance between two roughness

    通過對粗糙元周圍流場和充分發展段中心線壓力曲線的分析，發現有粗糙元存在的兩平行平板間微通道，其充分發展段壓降大於光滑平板充分發展段壓降；當相對粗糙度和re不變時，隨著板間距的減小，粗糙度對主流的影響不斷增大；當板間距和相對粗糙度不變時，在層流狀態下，粗糙度對流動的影響不隨re的變化而變化；當板間距和re保持不變時，相對粗糙度越大，其對流動的影響就越大。
  7. Technology of non - damage test for concrete intensity is extensively applied in project testing, as a precise and direct approach. accordingly, the test in this essay makes use of average concrete samples made up of commo - n raw material in boutou, and adopt comprehensive method of ultrasonic elasticity to test the concrete used within one year in boutou. through the regression analysis, we get the regression equation of anti - intensity of these two materials under the given conditions. according to the result, we establish the accurate curve line for comprehensive method of ultrasonic elasticity and provide practiced and non - damage testing approach and calculating method for concrete intensity test and reference for testing staff concerned

    混凝土強度無損檢測技術作為一種簡便快捷準確的測強技術在工程檢測中得到了廣泛的應用，鑒於此，本次試驗通過採用包頭地區常見原材料製成的一定批量常見齡期的不同種類（指混凝土試塊中的粗骨料、混凝土強度等級不同）普通混凝土標準試塊，採用回彈?超聲綜合法對包頭地區齡期不超過一年的現場混凝土進行了大量的試驗，並利用回歸分析，給出兩種骨料混凝土在相應測強條件下的立方體抗壓強度回歸方程，根據實驗結果建立包頭地區精度較高的混凝土回彈?超聲綜合法基準測強曲線，為實際工程的混凝土現有強度評定提供簡單易行的無損測試方法和計算方法，供有關檢測人員參考使用。
  8. The paper has made a comprehensive study to marine carbonate oolitic reservoir in triassic of feixianguan group of intra - platform taphrogenic trough basin in north - east past of sichuan basin. according to the principle of high resolution stratigraphic sequence, combined with original results gained form the area, the author have built up the base level cycles and fades model of different stages based on the surface identification mark of base level cycle using the information of geology, seismic, logging, core and outcrops

    1 、依據層序地層學高解析度基準面旋迴原理與識別技術，建立了裂陷槽向上變淺直至露出水面過程中形成的基準面旋迴變化的7種特徵性識別標志，包括泥巖表面乾裂、淡水選擇性溶蝕、白雲化現象、白雲巖、石膏、伽瑪曲線高值、向上變厚、變粗序列、向上變細、變泥、變紅序列、向上值變低序列等。
  9. These means have following defects : i. parameter controls is too simple that will fit the curve too roughly and can ’ t give the configuration and characteristic of surge curve very good ; ii. the performance curve will change a lot when working condition changes, especially when woring temperature changes ; iii. choking area will bring huge waste and is an area that the system oughts to avoid, but we haven ’ t corresponding methods to watch and control it in the domestic till now

    這些措施具有以下缺點: 1 、控制參數過于簡單，對曲線的擬合過于粗糙，不能很好的反映喘振曲線的形態和特點; 2 、當工作條件變化時，特別是工作溫度有所變化時，性能曲線會發生很大變化; 3 、阻塞區會造成巨大的浪費，也是系統該避免的區域，可是目前國內還沒有相應措施來監控它。
  10. This thesis is not only discussing and analyzing mathematically the working principle of y type reflection fiber optic detector, but also deducing the fundamental calculating formula of reflection light intensity, and drawing the displacement - responding sensitivity curve. this thesis also points out the three characteristics curves corresponding to the detections in tiny displacement, biggish displacement, and superficial roughness. these are very creative and completely valuable in practicality

    按題目要求，論文對y型反射式光纖探頭的工作原理進行了初步探討和數學分析，推導出反射光的基本計算公式，繪出了位移- -響應靈敏度曲線，並指出y型反射式光纖探頭進行微小位移、較大位移、表面粗糙度測試時對應的三個特徵曲線段，具有創新之處和實用價值。
  11. Then, according to the established structure, the parameters of the optical switch were modeled and optimized. the thickness, roughness, verticalness of the mirror was analyzed and designed. finally, the rectangular magnetic material was selected for the electromagnet thirdly, the parameters were optimized by ansys software and the performance of the optical switch was analyzed

    首先根據電磁鐵的非線性特性和梁的抗彎曲力的線性特性，設計出磁力驅動懸臂梁式光開關結構，然後根據提出的結構，從理論上對懸臂梁的參數進行模擬分析選出合適的懸臂梁參數，緊接著分析平面鏡的厚度、表面粗糙度、垂直度對光開關性能的影響；最後對磁路系統，明確選擇具有矩形磁滯回線的材料，設計出電磁鐵的結構。
  12. An experimental investigation on the transition in the boundary layer of horizontal plane with and without single two - dimensional roughness elements has been carried out in the wind tunnel. the distribution in normal and stream - wise directions of intensity of t - s wave excited by vibrating beam was measured in every condition. neutral curves were obtained by measuring the growth of the t - s wave at the normal critical location along the stream - wise direction

    在風洞中對水平光滑平板以及加有粗糙元平板的邊界層轉捩進行了測量與研究，比較了不同情況下平板邊界層內由振動梁激勵生成的t - s波沿流向和法向強度的分佈規律，得到了相應的振型增長曲線以及中性曲線。
  13. On basis of experimental analysis, several conclusions can be indicated that : roughness of cement face or structural plane can be described well quantitatively with fractal dimension in paper. roughness increases inner friction angle and cohesive force, and transfers characteristics of shear deformation curve and mechanics and form of shear failure

    試驗研究及分析表明，文中方法確定的分維數可以用來較好的定量描述結構面或膠結接觸面的粗糙程度；粗糙度的存在，提高了膠結面的內摩擦角及凝聚力，改變了膠結面剪切變形曲線特徵及剪切破壞機理和形式。
分享友人
分享到 Line

分享到臉書