絕熱降溫 的英文怎麼說

中文拼音 [juérèjiàngwēn]
絕熱降溫 英文
adiabatic cooling
  • 絕 : Ⅰ動詞（斷絕） cut off; sever Ⅱ形容詞1 （完全沒有了; 窮盡; 凈盡） exhausted; used up; finished 2 ...
  • 降 : 降動詞1. （投降） surrender; capitulate 2. （降伏） subdue; vanquish; tame
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 降溫 : 1 （降低溫度） lower the temperature （as in a workshop）; cooling; hypothermia; hypothermy 2 [氣...
  1. The factors that probably leads to cracks are put forward based on the analysis, which in turn are : the deformation of surrounding rock and the deformation of concrete volume and the pelter of air temperature and thermal insulation temperature rise and the thickness of liner and cooling pipe

    通過分析得出了導致裂縫的幾種可能原因依次為：混凝土的圍巖變形、自生體積變形、氣溫驟降、絕熱溫升、襯砌厚度和冷卻水管等，為今後類似工程提供理論依據。
  2. The moderate supersonic carbon added to the mold flux for ultra - low carbon steel is used to stay the melting speed as skeleton. then the mold flux coils have the good adiabatic, insulation and even flow property. at the same time it cause the carbon increase in the steel slabs and the operation of the ultra - low carbon is affected at last

    超低碳鋼連鑄結晶器用保護渣中，外加中超碳黑作為骨架降低熔化速度，使保護渣具有良好的絕熱保溫性、均勻流動的潤滑性，但同時卻會引起鋼鑄坯的碳增量，最終影響超低碳鋼的成功操作。
  3. Refractory fiber and product is manufactured by means of dry method and wet method. as an excellent insulation material, it has comparatively low volume density, good softness and very low thermal conductivity coefficient. sticking method, ancjoring method and folding method can be selected respectively. this product can be used in various industrial kilns & furmaces for lowering heat consumption

    耐火纖維及製品是採用干法、濕法生產的具有較低體積密度、較好柔軟性、極低的導熱系數的優質絕熱保溫材料，施工時可分別採用粘貼法、錨固法、折疊塊形式施工，適用於各種工業窯爐降低熱耗之用。
  4. The research of this text is about stopping " alkali - aggregate reaction ", reducing concretes exothermic peak, controling the internal concrete adiabatic storage and using the microexpansivity of magnesia to make up the shrinkage production in the later harden

    本文從防止「堿集料反應」 、降低水泥水化放熱峰、控制混凝土內部絕熱溫升和利用mgo微膨脹補償水泥石硬化後期產生的收縮等方面進行研究與探討。
  5. In this paper, referring to qingju water power station, temperature control analysis and study has been done : study on the match ratio of the concrete and question of modifying of the special fine sand concrete to improve resisting ability of splitting of concrete ; study on the technology of the highly mixed fly ash to reduce the adiabatic temperature rise of concrete ; in case of the condition of resisting splitting to allow, study on the temperature control measure to strengthen and water the size of building, simplify the operational procedure, accelerate the construction speed, economize the expenses of the project

    溫控問題成為青居水電站設計和施工的關鍵技術問題。 、本文對水工大體積混凝土溫控問題進行了分析和總結，結合青居水電站閘壩工程，開展溫度應力及溫度控制研究:研究混凝土的配合比及特細砂混凝土『改性問題，提高混凝土的抗裂能力;研究高摻粉煤灰技術，降低混凝土的絕熱溫升:在抗裂條件允許的情況下，研究施工過程中溫控措施的簡化，以加大澆築尺寸，簡化施工程序，加快施工進度，節約工程費用。
  6. The simulations results show that the spoiler is available to make the fuel and the oxidizer coming from the former to stay in the cavity for a long time, to let the fuel and oxidizer mix and burn completely. since there is a high temperature zone forming by vortex in the middle of the motor, it required a restricted thermal protection. the plate with holes decreased the vortex function in the cavity, which could not promote the combustion efficiency, but to decrease temperature in the cavity and be benefit to thermal protection of the wall

    計算結果分析表明:擾流板可以使燃料和氧化劑在擾流腔內的滯留時間加長，促進燃料與氧化劑的摻混燃燒，提高燃燒效率，但由於渦流在發動機的中間部位形成了高溫燃燒區域，致使局部燃料和絕熱層燒蝕速率增大，加大了熱防護的難度;孔板結構減弱了擾流腔內迴流區的漩流作用，不能增加推進劑燃燒效率，但可以使擾流腔內的溫度降低，給壁面熱防護帶來好處。
  7. Hvac system - - - thermal insulation for the air duct and pipe system of hvac

    空調系統- - -送風軟管及管道法蘭的保溫各類罐體、設備的絕熱保溫及吸產降噪。
  8. Insulating and sheathing materials of electric and optical cables - common test methods - methods specific to polyethylene and polypropylene compounds - tensile strength and elongation at break after conditioning at elevated temperature - wrapping test after conditioning at elevated temperature - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test - test method for copper - catalyzed oxidative degradation

    電纜和光纜的絕緣和護套材料.通用試驗方法.聚乙烯和聚丙烯化合物專用方法.高溫處理后抗拉強度和斷裂伸長度.高溫處理后的卷繞試驗.在空氣中熱老化后的卷繞試驗.質量增加的測量.長期穩定性試驗.催化銅氧化降解的試驗方法
  9. According to the thermodynamics theories, reaction free energy and adiabatic temperature in zro2 - b _ 2o _ 3 - mg system have been theoretically calculated and analyzed. results of adiabatic temperature calculation showed that the adiabatic temperature of zro2 - b _ 2o _ 3 - mg system without diluent was 3093k, and it reduced with improvement of diluent content. when the diluent mgo content was 0 ~ 45 %, or the diluent zrbb2 content was 0 ~ 62 % the shs process would occer

    絕熱溫度計算表明:稀釋劑含量為零時， zro _ 2 - b _ 2o _ 3 - mg體系的絕熱溫度tad為3093k ，隨著稀釋劑含量的增加絕熱溫度呈現逐漸降低的趨勢，得出了稀釋劑mgo含量在0 45 % ，稀釋劑zrb2含量在0 62 %之間的所有組分的體系均有足夠的熱量來完成燃燒合成反應的結論。
  10. Insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 2 : methods specific to polyethylene and polypropylene compounds - tensile strength and elongation at break after conditioning at elevated temperature - wrapping test after conditioning at elevated temperature - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test - test method for copper - catalyzed oxidative degradation

    電纜和光纜的絕緣和護套材料.通用試驗方法.第4 - 2部分:聚乙烯和聚丙烯化合物專用方法.高溫處理后抗拉強度和斷裂伸長度.高溫處理后的卷繞試驗.在空氣中熱老化后的卷繞試驗.質量增加的測量.長期穩定性試驗.催化銅氧化降解的試驗方法
  11. This type of capacitor has an assembling full - sealed structure, and it is comprised of capacitor unit body, contain - er, insulation cooling impregnant, outlet ceramic bushing, pressure - releasing valve and temperature controller etc. the internal insulation cooling impregnant is isolated from external atmosphere so as to avoid aging of impregnant and ingress of moisture

    全密封集合式並聯電容器主要由電容器單元組成的器身波紋油箱絕緣冷卻油出線套管支持絕緣子壓力釋放閥及溫度控制器等部件構成。採用波紋油箱增大散熱面積降低產品溫升。
分享友人
分享到 Line

分享到臉書