終終負載 的英文怎麼說

中文拼音 [zhōngzhōngfùzǎi]
終終負載 英文
terminator
  • 終 : Ⅰ名詞1 （最後; 末了） end; ending; finish 2 （指人死） death; end 3 （姓氏） a surname Ⅱ形容詞（...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 負載 : [電學] load
  1. This paper is to propose an open synchronization framework based on agent. it can availably economize network band, cut transfers delay, lighten netword burthen by using sufficiency network computing resource, and access offline

    本文利用agent技術，建立了一個新同步復制系統模型，從而能夠有效地節省網路帶寬，縮短傳輸延遲並充分利用網路計算資源以減輕移動終端的計算負載，在網路斷接的情況下提供對數據的訪問。
  2. Assuming the loop is known to be only a single straight segment of 26awg cable, there is no additive loop or afe noise, and the remote - end is terminated by a high - impedance load for all frequencies, figure 5 shows the resulting selt performance

    假定已知環路只有一個單個的直段26awg電纜，沒有附加的環路或者afe噪聲，對所有的頻率遠端通過一個高祖抗負載終止，圖5給出了selt的性能結果。
  3. This system uses the means of distributing control and concentrating management. the remote terminal ( rt ) controls electrical loads, meanwhile the power system processor ( psp ) controls the whole electrical system. this power distribution system realizes effectively load automatic management

    該系統採用分散式控制、集中式管理的策略，由各個遠程終端（ rt ）控制電氣負載，而由供電系統處理機（ psp ）負責整個電氣系統的綜合控制，有效地實現了負載的自動化管理。
  4. These topologies of inverters are composed of two bi - boost dc / dc converters, they are symmetry. so whole circuit turn into four - quadrant converters, we can control every power mosfet on or off. then we can get sine wave with direct current polarization at the left, at the same we also can get sine wave with direct current polarization phase contrast 180 compared of the left at the right

    這類逆變器由左右二個雙向boostdc / dc變換器構成，左右二邊是對稱的，所以整個電路構成了一個四象限變換器，我們可以恰當控制各功率管的開、關，使左邊的兩象限dc / dc變換器輸出一個帶直流偏置的正弦波，使右邊的兩象限dc / dc變換器輸出一個相差180度帶同樣直流偏置的正弦波形，這樣，負載zl上的電壓是左、右兩個dc / dc變換器電壓的差動輸出，正好可以消掉直流偏置，最終在負載r1上得到的就是正弦波。
  5. This paper deals with the following three topics with regard to the control of multiple manipulators : 1. deprive the kinematics and dynamical equations of two manipulators with identical structure on the basis of geometry theory, one of which has two links, giving the inverse solution to the kinematics of the system which consists of the manipulators and the grasped object ; 2. by use of load - distributing, design a controller coordinating multiple redundant manipulators whose parameters are known

    基於微分幾何理論推導出兩個具有相同結構的二連桿機器人的運動學逆解及與物體所成系統的動力學方程； 2在假設由多個冗餘機器人與物體組成系統的動力學模型確知的前提下，利用負荷分配法，設計了一種不僅能使關節力矩優化且能按照一定比例分配負荷的控制器，解決了以往控制器的一些缺陷，即忽視各個機器人的實際承載力，導致一些負荷力小的機器人卻必須承擔較大的負載，最終損壞機器人； 3
  6. We are concerned that process affinity will stop any workload sharing ; that is, the called ejb will always be on the server of the calling ejb

    我們擔心進程關聯會阻止任何工作負載共享；也就是說，被調用的ejb始終位於調用ejb的服務器上。
  7. But the contemporary p08 system uses a large amount of terminals and the distance between terminals is enlarged. as a result, the host overloads and the terminal has slow responsibility

    而現在的pos系統中， pos終端數量增加，距離增大，導致后臺主機負載過重，終端反應遲鈍，需要採用更為有效的系統集成方案。
  8. Asn : both electric utilities and end user are becoming increasingly concerned about the power quality. major reasons for the concern load equipment is more sensitive to power quality variations

    電業和終端用戶兩者變得越來越關心關于負載設備的品質，原因對電力品質變動是敏感的。
  9. Through study of match of the system with load, the paper suggested thin hole as damping parts which can make system working in optimal working site and efficiently converting wind energy to heat energy

    通過對系統與負載匹配的研究，提出採用薄壁孔元件作為阻尼元件可使系統始終工作在最佳工作點有效地將風能轉化為熱能。
  10. So the equipment is schemed out to simulate the work - state of aepds, according to the in - out signals of every solid - state power controller ( sspc ) and the stochastic voltage and current of buses. the top - down design method is adopted in the design

    所以作者根據固態功率控制器輸入、輸出信號模擬多路負載，以及匯流條的電壓、電流等在飛機配電系統中的各種工作狀況，研製了「先進飛機配電終端自動測試裝置」 。
  11. By synthetically considering all kinds of attributes of network resources and traffic flows, and introducing the distinguishing function and counting out the transfer - value of the paths, the algorithm will confirm whether the traffic flow is fit to transfer to the new path in order to balance the network load and enhance the utilization ratio of network resources

