絕對校準 的英文怎麼說

中文拼音 [juéduìjiàozhǔn]
絕對校準 英文
absolute calibration
  • 絕 : Ⅰ動詞（斷絕） cut off; sever Ⅱ形容詞1 （完全沒有了; 窮盡; 凈盡） exhausted; used up; finished 2 ...
  • 對 : Ⅰ動詞1 （回答） answer; reply 2 （對待; 對付） treat; cope with; counter 3 （朝; 向; 面對） be tr...
  • 校 : 校名詞1. （學校） school 2. （校官） field officer3. （姓氏） a surname
  • 準 : Ⅰ名詞1 （標準） standard; guideline; criterion; norm 2 （目標） aim; target Ⅱ動詞1 （依據; 依照）...
  • 絕對 : absolute
  1. The wound stator core is press fit into a cast iron housing for true and positive alignment as well as efficient heat transfer

    盤繞的定子核心被壓鑄進鑄鐵外殼內，不但保證真正的、絕對的校準，還保證高效的熱傳遞。
  2. New use of atypical antipsychotics was associated with a statistically significant increase in the risk for death at 30 days compared with nonuse in both the community - dwelling cohort ( adjusted hazard ratio, 1. 31 [ 95 % ci, 1. 02 to 1. 70 ] ; absolute risk difference, 0. 2 percentage point ) and the long - term care cohort ( adjusted hazard ratio, 1. 55 [ ci, 1. 15 to 2. 07 ] ; absolute risk difference, 1. 2 percentage points )

    非標準抗精神病藥物的新用法與未運用抗精神病藥物中用藥30日後的死亡風險性統計學上的顯著增加相關，其中在社區居住隊列組別（校正危害比為1 . 31 ， 95 %可信區間為1 . 02至1 . 70 ，絕對風險差異為0 . 2百分點）中和在長期護理組（校正危害比為1 . 55 ， 95 %可信區間為1 . 15至2 . 07 ，絕對風險差異為1 . 2百分點）中都如此。
  3. The calibration of piezoelectric accelerometer is an important area of the shock and vibration measurement technology, and the calibrated piezoelectric accelerometer is divided into standard accelerometer and working accelerometer, usually standard accelerometer is calibrated by absolute method and working accelerometer is calibrated by comparison method

    壓電加速度傳感器的校準是振動與沖擊測量技術中的一個重要研究領域，被校的壓電加速度傳感器有標準加速度計和工作用加速度計之分，通常標準加速度計用絕對法校準，工作用加速度計用比較法校準。
  4. The absolute calibration of hydrophones using the planar scanning technique in the frequency range 0, 5 mhzto 15 mhz

    用0 . 5mhz 15mhz頻率的水平掃描技術對水下擴音器進行的絕對校準
  5. In this paper, we begin with actual products designs and then combine the real conditions. on condition that technique conditions requirements were satisfied, by adopting electromagnetic field numerical analysis and experimental research, the electric field distribution inter - phase and to ground of 12kv metalclad withdraw switchgear vacuum circuit breaker is described accurately. the electric field distribution and movement in different conditions are also confirmed

    本文從實際產品設計入手，結合現實情況，在滿足技術條件要求的基礎上，通過採用電磁場的數值模擬分析及實驗研究，準確地描述了12kv配電系統中置櫃真空斷路器相間及對地全場域電場分佈情況，確定了中置櫃在不同情況下的電場分佈、變化情況，通過理論的計算和分析，對產品的絕緣進行了校核與驗證，通過多種方法的比較，進而得到合理的布置結構和達到最佳的絕緣配合，為實際產品的開發和設計提供了理論依據。
  6. We provide a pressure gauge calibration service for the measured variables of absolute pressure and overpressure in gasses and oil in our ptb - accredited dkd laboratory for the checking and updating of usage standards

    我們在ptb認證的dkd實驗室中為在氣體和油類中絕對壓力和過壓力的標準變量準備了一個壓力測量校準服務，以備檢查和更新使用標準。
  7. In our dkd laboratory, which has been ptb - accredited since 1981, we provide a pressure gauge calibration service for the measured variables of absolute pressure and overpressure in gasses and oil for the checking and updating of usage standards

