級間耦合法 的英文怎麼說

中文拼音 [jíjiānǒugěfǎ]
級間耦合法 英文
interstage coupling method
  • 級 : Ⅰ名詞1 （等級） level; rank; grade 2 （年級） any of the yearly divisions of a school course; gra...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  2. By means of trigonometrical progression method and the mainline track spectrum, the sample function of the chinese mainline railway track random geometric irregularity is simulated. with the data obtained from track geometry inspection car on qinhuangdao - shenyang special line for passenger transport and arma time series model, the sample function of high - speed railway track random geometric irregularity are simulated. based on existing literature, the artificial bogie crawl waves at various different speeds are randomly simulated

    根據我國干線鐵路軌道譜，採用三角級數法模擬出干線鐵路和準高速鐵路軌道不平順的樣本函數；根據秦沈客運專線高速試驗段軌檢車資料，採用arma時間序列模型模擬了高速鐵路軌道不平順隨機樣本函數；在既有研究資料的基礎上模擬出各種速度客車構架人工蛇行波；用隨機變量描述道床橫向剛度，並進行了隨機模擬；將振動理論和穩定理論結合建立系統的分析模型和運動方程；根據monte ? carlo法編制了車輛?軌道耦合系統隨機振動分析程序，進行了無縫線路隨機動力響應分析，通過試驗對計算模型、計算方法進行了驗證。
  3. Secondly, a network based on multi - terminal components modeling methodology was applied to model mems at system - level by the analogy and mixed - signal modeling tool of vhdl - ams, for the system - level model of mems is a mixed signal model, which has attributes of multi - energy domains coupling, multi - signals mixed and interacting between discrete - event subsystems and continuous - time subsystems. with this method, the whole system can be divided into some subsystems defined as multi - terminal components ; the behavior of the subsystems depends only on their terminal signals ; the information exchange between subsystems was done by the signals at their terminals. the continuous - time systems or discrete - event systems can be modeled and simulated with this method, which satisfied the requirements of nonlinear systems and large signals analysis

    同時，針對mems的系統級模型是一個混合信號模型，具有多能量域耦合、多信號混合、離散事件子系統與連續時間子系統交互的特點，使用vhdl - ams作為混合信號模型建模的工具，採用多埠組件網路建模方法建立了mems系統級模型，把微型機電系統分解為多個子系統或組件，各子系統被定義為多埠組件，子系統的內部行為通過其埠行為來描述，子系統間的能量與信號的交換通過組件的埠映射來實現，從而實現了對連續時間系統和離散事件系統的建模與模擬，滿足了非線性系統以及大信號分析要求。
  4. Through the model the inverse dynamic problem of stewart platform is solved and a foundation is made for stewart platform control used for 500m lt. meanwhile all the restrained forces acted at joints are found which provide analysis condition for the mechanism design. a simplified resultant force acted on the cabin by stewart platform is given which makes it possible to eliminate the dynamic coupling between the two subsystems by means of active vibration control

    基於newton - euler方法，建立了充分考慮動平臺慣性、支腿慣性、關節摩擦等因素的stewart平臺控制動力學模型，解決了已知動平臺運動規劃，求關節驅動力的動力學逆問題，為準確實現lt500m原型stewart平臺控制奠定了基礎；解出了各關節處的約束反力，為平臺機構設計提供了力分析條件；簡化給出了平臺對饋源艙的反作用力，使得採用振動主動控制技術消除兩級子系統之間的動力耦合成為可能。
  5. Due to a & b double flats setting of stp ( signalling transfer point ) in different place, and working on mode of payload - sharing on signalling links ( couple links ) between sp ( signalling point ) and stp, the calling signalling sequence cannot be collected completely from single stp. thus it is difficult to synthesize signalling affair in the signalling supervision system. the first, this thesis illuminateds network architecture of no. 7 signalling network and no. 7 signalling centralized supervision system

    由於七號信令網的信令轉接點設備stp （ signallingtransferpoint ）採用a 、 b雙平面異地設置，下一級的信令點設備sp （ signallingpoint ）至上一級的一對stp之間的信令路由採用負荷分擔方式工作， sp至stp對的負荷分擔鏈路形成耦合鏈路，導致在一個stp處無法採集到完整的呼叫信令序列，這樣就給監測系統核心部分之一的信令事件合成帶來了極大的難度。
  6. Traditional eai technology is confined to software development mode and system integration methods, which lead to compact coupling among enterprise application systems, and blocks enterprise " s system upgrade and development

    傳統的企業應用集成技術受軟體開發模式和系統集成方法的限制，造成了企業的各個應用系統之間緊密耦合的狀態，不利於企業的系統升級和拓展。
分享友人
分享到 Line

分享到臉書