粘度梯度 的英文怎麼說

中文拼音 [nián]
粘度梯度 英文
viscosity gradient
  • : 粘動詞(粘附) glue; stick; paste; adhere to; bond
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • : Ⅰ名詞1 (梯子; 樓梯) ladder; stairs; steps; staircase 2 (姓氏) a surname Ⅱ形容詞(形狀像樓梯的...
  1. In this paper, the contrast of original image is enhanced by nonlinear transformation based on the characteristics of grain image ; after comparing several methods of threshold segmentation and analyzing their performance and applicability on grain image, the adaptive threshold segmentation based on gradient image is presented ; the noise of binary image is reduced with morphological filter, the hollow in binary image is filled in and a recognition algorithm is designed to remove agglomerate particle ; on the basis of mathematical morphology two methods are adopted to segment agglomerate grains that are not agglomerated tightly ; the parameters of size and shape, perimeter, area, diameter, complexlity, longest feret diameter, shortest feret diameter etc, are extracted. this technique is applied in measurement of pearl powder ' s particle size

    本文根據粒圖像的特點,採用非線性對比增強處理改善顆粒顯微圖像的對比;對多種閾值分割方法進行比較,分析了它們的性能和用於粒圖像的適用性,在此基礎上提出了一種基於圖像的動態閾值分割方法;對獲取的顆粒二值圖像進行形態濾波和空洞填充,設計了識別演算法去除凝聚體;對重疊不太嚴重的結顆粒採用了兩種基於數學形態學的分割演算法;提取了周長、面積、粒徑、復雜、最長feret徑、最短feret徑等大小和形狀特徵參數,對珍珠粉等粉體粒進行了測量。
  2. This paper presents the displacement solution to mine elevator viscoelastic vibrating equations and the kinetic tension calculation method, discusses kinetic tension characteristics under rectangular, ladder shaped, sinusoidal and parabolic acceleration curves, provides ways to limit or even avoid lifting rope viscoelastic vibration

    摘要給出了礦井提升機彈性振動方程的位移解及動張力的計算方法,研究了採用矩形、形、正弦形、拋物線形加速時銅線繩的動張力特性,給出了限制和消除提升鋼絲繩彈性振動的方法。
  3. The boundary layer can indicate the comprehensive influences of oil reservoirs, the physical properties ( reservoir porosity, permeability, fluid viscosity and its composition ) of inside fluids and development conditions such as pressure gradient : the layer thickness reduces with the rise of capillary radius ; when capillary radius is fixed, the thickness increases with viscosity rise ; the more polarity composition content is, the more obvious the absorption, the thicker the boundary layer, more and more obvious the characteristics of non - darcy filtration

    邊界層反映了儲層、流體物性條件(儲層孔隙、滲透率、流體、組分)和開發條件(壓力)的綜合影響,認為邊界層厚隨著毛管半徑的增大而減小;在毛管半徑相同的情況下,邊界層厚隨壓力的增大而減小,最後達到一個臨界值;毛管半徑一定時,邊界層厚增加而增大;極性組分含量越大,吸附越明顯,邊界層厚越大;邊界層厚越大,非達西滲流特徵越明顯。
  4. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模,並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究,主要針對影響系統特性的主要參數變化,動態分析系統的輸出特性,在上下行工況中,分析了電機軸系性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響;最後對軸向柱塞泵馬達的流量壓力脈動對電轎廂速的影響和蓄能器內油液體積損失機理進行了理論研究。
  5. In chapter 5, using coordinate graphs, the influences of rectangular screw, trapezoidal screw and serrate screw on the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction are compared and analyzed

    第五章,通過坐標圖對比分析了微型機器人在矩形螺紋、形螺紋、鋸齒形螺紋下,各螺紋參數對軸向摩擦牽引力、最小液膜厚液膜承載能力、周向摩擦阻力的影響。
  6. Based on the technical requirements of manufacture, application and repair of the pump shell and cutter piece of the cutterhead pipeline dredge, put forward are the re - manufacture three principles on easily damaged workpieces of dredge engineering. with the inter - clamped structures on the pump liners, the gradient wear - resisting design on the cutter piece, and the new techniques in the process of re - manufacture, new wear - resistant materials, including high - cr alloy, overlaying and brazing deposits, and polymer adhesive coatings have been successfully applied to the re - manufacture dredge pump shell and cutter piece. the application results show that their wear - resistant lifetimes and the dredging profits have been increased remarkably

