粘土含量 的英文怎麼說

中文拼音 [niánhánliáng]
粘土含量 英文
clay concentration
  • : 粘動詞(粘附) glue; stick; paste; adhere to; bond
  • : 動詞1 (東西放在嘴裏 不咽下也不吐出) keep in the mouth 2 (藏在裏面; 包含) contain 3 (帶有某種...
  • : 量動1. (度量) measure 2. (估量) estimate; size up
  1. The black earth is a kind of alfisol, with a thick layer of humus, loose texture, high fertility, high porosity ratio, poor permeability and a high content of clay, which is suitable for cultivation

    摘要黑是一種腐殖質層厚,質地鬆散,肥力很高,孔隙比較大而透水性差,高,適于耕作的淋溶
  2. ( 3 ) the spatial analysis results showed that the variation of soil clay content was moderate at the direction of vertical section. the soil clay content was highest at the layer of 20 - 40cm, which showed that it is an eluvial accumulation horizon according to long - term cultivation, irrigation and rainfall

    ( 3 )在垂直方向上呈中等變異,整個體在20 - 40cm層處的最高,說明壤表層由於長期耕作、灌溉降雨,有一個淋溶淀積過程。
  3. The rheological experienments suggested that the viscosity of pcn was less than pp " s and decreased with increasing content of montmorillonite. the effects of silicate layer on rheological behaviors of pcn are important to process performance of pcn

    材料的毛細管流變測試表明,復合材料加工流動性隨著蒙脫的增加而得以改善,其度要低於純pp的度,這對加工成型極有指導意義。
  4. When fillings is other materials ( unprocessed montmorillonite, powder coal ash, co - composite of powder coal ash and organo - montmorillonite, co - composite ofcarbonizing calcium and organo - montmorillonite ) in the binder and content of organo - montmorillonite in the binder is five percent decided by tensile - shear experiment, tensile - shear strength of binder is up to tiptop ; at the same time, this paper carries out abrasion experiment, and, by comparison, concludes abrasion property of coating is optimum when content of organo - montmorillonite in the binder coating is five percent, and observes abrasion sample under set

    當膠劑中填料為其它物質(未處理蒙脫、粉煤灰、粉煤灰和有機化蒙脫共復合、碳化鈣和有機化蒙脫共復合)時,通過拉伸剪切試驗確定膠劑中有機化蒙脫為5時,膠劑的拉伸剪切強度最高;同時進行了沖蝕磨損試驗,通過比較得出,當膠劑塗層中有機化蒙脫達到5時,塗層的耐沖蝕磨損性能最佳,並對沖蝕磨損試樣在掃描電子顯微鏡( set )上進行觀察。
  5. Testing on logs in laminated shaly sands it demonstrates that the model can be applied in laminated shaly sands. testing on effects of rdc. and vdc representing clay resistivity and fraction or dry clay resistivity and fraction on water saturation calculated by the model it proves that it is very reasonable for rdc to be clay resistivity and vdc to be dry clay fraction, so the mode l derived from the paper can be used to evaluate shaly sands

    通過一組層狀泥質砂巖測井資料解釋,表明該模型適用於層狀泥質砂巖地層解釋;通過考察rdc 、 vdc代表或干電阻率及對該模型計算水飽和度的影響,說明rdc代表電阻率,而vdc代表干粘土含量是合適的,因此,使用文中給出的電阻率模型能更好地解決泥質砂巖問題。
  6. The grafting degree and grafting efficiency were decreased. the conversion of semi - contionious emulsion polymerization was decreased as the addition of mmt was increased because of the effect of monomer diffusion and decreasing efficiency of intiating agent

    半連續乳液聚合法制備abs mmt時,蒙脫的存在使聚合轉化率顯著下降,並且mmt粘土含量越高,對乳液共聚合造成的不利影響越大。
  7. When the amt concentration was below 3phr ( 3g amt / 100g epoxy resin ), the cte values of composites decreased from 0 to 20 % of that of pure epoxy, however, the light transmittancies in near ir region of composites were more than 80 % of that of the pristine epoxy, indicating that epoxy / amt exfoliated nanocomposites could be used as packaging materials for optoelectronic devices

    對剝離型納米復合材料的熱膨脹系數進行了研究,隨著粘土含量的增加體系熱膨脹系數顯著下降,且仍保持較好的光學透明性。表明納米復合是一種很好的制備高透光率和低膨脹系數的光電器件包裝用環氧樹脂基復合材料的方法。
  8. The organic matter, total n, hydrolytic n were increased, then reduced with the increase of abandoned time. the loss of organic c got up to 59. 4 % in abandoned land. in 0 - 20cm, the sand content of 0. 25 - 0. 05mm was increased gradually, the average content of sand in the abandoned land was up to 76. 84 %, the sand contents of silt and sand was gradually reduced, the soil mechanic compose became coarse

    隨撂荒年限的增加,壤有機質、全氮、堿解氮等主要養分均表現出先降低后增加的趨勢;撂荒地有機碳的損失平均達到59 . 4 ;在撂荒地表面0 - 20cm范圍內, 0 . 25 - 0 . 05mm粒徑的砂粒逐漸增加,各撂荒地砂粒平均達76 . 84 ,粉粒和逐漸降低,壤機械組成出現粗化現象。
  9. An important issue is that the dry bulk and shear modulus of sandstone are tightly correlated in a simple relationship with distribution of porosity, mineral composition, clay content, cementation, and differential pressure

