粘合劑混合料 的英文怎麼說

中文拼音 [niánhúnliào]
粘合劑混合料 英文
binder mix
  • : 粘動詞(粘附) glue; stick; paste; adhere to; bond
  • : 合量詞(容量單位) ge, a unit of dry measure for grain (=1 decilitre)
  • : Ⅰ名詞1 (藥劑; 制劑) a pharmaceutical or other chemical preparation 2 (某些有化學作用的物品) a...
  • : 混形容詞1. (渾濁) muddy; turbid2. (糊塗; 不明事理) foolish; stupid
  • : 名詞1 (材料; 原料) material; stuff 2 (喂牲口用的穀物) feed; fodder 3 (料器) glassware 4 (...
  • 粘合劑 : adhesie cement
  • 混合 : (攙雜在一起) mix; blend; mingle; admix; mixture; mix up; interfusion; commixture; blending; cre...
  1. In this paper, glycidyl ether, which was high epoxide value and low viscosity, was synthesized from 2 - trimethylene glycol, epichlorohydrin and the normal butyl alcohol by phase transfer catalyst based on the orthogonal experiment design

    摘要採用1 , 2 -丙二醇、正丁醇和環氧氯丙烷為原,在相轉移催化的作用下反應,通過正交實驗成了的高環氧值、低度的醇縮水甘油醚。
  2. Bituminous mixtures - test methods for hot mix asphalt - hot sand test for the adhesivity of binder on precoated chippings for hra

    瀝青.熱拌瀝青的試驗方法. hra用預塗瀝青碎石上性的熱砂試驗
  3. Sampling and examination of bituminous mixtures for roads and other paved areas - methods for determination of the condition of the binder on coated chippings and for measurement of the rate of spread of coated chippings

    道路和其他鋪砌區用瀝青的取樣與檢驗.測量塗石屑上條件和攤鋪率的方法
  4. The mainly work has : the relation of boron contents and the average liner burning rate, through which chooseing suitable boron contents in these delay compositions ; the impact of different particle diameters on delay characteristics, by the means of granularity classfication ; the impact on delay characteristics through pre - treatment to the raw materials and improvement of mixing means ; and some other factors, such as the pressure of charge, loaded times, the charge mass of delay composition ; at last, the mechanical intensities of boron based delay compositions with some different binders

    主要的研究內容有: b含量與線性平均燃速的關系,並由此選用b含量適的延期藥;通過原材的細化與粒度分級,研究了粒度對延期性能的影響;原材預處理和藥方式對延期性能的影響;以及影響延期性能的其它因素,如壓藥壓力、壓裝次數、裝藥量等;最後還研究了含不同的硼系延期藥的壓藥藥柱強度(機械強度)等。
  5. Pavement bases - continous manufacture of mixtures - production control of granular materials and sands bound with cementitions binders or of untreated granular materials and sands in a continuous mixing plant

    路面基層.的連續生產.用結的粒狀材和砂石的生產控制或連續設備中未處理的粒狀材和砂石的生產控制
  6. Road testing. measurement of the rate of hydraulic binders and additives in the cementitious materials. part 1 : chemical method for the determination of the cement content in a new mixed material

    道路試驗.結性材中水壓和添加比率測量.第1部分:新中膠接含量測定的化學方法
  7. The grade composite, road performance and its mechanism are systemically studied. 1 ) the aggregate grade of ogfc is studied through the volume method base on the analysis of the aggregate grades. then the grade is verified and the relation between the grade and pore rate is studied statistically, the typical grades of ogfc are developed ; 2 ) the reasonable pore rate of ogfc is studied on the basis of the balance of mechanics and function performance ; 3 ) the mineral fiber is added to the ogfc mixes to increase asphalt content, thus the anti - water performance of ogfc mixes are improved ; 4 ) high viscous asphalt fit for the preparation of ogfc is prepared through composite modification by sbs and rubber powder ; 5 ) the mechanics mechanism of ogfc is studied in the paper, it shows : asphalt paste, as well as the coarse aggregate skeleton, is essential to the mechanics of ogfc

