粘性滑動 的英文怎麼說

中文拼音 [niánxìnggǔdòng]
粘性滑動 英文
stick-slimotion
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 滑 : Ⅰ形容詞1 （光滑; 滑溜） slippery; smooth 2 （油滑; 狡詐） cunning; crafty; slippery Ⅱ動詞（貼著物...
  • 滑動 : slither; slippage; slipping; slide; sliding; run; sliding movement [motion]; glide; slump滑動閘門...
  1. The bacilliform cell penetrate into interior of the fibre to degrade the cellulose strongly and produced a mass of sticky polysaccharides. after cultured 48 hours, the bacilliform cell ' s surface of sporocytophaga have a great change. at this stage the bacilliform produce a lot of sticky polysaccharides. these sticky polysaccharides associated with the sites where the filter paper was decomposed intensively and form thorns on the surface of the bacillium. at the same time, the filter - paper weight loss is the greatest and decomposing rate is the fastest, so we think that the sticky polysaccharides are produced during the cellulose degradation

    培養48小時，桿狀細胞的表面結構發生很大的變化，此時的菌體表面已產生大量的粘性多糖，這些粘性多糖因菌體在纖維素表面滑動而在菌體表面形成突起，即在纖維素被旺盛降解部位的菌體表面產生了大量突起；而產生突起的菌體深入到纖維素分子內部，纖維素表面可以清晰地看到由於菌體嵌入纖維素分子內部而留下的凹陷。
  2. Purpose ： the type of 2cy is applicable to transport the lube or analog, the temperature is not more than + 80 and the thickness is from 5 to 1500 cst, no causticity, and no solid granules or fiber, also is applicable for the fluid drive system and ships, etc

    2cy系列適用於船舶等輸送溫度不高於+ 80 、粘度在5到1500cst之間、無腐蝕性、無固體顆粒和纖維的潤滑油式或類似潤滑油的其他液體，並且適用於液壓傳動系統。
  3. 0 x 10 " 3 and 264. 6mpa respectively. 6. the damping mechanism at ambient temperature is related to viscous motion of dislocation and interactions between dislocation with various point defects, the viscous sliding between the phase with rich zn and primary a dendrite crystals and the micro - plastic deformation of the soft phase in the eutectic

    6 ） azsm合金的室溫阻尼行為與組織中的溶質原子和位錯的交互作用以及位錯的粘性運動、富鋅相與基體之間的粘性滑移、以及共晶體中較軟相的西安理工大學碩士學位論文微塑性變形有關。
  4. Moreover, it is a compatible raw material under the terms of the food sanitation law. also, through the use of newly developed complex technology, we have given this coating excellent non - adhesion, low friction and sliding capabilities, etc. thanks to these capabilities it has become possible to adjust the surface treatment performance to match a wide range of application purposes, equipment, etc

    聚氨酯本身具有耐磨損性，高摩擦系數特性，還有防止靜電的導電特性，保證工廠安全的自動溶解特性，亦可用作食品衛生法對應的原料，此外通過最新開發的復合技術具備了無粘性，低摩擦性，光滑性等諸多優點，用途更廣泛，可適用於各種器械的表面處理施工。
  5. And also, the wear resistance at ambient temperature and of za27 alloyed with mn when lightly loaded is desirable but becomes worse at high temperature. the wear mechanism of the one mixed with both adhesive and abrasive wear under sliding friction conditions ( at high temperature )

    Si的加入量為1 - 3時， za27合金的磨損量最少，高溫摩擦性能最好；加入mn后， za27合金在低溫輕載下耐磨性能較好，高溫耐磨性能不理想；在滑動摩擦條件下（高溫）的磨損以粘著磨損和磨料磨損兩種方式共同存在。
  6. In water hydrostatic bearing lubrication, however, more accurate research results can be obtained as long as inertia of water flow is considered, because inertia item almost has the same quantitative level as the viscous one

    然而，在水靜壓支承潤滑中，水的流動慣性項幾乎與粘性項具有相同的數量級，對水膜的流速及壓力分佈具有一定的影響，因此應予以考慮，才能得出更加準確的研究結果。
  7. In order to develop and consummate the analysis theory and calculation method of base - isolated structures, based on the research on restoring force model of isolation systems and the analysis on the nonlinear seismic response of base - isolated structures, the analysis on multi - dimensional and lateral - torsional coupled seismic response of base - isolated structures is developed in this paper. according to the mechanical performance of isolation systems, detailed analysis and improvement of the present research, an unilateral and a bilateral coupled visco - elastic hysteretic model for rubber bearings, an unilateral and a bilateral coupled visco - elasto - plastic differential hysteretic model for lead rubber bearings, an unilateral and a bilateral coupled modified visco - plastic differential hysteretic model for sliding friction bearings are proposed

    為進一步發展和完善基礎隔震結構分析理論和計算方法，本文以隔震系統恢復力模型研究及基礎隔震結構非線性地震反應分析為基礎，對基礎隔震結構的多維地震反應及平?扭耦聯地震反應開展了以下幾方面的研究工作：根據隔震系統力學性能的特點，在現有研究成果的基礎上，對隔震系統恢復力計算模型進行了改進和創新，提出了普通疊層橡膠支座單向及雙向耦合粘彈性恢復力計算模型，鉛芯疊層橡膠支座單向及雙向耦合粘彈塑性微分型恢復力計算模型，摩擦滑動支座單向及雙向耦合修正粘塑性微分型恢復力計算模型。
  8. We not only carefully discuss the clay ' s nature, its anti - sheer intension, the exponents of anti - sheer intension and the water pressure of the hole in clay, but also study varies analysis methods such as sweden strip method, stability coefficient method and bishop ' s simplified method of arc slice. finally, we thoroughly discourse upon the method of none arc slice in slope analysis