    根據絞吸挖泥船泥泵絞刀的製造、使用和修復性能要求,提出了疏浚工程易損件再製造三原則;採用泥泵內襯互鎖結構、絞刀化耐磨設計和工藝再製造新技術,將高鉻合金耐磨材料、熔敷耐磨材料及其復合材料和高分子耐磨膠塗層材料成功地應用於再製造泥泵殼和絞刀片上,顯著提高了泥泵殼和絞刀的耐磨壽命和挖泥船的疏浚效益。
  7. ( 2 ) on the basis of continuity equation, momentum conservation equation, energy conservation equation, and substantial equation, coupled thm governing equations are derivated with giving up the assumption of local thermal equilibrium, adopting thermal elasto - plastic constitutive relation, taking the effect of temperature gradient on groundwater seepage ( analogous to soret diffusion ) and the effect of viscous dissipation of groundwater on temperature field of rock mass into account

    ( 2 )根據連續性方程、線動量平衡方程和能量守恆方程以及相應的物性方程推導了飽和巖體溫場-滲流場-變形場三場耦合作用控制方程組。在推導控制方程組時舍棄了「局部熱平衡」假設,採用了熱彈塑性本構關系,考慮了溫對地下水滲流的影響(類soret效應)以及地下水的性耗散對巖體溫場的影響。
  8. Through large amount of lab experiments, the relation of oil boundary layer thickness with capillary radius, pressure gradient, fluid viscosity and its composition has been discussed

    摘要通過大量的室內實驗,探討了原油邊界層厚與毛管半徑、壓力、流體和組分的關系。
  9. The maim factors affecting the velocity profiles are the viscosity near the bed, particle grid resistance and the density gradient

    影響流速分佈的主要因素有底部、顆粒格柵阻尼和密
  10. With the consideration of the vertical wave effect of soil and soil - pile interaction, an approximate analytical solution to vertical vibration of pile system with variable impedance in visco - elastic layered soil is developed. a simplified and practical mathematical model for interaction between soil layers is proposed, and its applicability is theoretically investigated. based on this model and by using laplace transforms and the transmit property of impedance function, the analytical expression of the impedance function and solutions of the displacement and velocity response function in frequency domain and in time domain at the pile head are derived

    4 、從三維軸對稱土模型出發,對考慮樁土耦合作用、土層層間聯系以及樁周土豎向應力變化條件下的成層彈性土中完整樁及變阻抗樁系統縱向振動問題進行了研究,提出了成層土中變阻抗樁系統縱向振動問題的近似解析解法和樁周土層層間相互作用的簡化而實用的數學模型,並利用拉氏變換和阻抗函數的傳遞性,獲得了成層土中任意段變阻抗樁樁頂阻抗函數的解析表達式,以及樁頂速導納和時域速響應解析解和半解析解。
  11. When the weak acid is given orally, the concentration gradient for un - ionized drug between stomach and plasma tends to be large, favoring diffusion through the gastric mucosa

    當這種弱酸性藥物經口服給藥時,胃與血漿之間的非解離型藥物濃很大,從而有利於透過胃膜擴散。
  12. Friction - reduction mechanism of dlc gradient film could be attributed to its smooth and hard amorphous structure. the hemocompatibility of dlc gradient film had been evaluated by investigating platelet consumption ratio, blood protein adsorption and platelet adhension and morphology on surface of materials

    Dlc薄膜材料與ti6a14v合金材料的血小板消耗率相差不大,但是dlc薄膜材料對血漿蛋白的吸附明顯低於ti6a14v合金材料,可以預料血小板在dlc薄膜材料表面附也會較少。
  13. A study of unsteady flow of viscoelastic fluid by ananlyticl method

    周期壓力彈流體非定常流動的解析法研究
  14. The axial frictional pulling force and the minimum thickness of mucus film were analyzed and calculated in detail when rectangular or trapezoidal cylindrical screw was being adopted in microcomputer

    詳細分析計算了微型機器人在採用矩形和形圓柱螺旋時的軸向摩擦牽引力和最小液膜厚
  15. In chapter 3, the modified reynolds equation is solved numerically with the finite different method, and the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction under the trapezoidal screw are obtained. at last, using numeral methods and coordinate graphs, the influences of trapezoidal screw parameters on the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction are studied and analyzed

    第三章,首先求出形螺紋下有限差分方程,然後推導了形螺紋作用下軸向摩擦牽引力、液膜厚液膜承載能力、周向摩擦阻力無量綱表達式,並用數值計算方法求解,通過坐標圖分析了形螺紋參數對軸向摩擦牽引力、最小液膜厚液膜承載能力、周向摩擦阻力的影響。
  16. It is shown that as long as the l norm of the gradient of the velocity vector field of the flow is finite, that is, if for any t > 0, then the classical solution exists globally on [ 0, t ]

    該準則表明只要流體速場的的l ~范數有限,即如果對任意的,則三維無boussinesq方程組的古典解在[ o , t ]上整體存在。
分享友人