    在分析各國ogfc級配的基礎上,運用礦體積法進行ogfc級配設計,用正交實驗對礦級配進行了優化設計,運用數理統計方法分析礦級配和孔隙率之間的關系,並回歸出礦關鍵篩孔通過率與ogfc骨架空隙結構關系的數學方程,進而提出了ogfc的理級配;通過對不同孔隙率典型級配的性能研究,綜力學和功能性能,得出了ogfc的理孔隙率范圍:針對高速公路面層對ogfc力學性能方面的要求,本文從瀝青膠結材、纖維穩定兩方面對ogfc的性能進行改善:通過sbs和橡膠粉復改性的方法開發出了適ogfc的高度改性瀝青,摻加聚物纖維,提高ogfc的最佳瀝青用量,進而改善了的高溫性能和抗水損害性能,優化設計出能滿足高速公路路用性能,車轍動穩定度達5000次/ mm以上,動融劈裂強度比90 ,透水系數31ml / s ,並具有防滑降噪功能的開級配瀝青磨耗層( ogfc )
  8. Sanyuanyibing juancai rubber waterproofing, waterproofing juancai gonghun chlorination polythelene rubber, adhesives, paint & waterproofing manufacturing ; rubber runway, rubber processing

    三元乙丙橡膠防水卷材、氯化聚乙稀橡膠共防水卷材、、聚氨脂防水塗製造;橡膠跑道、膠管加工。
  9. Tpf. 1 : dtu 59. 2 - building works - work of thick plactic finishes over concrete or plaster based on hydraulic binders - part 1 : technical specifications

    Dtu 59 . 2 .建築工程.基於水凝凝土和灰漿的厚塑光飾
  10. Tpf. 1 : dtu 59. 2 - building works - work of thick plastic finisches over concrete or plaster based on hydraulic binders - part 1 : technical specifications

    Dtu 59 . 2 .建築工程.基於水凝凝土和灰漿厚的塑光飾
  11. 2 resin with bad wetness systems, and non - thixotrpic grind materials. operate as following process : add the paint material and the solvent - add surface active agent if adopt - add the pigment stir, make it disperse or grind to the needed granularity

    2對于非觸變性研磨性磨,潤濕性差的樹脂體系操作如下:加油漆和溶加入表面活化如果採用加入顏攪拌分散或研磨分散到所需細度加預凝膠攪拌分散至所需細度稀釋至所需度。
  12. Bituminous mixtures - test methods for hot mix asphalt - soluble binder content

    瀝青.熱瀝青的試驗方法.可溶含量
  13. Bituminous mixtures - test methods for hot mix asphalt - binder content by ignition

    瀝青.熱瀝青的試驗方法.燃燒法測定含量
  14. Bituminous mixtures - test methods for hot mix asphalt - part 39 : binder content by ignition

    瀝青.熱瀝青的試驗方法.第39部分:用點燃法測定含量
  15. 1 while use surface activator and disperse pigment, system can grow to be thixotrpic structure during stir. operate according to following steps : add the paint material and solvent then mix - add the organic bentonite powder, stir with 10 minutes - add the polar active agent, stir 5 - 10 minutes - add surface active agent - add the pigment, stir and disperse to the needed granularity - dilute to the needed viscosity

    當使用表面活化以及分散顏和攪拌下可發展觸變體系時,操作如下:溶和展色加入有機膨潤土粉末10分鐘加入極性活化攪拌5 - 10分鐘加入顏攪拌分散至所需細度稀釋至所需度。
  16. Tests relating to pavement. preparation of materials bound with cementitious binders or aggregates mixes. part 3 : fabrication in the laboratory of gravel or sound mixes for samples confection

    路面試驗.或集制備.第3部分:礫石或全實驗室制備
  17. Unbound and hydraulically bounds mixtures - part 49 : accelerated swelling test for soil treated by lime and or hydraulic binder

    鬆散的和液力.第49部分:用石灰和或液力結處理的土壤用加速膨脹試驗
  18. Products and systems for the protection and repair of concrete structures - granulometry analysis - test method for fillers for polymer bonding agents

    凝土結構的防護和修整用產品和系統.粒度分析.聚用填的試驗方法
  19. Standard test method for quantitative extraction and recovery of asphalt binder from asphalt mixtures

    從瀝青中定量萃取和回收瀝青的標準試驗方法
  20. Hydraulically bound mixtures - specification - part 5 : hydraulic road binder bound mixtures

    液力.規范.第5部分:液壓道路
分享友人