    論文中對粘土的抗剪強度特徵、粘性土抗剪強度指標的選擇應用和孔隙水壓力等問題進行了分析，同時對分析土坡穩定性的瑞典條分法、穩定數法、圓弧滑動面的畢肖普法以及對非圓弧滑動面的土坡分析方法進行了細致深入的闡述和分析。
  9. Based on the method of limitation analysis of soil plasticity, researching from the soil arching mechanism of soil - nailing retaining, the upper limit of the critical height of soil - nailing slopes and the minimum horizontal length from coping of the potential slide surface to the edge of deep excavation are obtained through the analysis to weight of soil and vertical loading and the mechanism of soil and soli - nailing acting reciprocally

    摘要基於土的塑性極限分析方法，以均質土坡為例，從土釘支護結構的準粘聚力理論出發，綜合考慮土體自重、坡頂的條形荷載，以及土釘與土體的相互作用的機理，推導出了土釘支護的臨界高度的上限值和潛在螺旋曲線滑動面在坡頂方向距基坑邊沿的最小水平距離解析表達式，可供基抗支護設計參考。
  10. In oil lubrication theory, the effect of inertia on flow state of lubrication film is generally ignored because the inertia item is far smaller than the viscous one

    在油潤滑理論中，一般情況下都忽略慣性對潤滑膜流動狀態的影響，這是因為慣性項與粘性項相比要小得多。
  11. The type and working principle of 4wd which connected by cohesive shaft coupler are introduced, the effect of motor vehicle speed and tyre sliding rate on rotation difference of cohesive shaft coupler are described

    介紹了採用粘性聯軸器連接的四輪驅動形式和工作原理，闡述了汽車速度、輪胎滑移率對粘性聯軸器轉速差的影響。
  12. Decohesion and sliding are enhanced thanks to the anisotropy if the graphite sheets at the interphase / matrix interface

    而3d - c sic中界面處熱解碳層的各向異性結構會促進界面層的脫粘和滑動。
  13. According to the coulomb ' s earth pressure theory, from the condition of the static equilibrium of the force when the slide wedge was in limit equilibrium, a formula was derivated for the calculation of active earth pressure of cohesive or non - cohesive backfill soils

    摘要根據庫倫土壓力的計算原理，從滑動楔體處于極限平衡狀態時力的靜力平衡條件出發，推導出了計算粘性土或無粘性土主動土壓力的公式。
  14. Based on the hypothesis that the rear side of retaining wall is pitching and coarse, and the filling surface is gradient, taking viscous filling as the object of study and using the static balance method, a study has been conducted on the earth pressure on the rear side of retaining wall under the sliding wedge ' s limiting equilibrium condition, and generated a general form for active earth pressure and passive earth pressure

    摘要基於擋土墻墻背俯斜、粗糙且填土表面傾斜的情況，以粘性填土為研究對象，用靜力平衡方法研究了擋土墻后滑動土楔體達到極限平衡狀態時作用於墻背的土壓力，提出了主動土壓力和被動土壓力的一般形式。
  15. Metallic multilayer plain bearings - method for destructive testing of bond for bearing metal layer thickness 2 mm

    多層金屬滑動軸承.第2部分:厚度為2mm的軸承金屬層粘合力的破壞性試驗方法
  16. 05. 02 measuring the wear life of bonded solid film lubricants in oscillating motion, test method for

    振動中粘性固態薄膜潤滑劑的耐磨壽命的測量方法
  17. Adhesives for tiles - determination of slip

    磁磚膠粘劑.滑動性的測定
  18. The third one describes the properties of working fluid and some experiments on viscous - temperature curves of silicone oil, named as 0. 017m2 / s, 0. 027m2 / s and 0. 037m2 / s. the experimental results demonstrate that the dimension of plate and properties of working fluid have influences on life - span and torque transfer performance of lvc. in chapter four, the strength of each component of lvc were designed and corrected and the new seals were used and the space between the inner and outer plate is 0. 4mm

    第一章主要說明了課題研究的背景和意義、液體粘性聯軸器的工作原理及其在工程上的應用，介紹了常時四輪驅動汽車的概念與分類；第二章在閱讀大量文獻的基礎上，對液體粘性聯軸器的研究成果進行總結，包括粘性聯軸器的扭矩計算，扭矩輸出所受的影響因素，駝峰發生的機理、駝峰觸發的溫度、駝峰發生時的最小轉速差，聯軸器在發生駝峰現象之前硅油剪切的內部溫度特性，聯軸器的傳熱模型以及汽車速度、滑移率對轉速差的影響。
  19. Furthermore, the forms of slip surface are generalized into conic curve no longer taking the magnitude of cohesion into account. and the method of slope stability analysis for anchor - reinforced or discharged slope is also presented

    假定滑面上應力分佈形式，文中進一步將粘性土坡和無粘性土坡的滑面形式統一起來，在計算過程中不再根據粘聚力的大小來假定不同的滑面形式，均將滑動面形式假定為二次曲線。
  20. Then, the phase - space equations is presented based on the two - mass - oscillator dynamic equations, taking the relative velocity as the factors, to get the criterion as how to distinguish the stick phase and slip phase, which give a great convenience to optimize the design, and stability and control strategy. the response is studied following

    然後根據二元摩擦振子動力學方程，建立運動狀態方程;並轉化為相對速度狀態量，通過對相對速度狀態量的討論建立判別粘滯與滑動狀態轉換過程及劃分標準，狀態空間的建立為球基微操作器的優化設計，控制理論以及穩定性討論奠定理論鋪墊。
分享友人
分享到 Line

分享到臉書