紫膠醇 的英文怎麼說

中文拼音 [jiāochún]
紫膠醇 英文
laccol
  • : Ⅰ形容詞(紅和藍合成的顏色) purple; violet Ⅱ名詞(姓氏) a surname
  • : Ⅰ名詞1 (某些具有黏性的物質) glue; gum 2 (橡膠) rubber 3 (姓氏) a surname Ⅱ動詞(用膠粘) st...
  • : Ⅰ名詞1 [書面語] (含酒精多的酒) mellow wine; good wine2 [化學] (有機化合物的一大類 含羥基的烴化...
  1. Method for the determination of rutin, myricetin, quercetin, kaempferol, apigenin, pinocembrin, chrysin, galangin contents in propolis - lc - ms - ms detection method and lc - uv detection method

    中蘆丁楊梅酮槲皮素莰菲芹菜素松屬素苛因高良姜素含量的測定方法液相色譜-串聯質譜檢測法和液相色譜-外檢測法
  2. The gel by sodium alcoholate method, added benzoylacetone, have the obvious uv absorption peaks at 265nm and 337nm respectively. when the gel was placed in air, the chelate did n ' t have change. the absorption peak decreased until disappeared when the films were irradiated by the ultraviolet light with the relevant wavelength, which indicated that the films were obviously photosensitive

    ( 4 )通過三種方法制備感光性的sno _ 2 : sb ( ato )溶,採用鈉法,添加苯酰丙酮制備的二氧化錫凝膜,在265nm和337nm處存在明顯吸收峰,空氣中放置,所形成的螯合物不發生變化,用相應波長的外光照射時,這個吸收峰會減小直至消失,表明薄膜具有良好的感光性。
  3. Especially, the nano - iron and nano - tungsten sols as well as their powders were characterized in detail by xrd, ft - ir, uv - vis, xfs, tem, sem, edax and so on. another new method is put forward firstly to estimate the addition of dispersants and its effect by uv - vis

    重點選取納米鐵乙和納米鎢乙以及其中的納米顆粒進行了詳細表徵,所涉及的測試方法包括x射線衍射、傅立葉紅外光譜、外-可見光譜、熒光光譜、透射電子顯微鏡及選區衍射、掃描電子顯微鏡及微區能譜分析等等。
  4. In this thesis, we studied optical properties of eu3 + and mn2 + doped zns nanocrystallites. the new results are as follows : 1. zns : mn2 + ethanol colloids were synthesized and dispersed into pvb film. the luminescence enhancement of mn2 + was observed after ultraviolet irradiation

    制備出納米zns : mn2 +乙和pvb薄膜樣品,均觀察到外光輻照下的熒光增強現象,增長倍數超過20倍,高於以前的報導,並發現樣品在固體薄膜和溶中有不同的熒光增強行為。
  5. The tio2, cds and cds - tio2 films on the common glass substrate were prepared, respectively, using ti ( oc4h9 ) 4, cd ( cooch3 ) 2 and scn2h4 as raw materials by sol - gel method. the influences of manifold preparing parameters ( such as the concentration of sol, the amount of the peg. the number of coatings, the heat - treated temperature and time ) on the structure and performance were studied

    本文採用溶-凝技術,以鈦酸丁酯、乙酸鎘和硫脲為原料,以普通玻璃片為載體,制備了納米tio _ 2薄膜、 cds薄膜和cds - tio _ 2復合半導體薄膜,研究了制備過程中多種制備參數(如溶的濃度,聚乙二( peg )的加入量,鍍膜層數,熱處理溫度及時間)對薄膜結構和性能的影響,採用x -射線衍射( xrd ) 、掃描電鏡( sem ) 、能譜分析( edxa ) 、外-可見吸收光譜( uv - vis )等測試手段對各薄膜進行了結構和物性表徵。
分享友人