    該演算法對網路資源屬性和業務流屬性加以綜合考慮，引入判別函數並由此計算出路徑的遷移值，從而確定業務流是否適于遷移，以最終達到均衡網路負載，提高網路資源利用率的目的。
  12. In this paper tio2 / minerals have been prepared using natural minerals as carrier and the industrial metatitanic acid and the industrial sulfate titanium liquid as the raw material based on the effects such as loading capacity of tio2, specific surface area of minerals, different mineral source and preparation cost. the acid treatment and heat treatment of minerals, preparation methods and condition of ticvminerals have been studied, the photocatalytic experiments on samples were tested from degrading methylene blue solution, and some important results as follows : 1

    本研究以天然礦物對tio _ 2的負載能力、比表面積、礦物來源、材料成本等因素為依據，通過對天然礦石載體的活化工藝研究和工業偏鈦酸、工業硫酸鈦液（以下簡稱濃鈦液）為原料制取tio _ 2天然礦物復合材料的制備工藝研究，以及樣品光催化降解有機物的研究，最終制得了具有光催化活性的tio _ 2天然礦物復合材料。
  13. Feedrate planning of continuous micro - line ' s start and end points are discussed, and the constraining conditions, including the machine ' s acceleration and deceleration capability, allowable error of corner machining, maximum acceleration and dynamical behavior of the machine, are established 。

    摘要針對連續小直線段高速高精插補演算法中起始點和終止點的速度規劃，建立了包含機床加減速性能、轉接處誤差控制、最大加速度以及機床負載功率等的速度約束條件。
  14. The conventional connection circuit as the figure shows for two - wired transmitter : handhold terminal palm computer and external communication interface or mainframe communication circuit cannot directly bridges in the ends of power source. but may either meet on field ends a and b or meet on the ends of load resistance b and c. in the above - mentioned case, the circuit are supplied by power source

    對兩線制變送器來說，傳統的連接電路如圖所示：手持終端掌上電腦和外接通訊介面或主機通訊電路不能直接跨接在電源兩端，但既可接于現場兩端a ， b上，也可接在負載電阻兩端b ， c ，兩種情況下，電路都要通過電源來供電， hart規范允許負載電阻為2301100 。
  15. In this chapter, it puts forward a new system about checkpoint, avoiding the domino - effect and livelock. it realizes the storage of process context and other states with the form of executing file in the diskette by using checkpoint system and applying the page switching principles in linux. consequently, when the process has wrong at the checkpoint, it can move out the process in the fault machine, then choose other normal machine, continue to execute from the interrupted point, finally achieve the process migration and load balance of the system

    同時提出一種新的檢查點機制，避免了多米諾效應和活鎖，並且利用檢查點機制，應用linux中頁面的換出原理，實現了對進程的上下文以及其他狀態以可執行文件格式保存在磁盤，從而使該進程能在節點發生故障的情況下，將故障機的進程遷出，然後選擇其他正常節點機，從斷點處繼續運行，最終達到對該進程的遷移，並且實現系統負載平衡。
  16. A system design of the circulation function therapeutic instrument of brain is presented in this paper. an integrated prototype is composed of at89c55 used as system controlling module and a / d, d / a converter and liquid crystal display device used as a terminal display module to realize the output of dynamic load and permanent flow through digital synthesis

    本文提出了一種設計智能腦電治療儀的系統方案，以at89c55為核心控制模塊，輔以d / a 、 a / d成為全反饋閉環系統，使用液晶顯示器為終端顯示設備，實現數字合成動態負載恆流輸出。
  17. 2 for the first time, the author brings forward the concept of " pyramid horn high order mode resonator " and pml - fdtd technique is used to analyze the electromagnetic field distribution in the pyramid horn. the results show that the pyramid horn sensor is much more sensitive than the open ended waveguide or transmission line sensors. the sensor we used is a kind of resonance sensor

    二、首次提出了「角錐喇叭高次模諧振腔」的概念，並且採用pml ? fdtd法分析了角錐喇叭場分佈狀態，從而，得出了角錐喇叭探頭比終端開口波導或傳輸線探頭靈敏得多的原因在於：我們採用的探頭是諧振式探頭，消聲瓦樣品的差別相當于對角錐諧振腔的微擾；採用波導或同軸線探頭，消聲瓦樣品的差別相當于對傳輸線終端負載有一點變化而已。
  18. Numerical results are given to demonstrate the effects of several factors including the number of basis functions, the thickness of waveguide, the terminations of waveguide and different frequency on the radar cross section ( rcs ) of a slot array

    物理光學法用於有限電尺寸導體平板散射的分析。文中給出了縫隙陣列在不同頻率、基函數個數、波導厚度、終端負載等情況下的計算結果。
  19. Finally, in view of the absorbed po ~ ver of the terminated load and the realizablity of couplers, a proper eclectic distribution of coupling degree of couplers is computed synthetically. 2. a small, light, compact, ~ vide band and high performance h - t coupler with lognitudinal dualslot is presented

    根據天線方向圖要求，確定陣面的口徑分佈，在此基礎上，結合慢波線終端負載的吸收系數，以及耦合器耦合量的可實現性，綜合折中考慮，計算選擇出合適的耦合器耦合度分佈。
  20. Acting as the linkage between the transaction end systems and host, the front transaction host serves as application isolation, physical network isolation, message channel management and load balance. and then, the paper introduces xmp and xtp

    用前置機作為會員端接入軟體交易終端與交易主機之間的橋梁，在三層客戶服務器模型中起到應用隔離、網路隔離、鏈路管理和負載均衡等功能。
分享友人
分享到 Line

分享到臉書