粘管孔 的英文怎麼說

中文拼音 [niánguǎnkǒng]
粘管孔 英文
collatoria
  • : 粘動詞(粘附) glue; stick; paste; adhere to; bond
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  1. 1 water threatening - resistant characteristic : for instance, the outside tangency wall of epidermis cell prominently thicken ; the outside of epidermis cell are obviously covered by cuticle ; few stomats exists ; stomats are sunken ; and it has stmatic chamber structure, big aqueous tissues - parenchyma cell, mucilage cell, abnormal vascular, and soon

    抗水分脅迫的抗鹽結構特徵。如表皮細胞外切向壁明顯加厚,表皮外有明顯的角質層覆蓋;氣稀少、氣下陷及具有下室結構;大型貯水組織薄壁細胞、液細胞、異型維束等。
  2. Abstract : the formation technologies, the structure and properties of tcs microporous man - made yarn - kind new polyester fibre which was spinned in tcs with some micrometallic - oxide have been studied. the results indicate that the rheological behaviour and spinnability of commixed polyester melt, and the structure and properties of the fibre, are relative to the spinning temperature, melt pressure, microporpus size for spinning, formation conditions, thermo - vascellum temperature, thermo - vascellum position and rolling speed, besides the viscosity of polyester cuts, coacervation particles, adding amount and size of micrometallic - oxide

    研究表明, tcs微化共混聚酯熔體在成型加工中的流變行為和可紡性,及其纖維的結構性能除了與原料切片的特性度、凝聚粒子和共混聚酯中超細金屬氧化物微粒的添加量、粒徑等因素的影響有關外,還與紡絲溫度、紡絲熔體壓力、噴絲板微尺寸、冷卻成形條件、熱溫度、熱安裝位置以及卷繞速度等因素的影響密切有關。
  3. Due to the size of the defect, a fragment of bone is introduced to support the mucosal graft. strength of the repair is verified by increasing intercranial pressure with the valsalva maneuver, and it is seen to be watertight. rapid - setting fibrin glue is applied, and a second layer of mucosa is applied over this

    由於瘺較大,置入一些骨的碎片以支持填塞物,通過valsalva法咽鼓吹氣法增加顱內壓可以觀察修補的牢固性,可以看到沒有泄漏,利用可以快速固定的纖維蛋白膠進行固定,其上鋪上一層膜,然後再用膠水進行固定。
  4. Designning well tube and drill - hole diameter in order to increase thickness of both annular packing gravel and water - resisting clay, nylon net packing around well tube filters, designing filter layer on the boundary between packing gravel and water - resisting clay and ramming the gravel by working the piston into the well after gravel packing completion and the filling clay for salt - water resisting etc. we succeeded in constructing 3 drinking - water wells in minqin county, proved the affectivity and feasibility of using it and giving a certain technical demonstration of construction of drinking - water well in the same similar to this area

    通過徑與徑的調配設計,增大環狀粒料層和止水土層的厚度;濾水外包尼龍紗網;粒料與止水土接觸界面上設計反濾層;填粒后先行拉活塞利用水力夯實粒料層,再投土球止掉上部鹹水等措施,在民勤縣三口人飲水井施工中取得顯著效果,證明了該套成井工藝的有效性和可行性,有望為同類地區人飲水井施工提供技術示範作用。
  5. With increase of artificial forest age, the content of soil organic matter decreased sharply. and soil physical, chemical and biological properties of forest became worsen. from soil physical properties analysis, soil silt, clay, physical clay, aggregate degree and structure coefficient in topsoil increased with increase of artificial forest age and soil sand deceased

    在土壤物理性質方面,隨著人工雲杉林齡的增加,土壤表層粉粒、粒、物理性粒、團聚度和結構系數降低,砂粒含量增高,土壤飽和持水量、毛持水量及總隙和毛隙在人工雲杉演替過程中表現出「 u 」型變化。
  6. The numerical simulations show that the phase plane and amplitude plane in orthotropic fluid - saturated porous media is not paralleled to each other any more though the dispersion caused by the fluid is omitted. it is one kind of non - homogeneous wave. the maximum attenuation is no longer

