粘度檢驗 的英文怎麼說

中文拼音 [niándùjiǎnyàn]
粘度檢驗 英文
test method for viscosity of plastics gravure printing inks
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 檢驗 : checkout; test; examine; inspect; verify; survey; check;checking;testing;[英國]jerque（指檢查船舶...
  1. In order to verify the effectiveness of steep - front impulse voltage test in finding the internal faults of composite insulator, some insulators with faults, including conductive channel, semi - conductive channels, airy channel, partial little air bubble that occur separately at different place, are modeled. steep - front wave impulse voltage test is made for these faulty insulator and normal insulator

    為了檢驗陡波試驗對于發現合成絕緣子內部故障的有效性，分別模擬了絕緣子內部不同部位有導電性、半導電性通道，小氣泡，金屬雜質，長氣泡以及芯棒與護套間不粘連故障的絕緣子，並從三維靜電場計算和用不同陡度的陡波試驗兩個方面進行了驗證。
  2. Vitrified grinding wheels, fatigue proof test procedure

    陶瓷粘結砂輪疲勞度的檢驗程序
  3. The effect of reynolds number on rudder hydrodynamic performance is also analyzed. up to the stall angle the computed lift and drag agree well with measurements and other author ' s calculations, whereas stall angle, lift and drag beyond the stall angle are slightly under - predicted. the solver is used to investigate laminar and turbulent separated flows around a 6 : 1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces

    應用所開發的求解器，以naca0015翼型舵為算例計算了船舵在不同雷諾武漢理三;大學博士學位論文數下大舵角范圍內的三維粘性流場及水動力，成功地預報了舵的失速角和最大升力，並初步探討了雷諾數對舵水動力的影響;計算結果與現有試驗和計算數據比較，吻合程度相當好，初步檢驗和驗證了該求解器精確模擬粘性流動和計算水動力的能力。
  4. Testing of lubricants - determination of apparent viscosity of lubricating greases by rotational viscosimeter - system cone and plate

    潤滑劑檢驗.用旋轉式粘度計測定潤滑脂的表觀粘度.錐
  5. Standard of adhesive strength test of tapestry brick for building engineering

    建築工程飾面磚粘結強度檢驗標準
  6. Testing of plastic films and sheetings ; determination of blocking strength

    塑料薄膜和膜片的檢驗.粘連強度的測定
  7. Although violation of homogeneity assumption is known to adversely impact the accuracy of phylogenetic inference and tests of evolutionary hypotheses, testing such the assumption has been little investigated to date

    盡管違背了這個假設就相對地影響了系統發生的推論和進化假設測驗的粘度，但檢測這個假設卻鮮見研究。
  8. Testing of bituminous binders ; determination of viscosity ; measurement by drawn - sphere viscometer

    瀝青粘合劑的檢驗.粘度的測定.用拉球式粘度計測量
  9. Testing of carbon materials - determination of density with liquid pycnometer - binding and impregnating materials

    炭素材料檢驗.用液體比重計測定密度.粘結劑與浸漬劑
  10. Standard for adhesive strength test of tapestry brick for building engineerings

    建築工程飾面磚粘結強度檢驗標準
  11. Based on analysis and comparison of existing test data applied to existing ultimate strength prediction models, interfacial stress at the end of plate is deduced. after formulas for calculating the effective moment of inertia for frp - strengthened beams being revised and adjustment coefficient related to nominal main steel reinforcement ratio and curtailment length ratio being put forward, strength prediction formulas of compound beams under plate end debonding failure are established. in analysis of strength of compound beams under intermediate crack induced interfacial debonding failure mode, several bond strengths and their relation are introduced

    對于板端剝離破壞，在總結現有承載力模型的基礎上，利用已有試驗數據對各承載力計算公式進行了分析比較，進一步採用分階段分析法，推導了板端界面應力的計算公式，在此基礎上，採用加固復合梁有效慣性矩的修正公式，建立了考慮名義配筋率和板端偏移比影響的板端剝離破壞梁承載力的計算公式；對于跨中受彎裂縫導致的粘結破壞，闡述了常見的幾種粘結強度之間的區別和聯系，並基於拉剪粘結強度，提出了跨中受彎裂縫導致粘結破壞的承載力計算公式，並利用現有試驗結果確定了模型中的一些參數；最後，利用試驗數據對本文建立的兩種粘結破壞承載力計算公式進行了檢驗，結果基本吻合。
  12. The computations are shown to agree well with available experimental and numerical data and the physics of 3d large - scale flow separations and vortex shedding are confirmed. the simulation of the flow around a maneuvering wigley hull is a demonstration of capability for calculations of sway forces and yaw moments acting on a hull moving obliquely at a large range of yaw angles. the focus of study is large - scale cross - section separation flows, bilge - vortex development along the hull in the longitudinal direction and their effects on hydrodynamic forces

    應用所開發的求解器，以wigley船型為算例計算了大角度斜航船體粘性流場和水動力，分析了漂角的變化對船體所受到的粘性水動力的影響，相當精確地預報了以橫流分離和般渦生成與泄出為特徵的操縱運動船體特有流動形態及橫向水動力和轉脂力矩，經與現有試驗和計算數據比較，檢驗和驗證了該求解器精確模擬繞斜航運動船體的大尺度分離流動和計算非線性水動力的能力。
  13. Testing of textiles ; determination of the limit - viscosity of celluloses, principles

    紡織品的檢驗.第1部分:纖維素極限粘度測定原則
  14. Testing of textiles ; determination of the limit - viscosity of celluloses, nitrate procedure

    紡織品的檢驗.用硝酸鹽法測定纖維素的極限粘度
  15. Testing of textiles ; determination of the limit - viscosity of celluloses, ewnn - procedure

    紡織品的檢驗.第3部分:纖維素極限粘度的測定. ewnn程
  16. Cereals and feedstuffs for import and export. method for the determination of viscosity

    進出口糧食飼料.粘度檢驗方法
  17. Testing of rubber and elastomers ; testing with the mooney shearing disk viscometer ; determining the mooney viscosity

    橡膠和彈性體的檢驗.第3部分:莫氏剪盤式粘度計檢驗
  18. Testing of rubber and elastomers ; testing with the mooney shearing disk viscometer ; determining the scorching behaviour

    橡膠和彈性體的檢驗.第4部分:用莫氏剪盤式粘度計檢驗
  19. Testing of packaging ; determining the filling ratio of prepacks ; form relating to coefficients of variation for the density of the packaged material and for the package for adhesives and allied products

    包裝的檢驗.預包裝充滿率的測定.包裝材料密度和粘合
  20. Testing of mortars containing mineral binders ; determination of bond strength of hardened mortar

    對含有礦物粘合劑的砂漿的檢驗.固化砂漿粘合強度的測
分享友人
分享到 Line

分享到臉書