    砂巖的乾燥體變模和剪切模與孔隙度分佈、礦物成分、粘土含量、膠結度和差壓的關系是嚴格相關的,這一點非常重要。
  10. In this article the conclusion was got from some experiments and researches that the crux of the matter is to solve the seepage stability of the soil and it is possible that gravelly soil is made into impervious core with the protection of filter

    但是存在料的不均勻、低、滲透系數偏大、天然偏低、塑性較差等缺陷。試驗研究還認為,只要解決好滲透穩定問題,做好反濾保護,礫質作心墻防滲體是可行的。
  11. And it should be ascribed to silt according to the view of its mineral composition, particles distribution, physical and mechanical indices. not only is the content of cla > relatively high, but also the exchange capacity of ion, chiefly high - electronvalent calcareous ion, is great. due to aggregations filled with pore among inter - particles, the soil has the engineering properties of silty clay

    從其礦物成分、顆分試驗及物理力學指標來看,它應歸屬于粉,但由於中的較高,且粒間充填集聚體,的離子交換容較大,交換陽離子以高價鈣離子為主,故其仍表現出粉質的工程特性。
  12. On the paas - normalized plots, the parent granite and the granite weathering crust are enriched in lree without ce anomaly. while the groundwaters are also enriched in lree, they display significant negative ce anomaly, indicating the fractionation of ce during water - rock interaction. based on the study of two profiles of granitoid weathering crust, we concluded that ree concentrations in the groundwaters from the granitoid weathering crust are likely related to the continued chemical weathering, as well as the ree concentrations in the crust near the water table, clay concentration and the wate r ph values

    地下水與母巖、風化殼稀的paas標準化分佈模式基本相似,呈lree富集型,母巖中無ce異常,而水樣中有ce負異常,表明ce在水巖作用過程中發生明顯的分異;通過研究兩個典型花崗巖風化殼剖面發現,地下水的稀與連續的化學風化,以及水位附近剖面上的稀礦物以及水的ph值等有關。
  13. Polymer / mmt nanocomposite is a new class of material. they can attain excellent mechanical properties, thermal stability and barrier properties at lower clay content. their potential applications include film, food packing, components in electrical parts, automobile and airplane

    聚合物納米復合材料是目前新興的一類復合材料,在粘土含量不高時,就能表現出優異的力學性能、耐熱性、及阻隔性等,因此這類材料在薄膜、食品包裝及電子、電器和汽車、飛機的零部件方面具有廣闊的應用前景。
  14. Based on the analysis of the vertical sealing mechanics of static fault and its affecting factors, simulation of the coarser the grain size in fault zone is, the lower the shale content requirement for oil - gas sealing is, and on the contrary, the higher the shale content requirement is

    摘要在分析斷層靜止期垂向封閉機理及其影響的因素的基礎上,利用自行設計組裝的實驗裝置,模擬了斷層靜止期不同粒度斷裂帶封閉油氣所需要的粘土含量的下限值。
  15. Conclusively, organic modifier used for layered silicate plays an important role in determining the stable nanostructure. finally, glass - fiber reinforced phenolic nanocomposite is prepared and its mechanical properties are investigated

    制備玻璃纖維增強的模壓料,討論了粘土含量、樹脂中熱固性酚醛和線型酚的比例對模壓試樣力學性能的影響。
  16. Using this result, as evaluating, to vertical oil - gas sealing evaluation of several major faults in northern wuerson sag, good suitability is gained

    模擬結果表明,斷裂帶巖石顆粒粒度越粗,封閉油氣所需要的粘土含量越低,反之則越高。
  17. Determination of content of clay mineral in formation using elemental capture spectroscopy

    用地層元素測井資料確定儲層粘土含量
  18. For exfoliated epoxy / clay nanocomposites, its mechanical properties were optimal when the content of the clay was about 2wt %

    在剝離型環氧/納米復合材料中,當粘土含量為2 3wt時復合材料性能最好。
  19. Results showed, the transmittance of the former was notably higher than that of the latter with the same amt content

    研究結果顯示,材料的透光率隨粘土含量的增加而下降,隨波長的增加而增大,並逐漸趨于平緩。
  20. The light transmittance of the former with small amt content was higher than that of the latter with relatively higher amt content at the shorter wavelengths, and was lower than the latter at the longer wavelengths. and normalized light transmittance increased when the wavelength increased and the amt content decreased, whenever the amt is exfoliated or intercalated. on the additional, the light transmittance of composites prepared with different amounts of curing agent was also investigated

    在環氧樹脂基體中的結構對材料的光學透明性有很大的影響,當有機相同時,剝離有利於ec材料保持較高的透光率;當低粘土含量的插層型納米復合材料與高粘土含量的剝離型納米復合材料相比較時,材料的透光率大小關系隨波長的變化而變化:在短波長時,插層型納米復合材料優於後者;波長變長時,剝離型納米復合材料具有較高的透光率,盡管體系中遠大於插層型納米復合材料。
分享友人