細小更改 的英文怎麼說

中文拼音 [xiǎogēnggǎi]
細小更改 英文
slight changes
  • : 形容詞1 (條狀物橫剖面小) thin; slender 2 (顆粒小) in small particles; fine 3 (音量小) thin ...
  • : Ⅰ形容詞1 (體積、面積、數量、強度等不大) small; little; petty; minor 2 (年紀小的; 年幼的) youn...
  • : 更副詞1. (更加) more; still more; even more 2. (再,又) further; still further; furthermore
  • : Ⅰ動詞1 (改變) change; transform 2 (修改) revise; alter; modify 3 (改正) rectify; correct 4 ...
  • 細小 : very small; tiny; trivial; micr-; micro-; -ling
  • 更改 : change; alter; alteration
  1. Several materials with large coefficient of expansion were selected to make packaging components, and it was found that the packaging materials have good temperature sensitivity and compatibility with optical fibers. experimental accuracy and repetition of fbg temperature sensitivity and compensation were discussed. have selected several materials which has bigger coefficient of expansion to do packaging components, have made many temperature experiments, there have not flaws, such as aging, crackle, absciss layer, packaging materials have good temperature sensitivity and compatibility with optical fiber ; have designed the simple and practical packaging components, have performed a serials of experiments about accuracy and repetition of fbg wave - length, have obtained the first step conclusion ; have analyzed the result and made comparison between the result of different experiment, have summarized the best packaging effect and several rules to reduce mistskes

    本文所做的主要工作包括以下幾個內容:一、選取了常見的熱膨脹系數大的材料製作封裝元件,經過多次一80到80反復測試,封裝元件沒有出現老化開裂、封裝裂紋、空洞、離層等缺陷,封裝材料具有良好的溫敏穩定性及復用性,與光纖相容性較好;二、對光纖光柵進行簡單、實用的封裝處理,就封裝效果的優劣性、波長測量的準確度、重復性和封裝時產生的波長損失等方面進行了一系列的實驗,得出了初步的結論;三、對溫敏和溫度補償式封裝的實驗數據進行了詳的分析和對比,從數字上對溫變過程中光纖光柵中心波長的變及溫變曲線進行了定量的分析,在大量實驗數據分析結果的基礎上,總結出哪種材料封裝效果好,以及如何有效的減實驗誤差。
  2. The results show that, when increasing the feed rate of the grinding wheel, decreasing the rotating speed of the wafer chuck table and using coarser grit grinding wheel, the material removal rate in the wafer rotating grinding increase, the feed rate of the grinding wheel has greater influence on the material removal rate ; when suitably increasing the rotating speed of the grinding wheel, decreasing the feed rate of the grinding wheel and using finer grit grinding wheel, the wafer surface roughness can be reduced ; there exists a critical rotating speed of the grinding wheel ( about 2300rpm ), beyond which the material removal rate evidently decreases and the spindle motor current and wafer surface roughness steeply increase ; when the grit size of the grinding wheel is finer than # 2000, the material removal rate decreases and the wafer surface roughness has no obvious improvement

    研究結果表明,增大砂輪軸向進給速度和減工件轉速,採用粗粒度砂輪有利於提高磨削矽片的材料去除率,砂輪軸向進給速度對材料去除率的影響最為顯著;適當增大砂輪轉速,減砂輪軸向進給速度,採用粒度砂輪可以減磨削表面粗糙度;在其它條件一定的情況下,砂輪速度超過一定值會導致材料去除率減,主軸電機電流急劇增大,表面粗糙度變差;採用比# 2000粒度的砂輪磨削時,材料去除率減,矽片表面粗糙度沒有明顯善。
  3. To meet the service support requirements of the maintenance and repair vehicle for field medical equipment, the analysis of electric power for war - time maintenance and repair, generating set selection and installation design are performed. a series of technique improvements are also involved in, which make the generating system and vehicle integral design merge into an organic whole and provide a scientific and convenient electric power support for war - time maintenance and repair

    為使車載發電機好地滿足野戰衛生裝備維修車開展維修保障需要,在車輛研製過程中,對戰時維修用電進行了詳的需求分析、發電機組選型和安裝設計,並對常規配置的型柴油發電機進行了一系列的技術進,使得野戰衛生裝備維修車的發電系統與車輛整體設計融為一體,為戰時開展維修工作提供科學、便捷的電力保障。
  4. Through the investigation on the infiltration and cracking of concrete with addition of polypropylene fibers. the suitable addition of polypropylene fiber to minish the infiltration, crack and autoshrinkage of concrete was gained. the experiments indicate that polypropylene can minish concrete ' s infiltration, cracking and autoshrinkage, and the native fiber is more efficient than that made in brazil. all above proved that it is n ' t right that the finer the polypropylene fiber the better the performance of concrete

