系統油 的英文怎麼說

中文拼音 [tǒngyóu]
系統油 英文
system oil
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : Ⅰ名詞1 (事物間連續的關系) interconnected system 2 (衣服等的筒狀部分) any tube shaped part of ...
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • 系統 : 1. (按一定關系組成的同類事物) system 2. (有條理的;有系統的) systematic
  1. Water system. oil pressure actuator. type and size

    .壓接力器.型式與尺寸
  2. The mixture of hydrogenated oils is pumped into the closed system and the fat solidifies on small refrigerated cylinders.

    把混合的氫化抽壓進密封式脂便在小的冷凍滾筒上結晶。
  3. The system uses the pc and the at89c52 as the control center of the system. the pc optimizes the control parameters as the calculation control unit. the at89c52 receives the various parameters by serial communication with the power measurement system and the fuel consume measurement system and the emission measurement system and the ecu and so on, then sends into pc by sharing the ram with the pc as the communication control unit

    採用pc機和單片機at89c52為上位機,以pc機作為計算控制單元,對發動機控制參數進行優化;單片機作為通訊控制單元,與作為下位機的測功器加載耗測量、排放測量以及發動機電控單元ecu等子進行串列通訊接收各參數,並通過與pc機共享ram送入pc機。
  4. The autonomous underwater vehicle which carries liquid oxidizer and liquid incendiary agent and uses the outside seawater as coolant request the oxidizer 、 incendiary agent and coolant can supply the power system according to accurate proportion and reasonable flow on any condition. the system should have small volume and light weight and should be easily realized. the system and control mode introduced in this article can fit these requirements well

    控制或降低液壓系統油液的污染度和提高液壓元件的污染耐受能力是確保液壓可靠工作的兩個重要方面,本文分析了液壓柱塞泵所在系統油液污染特性一定時影響泵污染耐受能力的諸多因素,指出了在結構形式確定的條件下設計高污染耐受度液壓柱塞泵所要求的摩擦副材料與主要表面工藝
  5. Ntu " khpi " is the only higher education institution that trains specialists for such important branches of machine - building as turbine construction for atomic, thermoelectric, hydraulic power engineering, heavy electric machine - building, tractor - building, computer control systems for internal combustion engines, boiler - and reactor manufacturing, fat technologies and fat substitutes technologies, tank - building, electrical insulation, cable and condenser engineering

    哈爾科夫工業大學是唯一一所培養下列重要部門的機器製造業專業人材:原子能、火電和水電渦輪機製造,重型電機製造,拖拉機製造,內燃機、鍋爐和反應堆的計算機控制技術和替代技術,坦克製造,電氣絕緣,電纜和電容器製造。
  6. After putting cn6 - 35 / 9 steam turbine unit of nanjing chemical industry co into operation, serious vibration of the servomotor and oil - pipe in the governing system had occurred

    摘要南京化學工業公司cn6 - 35 / 9汽輪機組投運后,調節系統油動機及管道嚴重振動。
  7. Study on leaky fault mechanism of hydraulic fluid of self - propelled artillery

    自行火炮液壓系統油液內泄漏量數學模型研究
  8. Based on this method, design the system oil circuit and constant - pressure hydraulic power station as well as the hydraulic manifold block, measuring platform, electrical cabinet and reclaiming oil tank

    在此源方案的基礎上,設計出測量系統油路、源泵站,同時進行了液壓集成塊、測量臺架、電氣控制櫃和漏回收箱的設計。
  9. Detga - a sereies of bearing and circulating oils. manufactured from high viscosity index paraffinic base oils, prssessing excellent natural demulsificationnproperties. effective additives further enhance oxidation stability. recommended for applications where the extra load carrying characteristics are not required. suitable for lubrication of machine guides, bearings and spindies, aie line lubrication of maching tools, ring liled and wick feed bearings, and light duty gear and hydraulic systems

    德佳-一列軸承及循環系統油,由高粘度指數石蠟烴基礎製造,具有極佳之天然抗乳化性,有效的添加劑提高了抗氧化性能,特別推薦于輕度負荷的操作,可應用在機床導件、軸承、錠子、氣動件潤滑、環及繩潤滑軸承等,甚至是輕負荷及液壓
  10. Design of the pressure oil supply units of lubrication system of the hydraulic turbines

    水輪發電機組潤滑系統油壓裝置的設計
  11. Cetnralized lubrication pressure indicator

    集中潤滑系統油壓表
  12. Ship systems and equipment hydraulic systems - filter selection parameters

    船舶和設備液壓.濾選用參數
  13. A detailed description is given of the problems in the channels for oiling of common oil systems in the large sets of ammonia units and the cleaning method and procedure

    摘要詳細介紹了合成氨裝置大機組公用系統油路存在的問題、清洗方法、步驟。
  14. Oil pollution analysis and example of its control for hoist hydraulic system

    啟閉機液壓系統油液污染分析及控制實例
  15. Application of fuzzy control in temperature controller of hoist lubricating system

    模糊控制在起重機潤滑系統油溫控制中的應用
  16. Based on neural network theory, it takes pressure of upper cavity as secondary variable and punching power as primary variable to build model of soft sensing. thus punching power can be predicted using system pressure because of their functional relation. this type of measurement technology provides a new method to parameters measurement which is n ' t easy to got directly

    以液壓缸上腔壓力為輔助變量,樁錘下打力為主導變量,利用函數型神經網路理論建立了兩者之間的軟測量模型,找到了液壓系統油液壓力和樁錘下打力之間的函數關,從而為獲取不易直接測量參數提供一種新方法。
  17. This test - bed is made of five part, oil supplying system, oil heating system, specimen constant temperature system, position control system and loading system

    該試驗臺共有五個部分,包括供液加熱、試件恆溫、位置控制和液壓伺服加載
  18. Water system. oil drive device

    .壓驅動裝置
  19. By the end of 2001, its estimated productivity has been amounted to 287 106 t. in this paper, based on regional sedimentary settings, sedimentary theories, seismic reservoir prediction and reservoirs description technologies, fine reservoirs description is done to upper guantao after overall and systematic researches into stratigraphic models, structural models, sedimentary microfacies, reservoirs " heterogeneity, fluid properties, reservoirs " temperature / pressure system, oil - water relationship and reservoir types

    研究過程中從區域沉積背景、沉積學理論、地震儲層預測技術及藏描述綜合研究方法出發,對勝利海上埕島田館上段地層模型、構造模型、沉積微相、儲層非均質性、流體性質及藏溫度、壓力水關藏類型均進行了全面地研究。
  20. Marine lubricant series. part 3 : marine system oils

    船用潤滑列產品第3部分:船用系統油
分享友人