細晶 的英文怎麼說

中文拼音 [xìjīng]
細晶 英文
cryptomere
  • 細 : 形容詞1 （條狀物橫剖面小） thin; slender 2 （顆粒小） in small particles; fine 3 （音量小） thin ...
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  1. Severe plastic deformation ( spd ) processing, especially equal - channel angular processing ( ecap ) of steel and other iron - based alloys, has achieved increasing interest recently because of the potential for obtaining ultrafine grains and improving the properties

    近年來，強烈塑性變形特別是鋼和鐵基合金的等徑彎曲通道變形因為具有獲得超細晶組織和改善性能的潛力，引起了各國研究人員的很大興趣。
  2. Riebeckite aplite - granite

    鈉閃細晶花崗巖
  3. Biotite aplite granite

    黑雲細晶花崗巖
  4. Quartz diorite aplite

    石英閃長細晶巖
  5. Soda syenite aplite

    鈉正長細晶巖
  6. Soda aplite granite

    鈉細晶花崗巖
  7. Chen p. r., chen x. m., ni p., wang w. c. et al., 1997, discovery of chalcopyrite daughter mineral in polyphase fluid inclusions from yanyuan porphyry copper deposit, sichuan province

    朱金初，李人科，周鳳英，王汝成等， 1996 ，廣西栗木水溪廟不對稱層狀偉晶巖?細晶巖巖脈的成因討論。
  8. We find that the petrology characteristic of all the samples have no characteristic of meteoric water such as geopetal structure, infiltrative sand, ( uniform cement and gravitational cement on base of the research of the dolomite in the regions. on the dot diagram of combination of mgco3 ( mol % ) and sr, the dot are all close to the line of seawater whether they are microlite - crystalline penecontemporaneous dolostone or diagenetic dolostone of various crystals. the 87sr / 86sr value of dolostone or matrix is less than the one of sparry calcite in cave or vein, and close to the value of seawater

    通過本區白雲巖的研究發現：已有的白雲巖樣品的巖石學特徵沒有顯示出如示底構造、滲濾沙、新月型膠結物和重力膠結物等大氣淡水作用的特徵；在白雲石mgco _ 3mol百分數和白雲石sr含量的投點圖中，無論是準同生成因的泥?微晶白雲巖，還是粉?細晶（或中晶，或細晶以上的不等晶）的成巖白雲巖，均投在海水線的附近；白雲巖（或基質）的~ （ 87 ） sr / ~ （ 86 ） sr比值顯著低於與孔洞或脈中充填的亮晶方解石，且與海水值十分接近， ~ （ 13 ） c和~ （ 18 ） o值顯著高於孔洞或脈中充填的亮晶方解石，也偏向于海水值； mn含量則顯著低於孔洞或脈中充填的亮晶方解石。
  9. Low velocity coupled growth and banded structure of peritectic alloys under directional solidification

    細晶變形鎂合金的研究進展
  10. W - cu composites prepared from the precipitation w - cu powder have higher sintered density, better mechanical and physical property, more homogeneous and finer microstructure than those prepared from w - cu powder by the balling - reduction method. in chapter 5, a combination of homogeneous precipitation and ball - milling process, namely the mechano - thermochemical process was employed to prepare ultra - fine w - cu powder

    其中，球磨w一cu復合粉（ hp一m ）壓坯在1150下燒結30min后，可獲得相對密度大於99 %的幾乎全緻密的超細晶粒w一cu復合材料， w的顆粒度小於0 . 5林m 。
  11. It is also desirable to have a reasonably fine grain in order to obtain ultrasonic inspectability.

    為了獲得良好的超聲波探傷性能，也希望得到合適的細晶粒。
  12. The influence of burning system on the properties and structure of the ceramic capacitors has been studied under the certain temperature system, the optimum sintering temperature of the ceramics was primarily decided by the content of bi2o3 ? 3tio2. the sintering temperature dropped with the adding of bi2o3 ? 3tio2. at the range of suitable sintering temperature, slow heating and low temperature sintering can obtain fine grain and dense structure. it results in the improving of the breakdown voltage for the middle - high voltage ceramic capacitors