    在我們的dkd實驗室中早在1981年就已經得到ptb認證，我們為在氣體和油類中絕對壓力和過壓力的標準變量準備了一個壓力測量校準服務，以備檢查和更新使用標準。
  8. In order to improve the circuit ' s input impedance, which is affected by insulating resistance of electrode leading wire, terminals and printed circuit board, electrode is connected to the meter through insulating wire of high impedance which is directly welded in the printed circuit board with insulating ring. the deviation of electrode is corrected by software and the algorithm is given

    使用高阻絕緣線連接電極，並將高阻絕緣線直接焊在加有絕緣環的印刷線路板上，從而消除電極引線、接線端子和印刷線路板漏電對放大電路輸入阻抗的影響；軟體校正電極偏差，並給出校準演算法。
  9. Absolute calibration source

    絕對校準源
  10. The characteristic of all of world coordinate system is, coordinate of every time fixed position and locate coordinate does not have a relation last time, the coordinate location system that touching screen is an independence on physics, the data that feels every time passes the coordinate that calibration turns to go up for screen, such, no matter be below what circumstance, with respect to requirement feeling screen this covers coordinate, bit samer output data is stable, if be not stabilized, so this feeling screen locates with respect to unwarrantable absolutely coordinate

    絕對坐標系統的特點是，每一次定位坐標與上一次定位坐標沒有關系，觸摸屏在物理上是一套獨立的坐標定位系統，每次觸摸的數據通過校準轉為屏幕上的坐標，這樣，就要求觸摸屏這套坐標不管在什麼情況下，同一點的輸出數據是穩定的，假如不穩定，那麼這觸摸屏就不能保證絕對坐標定位。
  11. Three absolute radiometers compare with the solar irradiance absolute radiometer ( siar - 1 ) respectively on ground, and calculate the corrected coefficient of three absolute radiometers relativity to wrr respectively. seven calibrated factors are introduced, and the formula of every calibrated factor is showed, which according to the principle and the work in fact of stim. it can truly calculate corrected coefficient of every calibrated factor by formula

    在地面，通過把三臺絕對輻射計分別與同世界輻射基準wrr比對過的絕對輻射計siar - 1進行了比對，分別計算出了三臺絕對輻射計相對於世界輻射基準wrr的修正系數；在空間，結合太陽輻照度監測儀的工作原理及其實際工作情況，研究出了太陽輻照度監測儀星上測量七項校正因子的計算公式，通過這些公式能夠準確地計算出各項校正因子的修正系數。
  12. The absolute calibration of hydrophones using the planar scanning technique in the frequency range 0, 5 mhz to 15 mhz

    採用頻率范圍為0 . 5mhz至15mhz的平面掃描技術對水聽器的絕對校準
  13. A new method of absolute calibration of photodetector sensitivity based on spontaneous parametric down - conversion ( spdc ) biphoton field is described. the process of spdc is studied theoretically. the single photon detection probability and two - photon coincidence probability are derived and the calibration principle for photodetectors is explained. an experimental system has been set up. the sensitivity of a photon - counting photomultiplier tube was measured, and the results were compared with those obtained using conventional method

    討論了一種基於自發參量下轉換雙光子場絕對校準光電探測器靈敏度的新方法，著重推導了對自發參量下轉換過程中產生的單光子的探測概率和雙光子的符合速率，從而闡明了絕對測量光電探測器量子效率的原理.基於這一方法對光子計數型光電倍增管的響應靈敏度進行了測量，並將實驗結果與常規方法測得的結果進行了比較
  14. If felling is absolutely unavoidable, the works department should seek, prior to the commencement of work, the approval of the campus landscaping enhancement committee clec which must be satisfied that the extent of destruction is already kept to a minimum and the proposed compensatory scheme adequate

    如砍伐是絕對不能避免的話，工程部門定要于工程展開前獲得校園景觀美化委員會（ clec ）的批準，證明已採取適當措施將工程的破壞減至最低，及提出適當的補償方案。
  15. Methods for the calibration of vibration and shock pick - ups. primary vibration calibration by laser interferometry

    振動與沖擊傳感器的校準方法激光干涉振動絕對校準
分享友人
分享到 Line

分享到臉書