絕對壓力計 的英文怎麼說

中文拼音 [juéduì]
絕對壓力計 英文
absolute manometer
  • : Ⅰ動詞(斷絕) cut off; sever Ⅱ形容詞1 (完全沒有了; 窮盡; 凈盡) exhausted; used up; finished 2 ...
  • : Ⅰ動詞1 (回答) answer; reply 2 (對待; 對付) treat; cope with; counter 3 (朝; 向; 面對) be tr...
  • : 壓構詞成分。
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  • : Ⅰ動詞1 (計算) count; compute; calculate; number 2 (設想; 打算) plan; plot Ⅱ名詞1 (測量或計算...
  • 絕對 : absolute
  1. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先,液體介質的靜電霧化機理作了初步的探討,理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後液體荷電方法進行了研究分析,于高電導率的液體,場致荷電和接觸荷電可以使其霧化,而于電導率較低的緣液體,需用浸潤電極荷電和感應荷電方法使其充分帶電;最後,根據前面的研究分析,設和組裝試驗裝置,在同一環境下煤油、乳化劑、酒精三種不同液體介質進行高靜電霧化試驗,並試驗結果進行分析處理,總結出液體靜電霧化與液體表面張、電導率和粘度的關系及電液體靜電霧化的影響等,得出高靜電場中液體霧化的一般規律。
  2. All the transmission lines of west - east electricity transmitting project are inevitable to crossing the high altitude and icing areas. for the reducing of the air pressure and the absolute humidity, the electricity strength of insulators will drop obviously. therefore, it must be considered the effect on the insulators " flashover voltage caused by the change of altitude and ice when the insulation cooperation of transmission lines are being designed

    「西電東送」工程的所有輸電線路都不可避免的要經過高海拔和覆冰地區,由於大氣濕度的降低會使緣子的電氣強度顯著下降,因此在進行輸電線路的緣配合設時必須考慮到海拔高度和覆冰的變化緣子的閃絡電影響。
  3. In the paper, the high - voltage insulation property of the lift is designed and analyzed firstly, and then according to the dynamic model of the lift, the optimum design is implemented

    首先緣升降平臺的高緣性能進行了設和分析,並根據升降平臺的動學模型,緣升降平臺的結構進行了優化。
  4. The main conclusions and original results are summarized as follows. the manganin ultra - high pressure sensors for gas gun were made by two - step thin film techniques, namely, manganin thin films were first deposited by magnetron sputtering on fused silica substrates, and then covered by a layer of sio2 thin films by electron beam evaporation. consequently, the manganin sensing elements were " cleanly " encapsulated in inorganic solid matrix and the high - pressure shunt effect was eliminated radically

    上述技術的主要優點在於可以採用高緣性能更好的無機物作為緣封裝材料,如本研究中所採用的sio2 ,而代替在箔式錳銅中所使用的ptfe ;並可實現敏感元件「清潔」地無機固態封裝,即將整個敏感元件是包封在無機物中,而不與高緣性能相較差的有機物,如粘接劑、樹脂等直接接觸,從而在根本上消除了高旁路效應。
  5. It compares and analyses the equipment test voltage emendated to standard atmosphere conditions with the equipment nominal withstanding voltage. and then it concluded that : the emendation value educed by " humidity ratio " integrated emendation method is basically equal or close to the equipment nominal withstanding voltage ; but the values by two traditional emendation methods are mostly higher. it also proves that, " humidity ratio " integrated emendation method is more perfect than any other methods, and it can reflect the influence degree of atmospheric parameters on electrical equipment outer insulation discharge voltage actually

    文中選擇「比濕」綜合校正法和兩種傳統校正法,分別西高所為羊八井、拉薩、羊湖110kv變電所設備所做的人工氣候室模擬試驗數據及雲南中試所做的zs - 110工頻放電電試驗數據進行校正算,將試驗電的校正值與試驗設備的標稱耐受電水平進行比較分析;認為: 「比濕」綜合校正法的校正值與設備耐受電水平基本相等或接近,而兩傳統校正法的校正值大多高於設備耐受電水平;進一步證明, 「比濕」綜合校正法是目前諸多校正法中較為完善的,能真實地反映大氣參數電氣設備外緣放電電的影響程度的校正法,在高海拔電工程設中應推廣應用。
  6. Industrial pressure gauges. metallic pressure gauge indicators. absolute pressure gauges

    工業表.金屬指示表.絕對壓力計
  7. Under different load, when we apply this software to any time, region and cooling way, we can get the hottest spot increment and aging rating. to manufactory, the software means sounder thermal design, which will meet the load, putted forward by user, while to user, the software equal to a master who can help them decide the capacity rating of the transformer, which will fit the load. by using the software, the potential danger and the waste, caused by unfit load choice may be avoided

    研究開發了算乾式電器負載能算軟體,可于各種緣結構,各種冷卻方式和任一地區、任一時間下運行的變器在不同運行載荷下的最熱點溫升緣老化率進行分析和算,同時利用該軟體製造廠可以依據用戶提出的運行負載量給出相應的熱設方案,用戶可根據運行負載情況利用軟體算所需變器的額定容量,避免額定容量選擇不當造成隱患和浪費。
  8. Absolute pressure vacuum gauge

    真空
  9. The third chapter employed a new method of taking pressure as step to simulate refrigerant flow characteristics in adiabatic capillary tubes, based on adiabatic capillary tube mathematic models. refrigerant critical flux in capillary tubes is predicted by means of back - propagated method. it indicates that this method can save computational time, so it can be used in engineering

    在建立熱毛細管數學模型基礎上,採用以為步長的新方法熱毛細管進行了模擬算,採用bp神經網路製冷劑在毛細管中臨界流量進行了預測,結果表明該方法能夠較大幅度地節省算時間,因而具有工程應用價值。
分享友人