粘結膜 的英文怎麼說

中文拼音 [niánjiēmó]
粘結膜 英文
film adhesive
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 結膜 : [生理學] conjunctiva; tunica conjunctiva結膜切除術 logadectomy; 結膜炎 conjunctivitis; epipephysitis; taraxis
  1. Chitosan could be used to prepare controlled - release medicine membrane, artificial skin, and anti - adhesion membranes for post - operative application, etc. however, few chitosan membranes have been used in clinical practice

    因此，本文採用殼聚糖作為防術后粘連膜的基體材料，研究了殼聚糖及其共混膜的制備方法並進行了結構與性能的表徵。
  2. Methods twelve patients ( 12 eyes ) with sever symblepharon and pseudo - pterygium were treated for symblepharon resection, then autologous oral mucosa was transplanted for reconstruction of the palpebral conjunctiva and fonix, amniotic membrane and conjunctival limbal grafts for bulbar conjunctiva and corneal surface reconstruction

    方法對12例12眼有嚴重瞼球粘連及假性胬內的患者，進行瞼球粘連松解后，應用自體口唇粘膜移植進行瞼結膜和穹窿結膜修復，羊膜和自體結角膜緣組織瓣移植重建球結膜和角膜表面，觀察其臨床效果。
  3. When two corrugated diaphragms are joined at the outer edges, the unit is referred to as a capsule.

    當兩個波紋膜片在邊緣處粘結時，就構成一膜盒。
  4. The conjunctiva secretes mucus.

    結膜分泌粘液。
  5. Specification for insulating materials based on mica - specifications for individual materials - polyester film - backed mica paper with a b - stage epoxy resin binder

    雲母基絕緣材料規范.第3部分:單項材料規范.第4節:用b級環氧樹脂粘合劑粘結的聚酯薄膜襯底雲母紙
  6. Specification for insulating materials based on mica ; part 3 : specifications for individual materials ; sheet 4 : polyester film - backed mica paper with a b - stage epoxy resin binder

    雲母基絕緣材料規范.第3部分:單項材料規范.第4活頁:用b級環氧樹脂粘合劑粘結的聚酯薄膜襯底雲母紙
  7. Specification for insulating materials based on mica. part 3 : specifications for individual materials. sheet 4 : polyester film - backed mica paper with a b - stage epoxy resin binder

    雲母基絕緣材料規范.第3部分:專用材料規范.活頁4 :用b級環氧樹脂粘合劑粘結的聚酯薄膜襯底雲母紙
  8. The binding principle in pelletizing covers a comprehensive model of interfacial reaction among particles inside green pellets, the formation of binding film during hardening of green pellets by baking to obtain enough strength for a volumetric catalyzed reduction model for cold - bound pellets bearing composite binder and corresponding high temperature reduction system in rotary kiln

    提出了含復合粘結劑的生球強度界面作用力綜合模型，冷固球團礦強度的粘結膜機理，含復合粘結劑的冷固球團礦催化還原體積反應機制及全窯高溫快速還原熱工制度。
  9. Optical coatings - part 1 : testing of the adhesion by storing in deionized water and in salt water

    光學薄膜.第1部分:脫離子水和鹽水中貯存粘結強度試驗
  10. Optical coatings - part 2 : testing of the adhesion by boiling in deionized water and in salt water

    光學薄膜.第2部分:脫離子水和鹽水中煮沸粘結強度試驗
  11. Ocular lids synechia was happened in 1 eye. 2 eyes were treated by 3 times of amniotic membrane transplantation and with the better recovery of 0. 2 visual acuity

    瞼球粘連發生1例，有2例前後做了3次羊膜移植，才使角、結膜基本愈合，視力提高到0 . 2 。
  12. Test method for adhesion strength of bondable films to substrates in ribbon - wire bonds

    綁線連接時可粘性膜同襯底的粘結強度的試驗方法
  13. Standard test method for flexibility determination of supported adhesive films by mandrel bend

    用芯軸彎曲試驗法測定承托粘結膜撓曲度的標準試驗方法
  14. On the base of the development of thick film pastes technology, ru - based thick film resistor pastes have been studied due to select conductive phase and inorganic binder. state - of - the - art techniques such as rolling, screen printing and sintering were used for sample preparation. effects of ingredients, printing parameters and sintering parameters, microstructure on the properties of thick film resistor ( trf ) have been analyzed with xrd, sem, dsc and electrical tests

    本文在跟蹤國內外厚膜漿料技術發展的基礎上，以釕酸鉍/銀系厚膜電阻漿料為研究對象，通過選用合適的功能相和無機粘結相成分，以三輥軋制、絲網印刷和高溫燒結等制備工藝為技術特徵，採用xrd 、 sem 、 dsc等分析方法和電性能測試手段，系統的研究了漿料中各相的成分配比、制備工藝參數，以及膜層微觀結構對厚膜電阻性能的影響規律。
  15. The adsorption of polymer chains at the sio2 surface avoided the coherence between the nascent hollow fibers, improved spinning conditions and hollow fiber bearing. the addition of ca further improved mechanical property of membrane, but pressure - resiposivity became weak. by controlling polymer and sio2

    通過對sio _ 2填充pu溶液紡絲成形研究發現，因sio _ 2對pu紡絲液相分離條件的改變及對pu大分子的吸附，有效防止了pu初生纖維的粘結，提高了pu紡絲溶液的可紡性，改善了pu中空纖維膜的支撐性。
  16. Standard guide for preparation of concrete surfaces for adhered bonded membrane waterproofing systems

    用水密材料粘結薄膜制備混凝土表面的標準指南
  17. Tests relating to pavements. waterproofing materials for structures. determination of cracking stregth. part 1 : tests on adhesive thin film

    路面試驗.結構用防水材料.開裂強度測定.第1部分:膠粘薄膜試驗
  18. Standard guide for application of fully adhered, cold - applied, prefabricated reinforced modified bituminous membrane waterproofing systems

    完全粘結的寒冷條件下使用的預制增強改良瀝青薄膜防水系統應用的標準指南
  19. Aerospace ; expanding adhesive films for structural parts ; technical specification

    航空航天.結構零件用膨脹粘結膜.技術規范
  20. Aerospace - adhesive films and primers for structural assemblies - technical specification

    航空航天.結構組件的粘接膜和底層塗料.技術規范
分享友人
分享到 Line

分享到臉書