    研究了燒成工藝制度對電容器陶瓷性能和結構的影響，結果表明：在一定的升溫保溫時間下，瓷料的最佳燒結溫度主要取決于組成中bi _ 2o _ 3 ? 3tio _ 2的含量， bi _ 2o _ 3 ? 3tio _ 2含量的增加將降低燒結溫度；在合理的燒結溫度范圍內，慢速升溫和低溫燒結將有利於得到細晶緻密結構，從而改善中高壓陶瓷電容器的耐壓強度。
  13. The mechanical capability, dilatability and stability of these microstructures at elevated temperatures were also studied

    並對所得到的超細晶材料的熱穩定性、力學性能和熱膨脹性能進行了研究。
  14. The results indicated that, the fabrication process of ultra - fine grain material is mainly determined by the stress, rotate speed and the flux of cooling water. the grain refining and the hardening effect are mostly affected by the rotate speed and the flux of cooling water. compared with commercial ly12, the invalidate strength and the prolongation rate of the ultra - fine grain material are properly improved in the measurement of compression property ; and the abrupt change of the dilatability of the ultra - fine grain material at 500c is found ; also the phenomena of which the grain size of these microstructures is stable when annealed under 300c is observed

    研究表明，採用本文提出的摩擦壓扭強變形區轉移法可以得到棒狀的超細晶材料，軸向壓力、扭轉速度和溫度是採用該方法制備超細晶材料的主控參數；試件的旋轉轉速和冷卻速度對變形區晶粒細化和硬化效果影響顯著；超細晶ly12的壓縮性能與淬火+自然時效狀態的ly12壓縮性能相比，斷裂強度和延伸率均有一定程度的增強；超細晶ly12的熱膨脹系數在550左右發生明顯的變化。
  15. All main ways of metal strengthening including grain refining strengthening, dislocation strengthening, grain boundary and substructure strengthening, second phase strengthening, solid solution strengthening, as well as trip strengthening and so on, have totally found expression in the adi

    金屬強化的幾種主要方式：細晶強化，位錯強化，晶界與亞結構強化，第二相強化，固溶強化，細晶強化以及trip強化等都在等溫淬火球鐵中得到了體現。
  16. The lath martensite nanometer structure can play the role of fine - particle strengthening and dislocation strengthening as well as coordinate the distribution of dislocation. it is hopeful that the strength and toughness of material with this structure can be increased at the same time

    板條馬氏體組織納米化結構，可起到納米晶粒的細晶強化與位錯強化的聯合作用，並可協調位錯分佈，有望使具有這種組織的材料強度和韌性同時得以提高。
  17. The main intention of this study is to investigate 95 alumina substrates by tape casting process, which will be used as ceramic packages in kinds of integrate circuit ( ic ). high bending strength and fine surface were required as the basic properties of ceramic substrates. in this thesis, based on the research of the tape casting used in ceramic substrates at home and abroad

    本文綜述了國內外研究現狀，著重研究細晶氧化鋁的制備和流延工藝參數的控制，以及細晶95al2o3瓷的制備，研究al2o3原料（包括種類和粒度） 、摻雜改性劑、流延漿料、有機配方等對95al2o3瓷基片性能的影響，獲得最佳流延配方，流延基片綜合性能良好，成功制備了細晶氧化鋁瓷基板。
  18. Ultrasonic peening improves the fatigue strength of welded joints in a ultra - fine grained steel

    超聲捶擊提高超細晶粒鋼焊接接頭的疲勞性能
  19. The results indicated : 1 ) the friction interface can transfer continuously and stably with the imbalance cooling thermo - induce. ultra - fine grain column part can be prepared through it. and ultra - fine grain flat part can be obtained through jointing several ultra - fine grain strips in cooling friction stir processing 2 ) the refined grain size and the hardening result are mostly affected by the rotate speed, the friction press and the deformating temperature

    實驗結果表明： （ 1 ）通過不平衡冷卻的熱誘導作用，實現了棒材摩擦界面的持續、穩定轉移，得到了棒狀超細晶組織；通過強冷攪拌摩擦工藝進行細晶帶合併，能夠得到板狀的超細晶組織。
  20. Cold formed welded structural hollow sections of non - alloy and fine grain steels - part 1 : technical delivery conditions ; german version en 10219 - 1 : 2006

    非合金鋼和細晶粒鋼的冷成形焊接空心結構型材.第1部分
分享友人
分享到 Line

分享到臉書