純化磁鐵 的英文怎麼說
中文拼音 [chúnhuàcítiě]
純化磁鐵
英文
purifying magnet- 純 : 形容詞1 （純凈; 不含雜質） pure; unmixed 2 （純粹; 單純） simple; pure and simple 3 （純熟） skil...
- 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
- 鐵 : Ⅰ名詞1 （金屬元素） iron （fe） 2 （指刀槍等） arms; weapon 3 （姓氏） a surname Ⅱ形容詞1 （形容...
- 純化 : purification; purifying; depuration; edulcoration; purify
- 磁鐵 : [物理學] magnet; ferromagnet; magnetic-iron
-
The interstitial net and aggregates may be of solid sulfide but most contain magnetite and silicate in widely varying proportions.
粒間網線及集結體可以是純硫化物，但大多數含有不同比例的磁鐵礦及硅酸鹽礦物。The raw materials, the composition, the time of milling, the calcining temperature, the different additives, the sintering temperature and the sintering parameters were investigated. the result showed : it was advantaged to obtain high initial permeability mnzn ferrite with stable frequency characteristic using high - purity raw materials ; in order to obtain mnzn ferrite with high properties, we must control strictly the composition ; it could improve the properties of mnzn ferrite by optimizing calcining temperature. the lower calcining temperature made the permeability higher, and the higher calcining temperature could promote the frequency characteristic of permeability ; we chosen the right time of milling according to the requirement of power diameter ; in order to improve the properties of mnzn ferrite, it is necessary to add effective additives. in this dissertation, the influence of bi2o3 、 moo3 、 k2co3 、 co2o3 were investigated ; the sintering temperature, the time of heat - retaining and sintering parameters were the key factors of preparing high permeability mnzn ferrites
研究結果表明:採用高純度的fe2o3有利於獲得高起始磁導率且頻率特性優良的鐵氧體;為了制備所需性能的鐵氧體，需要嚴格控制配方中各種原材料的含量，優化配方;由於粉體活性受預燒條件的影響，所以對不同要求的鐵氧體選擇的預燒條件就不一樣，適當降低預燒溫度有利於獲得較高的起始磁導率，而為了獲得良好的頻率特性可以適當地提高預燒溫度;根據對粉體顆粒粒徑的不同需求，可以選擇不同的球磨時間;而有效的添加劑是改善材料性能的必要條件，本文在添加劑的研究中主要對bi2o3 、 moo3 、 k2co3 、 co2o3的影響分別作了詳細地討論;燒結溫度、保溫時間和燒結氣氛是高磁導率mnzn鐵氧體制備最關鍵的工藝，適宜的燒結工藝可以獲得理想微結構和組成，從而得到高性能的鐵氧體材料;而從材料的微結構上來看，要提高材料的截止頻率，就要適當地細化晶粒、增加晶粒內部的氣孔。By successful solution of non - linear magnetic fields and revision of the program, we can reach following conclusions : in the computation of nonlinear magnetic fields, if iteration method is used, under - relaxation is necessary when amending the permeability distribution in soft magnetic materials ; and when < wp = 5 > calculating the equivalent current density in permanent magnets, under - relaxation is not a necessity ; when searching for permeability values by interpolation method on the demagnetization curve of soft magnetic materials, if a fixed saturation point is set, around this point an abrupt change of permeability values will be obtained ; this sudden change may cause a little problem in the smoothness of magnetic field distribution ; because the magnetic circuits of microwave tubes are too complicated, in the author ' s view, to describe the working state of a magnet system, the working points of magnets can not do it properly but average energy production of magnets will serve ; as to indicate the quality of a magnet system design for microwave tubes, the efficiency of magnetic energy utilization will be a very good criterion
由此得出結論，在非線性磁場計算中：採用迭代法的情況下，在各迭代循環之間進行磁導率修正時，一個欠鬆弛迭代過程是必需的；對永磁體中的等效電流修正時可以不作欠鬆弛迭代；在純鐵的磁化曲線上指定某一個固定的磁感應強度為磁飽和值，會使得插值求出的磁導率在該磁飽和值附近有一突變，這一突變對計算結果中磁場分佈變化的光滑性稍有影響。在微波管磁系統設計中，由於微波管磁路比較復雜，作者認為磁體的工作點並不能很好地反映磁體的工作狀態，而採用平均磁能積為衡量磁體工作狀態的標準更加符合微波管磁系統的實際情況；要表示磁系統設計好壞的程度，則用磁能利用的效率為標準更好。
分享友人