組合肋板 的英文怎麼說

中文拼音 [zǔgělèibǎn]
組合肋板 英文
bracket floor
  • 組 : Ⅰ名詞1 （由不多的人員組成的單位） group 2 （姓氏） a surname Ⅱ動詞（組織） organize; form Ⅲ量詞（...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 肋 : 肋構詞成分。
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 組合 : 1 （組織成為整體） make up; compose; constitute 2 （組織起來的整體） association; combination3 [...
  1. Based on the numerical simulation and accuracy analysis to previous slab ' s test with the ansys program, the study of composite wall, with various detail design under potential load action respectively or jointly is carried on and the wall ' s atress behavior and failure mode is obtained, also the influence to wall ' s stiffness and bearing capacity by kinds of factors, including wall ' s shear span ratio, member ' s section, bar arrangement, etc. based on the hammer blow test and stiffness test, a 1 / 3 scale ten - bay model ' s modality parameter and elastic deformation characteristic is analyzed

    在對密肋復合墻板運用ansys ~ （ （ ? ） ）程序進行數值模擬、分析驗證的基礎上，對典型組合墻體在不同連接構造和不同荷載效應組合作用下的受力形態和破壞模式進行研究；計算分析了復合墻體剪跨比、邊框柱截面尺寸、邊框柱配筋大小以及墻板內肋梁肋柱配筋等諸多因素對密肋復合墻體承載力及剛度的影響，得出其變化規律。
  2. Thecalculating results show that the composite action between concrete floor and steel beamsgreatly influence the bending bearing capacity and initial rotational stiffness of joints, it shouldbe considered in practical engineer. reinforcement ratio of lengthways reinforcing bar andthe stiffener of web have great influencer on the behavior of connections, while the thicknessof end - plate and degree of shear connection have a litter influence on its behavior

    分析計算結果表明:樓板與鋼梁的組合作用對節點的抗彎承載力及初始轉動剛度的影響非常大，實際工程中節點設計應當考慮這種組合作用;樓板內縱向鋼筋配筋率與柱腹板加勁肋對節點性能影響顯著，而連接端板厚度及剪力連接程度的影響則不是太顯著。
  3. In virtue of finite element program, this paper calculates the model of rc - masonry combination arch bridge in the stages of construction and use in this paper. based on these data, it analyzes the structure behavior of the reinforced concrete arch ribs and the masonry arch ribs using methods of inner force and stress

    本文藉助有限元程序對rc -石砌體組合拱橋的計算模型進行了施工階段和使用階段的計算，並採用應力疊加和內力疊加兩種方法對rc拱肋和石砌體拱板的受力特性進行分析。
  4. Thus it is necessary to study moment resistance, rotation stiffness and rotation capacity of the joints. in this paper, six specimens on end - plate composite beam - to - column joints and two specimens on end - plate composite beam - to - column joints were designed to subject to static load. the factors of m - characteristics about semi - rigid composite joints, including bolts, profiled steel sheeting, beam, column, stiffen rib and reinforcement, are studied

    本文設計了6個端板型鋼-混凝土組合樑柱節點與2個端板型純鋼樑柱節點，通過對這些試件的靜力荷載試驗，重點研究了端板型鋼-混凝土組合節點的彎矩-轉角性能的影響因素，包括高強螺栓、壓型鋼板、型鋼梁、型鋼柱、加勁肋，以及混凝土板內縱向鋼筋配筋率等。
  5. The research suggests that the failure process of the multi - ribbed composite walls under horizontal seismic loads is : the cracks of the infilled silicate bricks and the cracks of the inner rib beams and rib columns - the cracks of the outer frames ; and that the walls can release energy by stages, showing perfect capacities of energy dissipation and collapse resistance

    研究表明：復合墻板在水平地震力作用下，其破壞過程按「填充砌塊?肋梁肋柱?外框架」的順序進行，分級釋放能量；試驗中墻板大部分發生剪切滑移破壞；墻板的平均抗剪承載力、延性指標、耗能及抗倒塌能力明顯優于組合磚墻。
  6. The wall was equaled to an elastic composite slab with silica bricks as main body and concrete rib beams, columns and outer frame as reinforcing fiber. ( 2 ) elastic - plastic stage. the wall was equaled to a rigid frame - oblique compression bar model in which concrete frame was equivalent to a rigid frame while silica brick was equivalent to a oblique compression bar

    （ 1 ）彈性階段? ?將墻體視為一種以輕質砌塊為基體，混凝土肋梁、肋柱、外框為增強纖維的復合材料等效彈性板； （ 2 ）彈塑性階段? ?將墻體視為一個由鋼筋混凝土剛架和與之鉸接的砌塊等效斜壓桿組成的剛架斜壓桿組合模型； （ 3 ）破壞階段? ?將墻體視為肋梁嚴重破損的梁鉸框架模型。
  7. The seperated pair of main ribs section was made up by bridge panel and girder, because its construction is convenient, used widely in the prestressing force concrete cable - stay bridge of large span

    回答：分離式雙主肋截面是由橋面板與邊主梁組合而成，由於其施工方便，在大跨度預應力混凝土斜拉橋中得到廣泛應用。
  8. By using the types of stiffeners, the thickness of the composite panels and the arrangement of the goggle pins as the parameters, mechanical performance tests were made on 9 composite panels

    以加勁肋形式、組合板厚度和栓釘布置為參數，進行了9塊組合板的力學性能試驗。
  9. A new type composite quay - wall panels of steel and concrete with profiled steel used as the stiffeners were proposed to meet special requirements

    摘要基於特殊需要，提出了帶型鋼加勁肋的鋼板混凝土組合板這一新型組合碼頭面板。
  10. But there is still a lot to be advancedresearch, complement in the development application process of new construction system. the paper, through the test of shear property and the factor analysis, studied rigdity and restoring force characteristic of multi - ribbied slab. finished work as following : though aseismic test of nine 1 / 2 - scaled model and one 1 / 4 - scaled model slabs, the paper studied breakage form, bearing capacity and energer consume, questioned stagnant speciality and contrast analyzed all kinds of factors influenting rigidity

    本文是在總結課題組前期研究工作的基礎上，通過對墻板模型的抗剪性能試驗及因素分析，就密肋復合墻板的剛度及恢復力特徵進行了研究，完成的主要工作如下：通過對9塊1 2比例及一塊1 4比例墻板模型抗震性能試驗，研究了墻板的破壞形態、承載力、變形及耗能；探討了墻板的滯回特性；同時對影響剛度的各種因素進行了對比分析。
  11. First, failure pattern, deformation character, carrying capacity and rigidity of multi - rib panel with outer lightweight frame under seismic loading are analyzed synthetically in the paper

    文中首先對帶邊框密肋復合墻板在地震作用下的破壞模式、變形特徵、承載能力及剛度進行了綜合分析，並與組合磚墻的受力性能進行對比。
分享友人
分享到 Line

分享到臉書