    指出由於介質的各向異性,盡忽略了流體度引起的度耗散,正交各向異性液飽和多介質中瑞利波的相平面和幅平面亦不再重合,為非均勻波,最大的衰減不再沿波傳播方向。
  7. The boundary layer can indicate the comprehensive influences of oil reservoirs, the physical properties ( reservoir porosity, permeability, fluid viscosity and its composition ) of inside fluids and development conditions such as pressure gradient : the layer thickness reduces with the rise of capillary radius ; when capillary radius is fixed, the thickness increases with viscosity rise ; the more polarity composition content is, the more obvious the absorption, the thicker the boundary layer, more and more obvious the characteristics of non - darcy filtration

    邊界層反映了儲層、流體物性條件(儲層隙度、滲透率、流體度、組分)和開發條件(壓力梯度)的綜合影響,認為邊界層厚度隨著毛半徑的增大而減小;在毛半徑相同的情況下,邊界層厚度隨壓力梯度的增大而減小,最後達到一個臨界值;毛半徑一定時,邊界層厚度隨度增加而增大;極性組分含量越大,吸附越明顯,邊界層厚度越大;邊界層厚度越大,非達西滲流特徵越明顯。
  8. The special structure of zippered plastic pipe zippered seep holes made a greater seepage quantity on the condition of bare pipe ( no anti - blocking material adopted at the mouth of seep holes ). so several kinds of anti - seepage material were adopted in the experiment of this part in order to find the proper anti - seepage material ( nonwoven fabrics glued by neoprene ) and working head ( 3m ' s working herd on initial irrigation )

    由於拉鏈式塑料的獨特構造(拉鏈式滲水口) ,裸(滲水口不採用任何防堵材料)情況下滲流量很大,所以本部分試驗採用了幾種防滲材料試驗,最後通過比較分析,找到了合適的防滲材料(氯汀膠無紡布)和工作水頭(初始灌水時3m工作水頭) 。
  9. Negative pressure blockage and biological blockage are two main forms of blockage for the special structure of zippered plastic pipes, so two treatments were made here : ( i ) nonwoven fabrics glued by neoprene and ( ii ) nonwoven fabrics glued by neoprene with a layer of asphalt emulsion applied outside

    由於拉鏈式塑料的獨特構造(拉鏈式滲水口) ,所以它的堵塞主要應是負壓堵塞和生物堵塞,為此設2個處理:氯汀膠無紡布和氯汀膠無紡布並外塗一層乳化瀝青進行試驗研究。
  10. Standard test method for measuring apparent viscosity at high - temperature and high - shear rate by multicell capillary viscometer

    用多毛細度計在高溫高剪切率下測量表觀度的標準試驗方法
  11. Standard specification for clay drain tile and perforated clay drain tile

    土排水瓦和多土排水瓦的標準規范
  12. On the basis of the entropy expression of viscous flow, the entropy expression of porous media seepage under porous media continuum hypothesis is studied and put forward, and their unification is verified in pipe model

    本文基於流體滯流動過程的熵產表達,研究提出了多介質連續介質方法下多介質滲流過程的熵產表達形式,並在平直模型中驗證了兩者的統一性。
  13. Test method for measuring apparent viscosity at high - temperature and high - shear rate by multicell capillary viscometer

    用多毛細度計在高溫和高剪切率下測量表面性的試驗方法
  14. Holes through refractory walls or in ceramic lead - in sleeves, if used, must be large enough to ensure no physical binding of them

    穿過難熔爐壁或者套,一旦用了,必須保證足夠大以確保沒有任何物質的合劑上。
  15. To the places of small reynolds numbers and high media viscosity, it is difficult to reach the demand that using orifice plate and nozzle, etc, to make the measurement. and the 1 / 4 orifice plate was specially designed for that

    對于道雷諾數很小或介質度高的場合,應用板或噴嘴等來測量很難達到要求,而這些裝置正是專為此而設計的。
分享友人