    試驗結果表明聚丙烯纖維能有效善混凝土的抗滲、抗裂性能並能有效減混凝土的自收縮,國產聚丙烯纖維在減混凝土的自收縮、善混凝土的抗滲、抗裂性能方面優于巴西聚丙烯纖維,說明了聚丙烯纖維善混凝土性能並不是越越好。
  5. Although many suggestions have been put forward, they do not adequately address the problems faced by small open markets, specifically the possibility that they could be destabilised by the volatility of international capital to such an extent that the viability of their financial systems could be put in danger

    關于國際金融革的建議已提出過不少,但都未能充分處理這些經濟體系所面對的問題。具體來說,對于國際資金流向大幅波動沖擊及開放的金融體系,使其無法維持有效及穩定運作的隱憂,至今仍未就適當的處理方案達成國際共識。
  6. Street - level life : every effort has been made to provide the public with street level access and an interesting street level experience. podiums and deckings have been eliminated. there are no underpasses or tunnels through the buildings

    以上各項建議的目的,是為公眾創造便捷的地面通道,與及有趣的街道活動體驗,因此撇除了露天平臺及架空樓層的設計,建議計劃中,添馬艦政府總部大樓為建於地面及體積較的建築物。
  7. In the first part of this thesis, on the base of analyzing the wavelet theory and discussing the wavelet coefficient, a kind of shapiro code algorithm is put forward. it efficiently organizes the wavelet coefficient and enhances the compression

    第一部分在詳研究波理論的基礎上對波系數的組織形式進行了討論,提出進型shapiro編碼演算法,有效的組織波系數並對編碼序列進行一次預編碼,提高了壓縮比。
  8. Moreover, government should do further reform on the system of science and technology ; consolidate the establishment of technology innovation system ; perfect regulations, increase investment, enhance the protection of intellectual property rights ; increase investment for fundamental research, encourage to combine the study for innovation and the research on industrialization ; make attractive rules to international talents, encourage innovation and development of chinese science and technology ; actively guide and create venture capital market, and provide multidimensional access to finance for biotechnological industry

    這一戰略目標的實現應以「合作開發、進創新、市場分和成本最」為主要方向,分三步完成。同時指出政府為發展中國醫藥生物技術產業,應在制定產業發展政策、強化國家科技創新體系建設、加強知識產權保護、鼓勵基礎性創新研究和產業化研究相結合、制定吸引世界性創新人才的政策以及培育風險投資市場等方面發揮積極的作用。
  9. Later on, after elaborating the disadvantages of the old methods in detecting and recognizing moving objects, a series of corresponding approaches are proposed, such as grid scan, local tracking bug and dynamic window in object tracing to reduce the huge data needed to be processed, maximum and minimum for selecting a proper segmentation threshold and improved conversion from rgb model to hsv and so on to decrease the influence of inhomogeneous lighting and the color noise, a bilinear interpolation in each quadrant to eliminate the bad effect on the recognition precise because of the distortions of the camera. after that, much emphasis is given on application study in pattern recognition with a feed - forward neural network. both the basic bp algorithm and improved bp algorithm in the study process are described in detail, and the later is used to quicken convergence speed and improve validity of the network

    然後,分析和闡明了傳統的運動目標檢測方法的不足,並在此基礎上結合研究中的實際實驗環境,提出了一系列解決方法,包括針對降低龐大數據量而提出的網格掃描、局部「跟蟲」追蹤和動態窗口掃描等目標檢測方法,針對實驗環境中光照不均和顏色干擾提出基於人機交互的最大最值閾值選取方法和引入進的rgb模型到hsv模型的轉換方法,為消除圖像畸變對識別精度的惡劣影響而採用的通過控制點進行雙線性插值進行畸變校正的方法;緊接著,概述了神經網路的發展歷史和幾種常用神經網路模型的特點,重點研究了前饋型神經網路在模式識別中的應用問題,詳闡述了基本的bp演算法和學習過程中bp演算法的進,從而使網路收斂速度快,解決問題有效,並在此基礎上,設計了一個基於bp神經網路的運動目標識別系統,給出了實驗結果。
  10. Component allows users to select a font, as well as change its display aspects, such as its weight and size

    組件選擇字體,並可以字體顯示方式,例如粗和大
  11. And then, to improve the living function of road space and amend simpleness of function and form, we must analyse road space from these aspects, such as whole control, detail design and the image of road space with residents activity etc. so to establish the living function of road space in residential quarter, we need to set up the road system, confirm scale, elect transport mode in whole and create site adjust criterion, use original landscape elements in detail. in addition, advancing the visualization of road space is also one way to set up the connection between residents activity and the image of road space. at last, we introduce several successful cases in foreign country and analys a case in our country. we hope we can go on the research in - depth in the furture

    然後,我們分別從整體控制、部生成及道路意象與居民活動的互動來善道路的單一和簡化,提高其可居性。這樣,通過對道路空間宏觀上道路網路的形成、規模的確定、交通方式的選擇和節上場所的創造、尺度的調節、原風景元素的運用,以及通過提升道路形象來形成道路意象與居民活動的互動,從而建立一種可居的居住區道路空間。最後,介紹和分析了幾個國外成功的住區空間可居性規劃理念和國內的設計實踐,並期待隨著區的發展,在將來作深入的研究。
分享友人