粘合態 的英文怎麼說
中文拼音 [niángětài]
粘合態
英文
bonding state-
On thebasis of describing mineralogy characteristics such as combination electron minro - form , crystallinity of clay minerals , the relationship between coal series clay minerals in themesozoic era in ningxia area and coal metamorphism was analyzed
在概述粘土礦物組合、電子顯微形態和結晶度等礦物學特徵的基礎上,探討了寧夏地區中生代煤系粘土礦物與煤變質的關系。Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )
體積電阻率的測定:當r _ v 10 ~ 8時,製成100 100 4mm板材,用zc36型高阻儀測量;當r _ v 10 ~ 8時,用dt - 9205b型數字式萬用表測試試樣的體積電阻,為了減小接觸電阻對測試的影響,採用銀導電膠將銅片粘接在試樣的兩個端面上,靜置24小時,待銀導電膠凝固,試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。Polybutadienes, epoxy resins, and similar polymers may be used while they are in the viscous or liquid state of prepolymerization.
聚丁二烯,環氧樹脂及類似聚合物在粘性狀或液體預聚態都是可用的。Binders for paints and varnishes - measurement of the dynamic viscosity of liquid resins ; resin solutions and oils by the capillary viscosimeter of isocelses type according to ubbelohde
塗料和清漆用粘合劑.液態樹脂動態粘度的測量.根據烏Bitumen and bituminous binders - determination of dynamic viscosity of modified bitumen - part 2 : coaxial cylinders method
瀝青和瀝青粘合劑.改良瀝青的動態粘度的測定.第2部分:同軸柱體法Bitumen and bituminous binders - determination of dynamic viscosity of modified bitumen - part 2 : coaxial cylinders method ; german version en 13702 - 2 : 2003
瀝青和瀝青粘合劑.改性瀝青動態粘度的測定.第2部分These characteristics and phenomenons have effect on the quality of gear pump, and it is difficult relatively to research them by theory. at present the research is limited to the phase of examination testing. theoretic research of the characteristics and the phenomenons of polymer gear pump are blank in china when the gear pump feeds the viscous polymer liquid of chemical flow with high temperature and high pressure
齒輪泵除具有流量和容積效率、扭矩和機械效率、功率和總效率等基本特性外,還存在著困油、噪聲和氣穴等現象,這些特性和現象直接影響齒輪泵的質量,對斜齒齒輪泵的這些特性和現象的理論研究難度較大,目前大多仍局限於實驗測試研究階段,而聚合物齒輪泵在輸送化工流程中的高溫、高壓的粘流態聚合物時特性的理論研究在國內基本還處于空白。Test method for adhesion of solid film lubricants
固態薄膜潤滑劑的粘合性的試驗方法Bonded abrasive products - static balancing of grinding wheels - testing
粘合磨料產品.砂輪的靜態平衡試驗Adhesives - determination of dynamic resistance to cleavage of high - strength adhesive bonds under impact conditions - wedge impact method
粘合劑.在沖擊條件下測定高強度膠粘劑耐動態劈裂性.楔形物沖擊法Apart from geochemists from western countries, which paid a particular attention on amorphous iron - manganese oxides extracted by enzyme or 0. 1 ~ 0. 25m nh2oh ? hc1, our results show that the extraction of metals adsorbed by clay and bound to the carbonate in soil is most useful to identify the concealed mineralizations in the semiarid and loess covered terrains, northern china
但與國外重點關注非晶質鐵錳氧化物如酶、鹽酸羥氨提取結果不同,在我國北方半乾旱黃土覆蓋景觀區,粘土吸附和碳酸鹽結合態金屬元素的提取為最有效的提取步驟。而游離態、有機結合態的提取效果則受景觀控制變化較大。Different from the existing cognition, the concentration of solvent should be much lower rather than higher when extracting the metals absorbed on clay minerals and bound to carbonates
與前人認識不同,進行可交換態(粘土吸附)和碳酸鹽結合態弱信息提取時,不是提高提取劑濃度,而是降低濃度。Adhesives - determination of dynamic resistance to cleavage of high strength adhesive bonds under impact conditions - wedge impact method
粘合劑.沖擊情況下高強度粘結點耐動態劈裂性能的測定.楔形沖擊法Standard test method for strength properties of tissue adhesives in t - peel by tension loading
通過拉伸載荷測定t形剝落狀態下組織粘合劑強度特性的標準試驗方法Standard test method for strength properties of tissue adhesives in lap - shear by tension loading
通過拉伸載荷測定搭接剪切狀態下組織粘合劑強度特性的標準試驗方法On the condition of high speed and high load, the worn surface of pam 1 / nylon 6 composites nearly melt and comparatively uniform transfer on the surface of steel is formed, which accounts for the rather low wear mass loss
高速高載時,尼龍6和剛性較小的pam2 /尼龍6復合材料磨損表面處于粘流態,並在鋼環表面形成了連續的轉移膜,表現出較好的耐磨損性能。Plastic deformation happened in the worn surface where fe element was found, so pam micro - fiber supported part of the load and prevented the further deformation. on the condition of high speed and high load, the worn surface of pam1 / nylon 6 composites was nearly melted and formed comparative uniform transfer on the surface of steel, which accounted for the rather low wear mass loss. the infrared analysis showed that the a small quantity of transition of crystal form from into of nylon and its composites happened during the friction because of the high temperature and strong sheering strength
通過對復合材料耐磨性能研究表明:復合材料的摩擦系數隨載荷的增加而逐步下降,且磨損表面有明顯的塑性變形;從能譜分析結果來看,復合材料表面有fe的存在,表明pam微纖承受了部分載荷,並阻止了基體的進一步塑性變形及粘著轉移;在高速高載時, pam1 /尼龍6磨損表面處于粘流態,並在鋼環表面形成了連續的轉移膜,表現出較好的耐磨損性能,且在高溫和強剪切力的作用下,材料基體發生了少量的晶體向晶體的轉移。Bitumen and bituminous binders - determination of complex shear modulus and phase angle - dynamic shear rheometer ; german version en 14770 : 2005
瀝青和瀝青粘合劑.復合剪切模量和相位角的測定.動態剪Adhesives - determination of dynamic resistance to cleavage of high - strength adhesive bonds under impact conditions - wedge impact method iso 11343 : 2003 ; german version en iso 11343 : 2005
粘合劑.沖擊條件下高強度膠粘劑耐動態劈裂的測定.楔Bonded abrasive products - permissible unbalances of grinding wheels as delivered - static testing
粘合磨料產品.砂輪交貨時的允許不平衡性.靜態試驗分享友人