絕緣試驗電壓 的英文怎麼說

中文拼音 [juéyuánshìyàndiàn]
絕緣試驗電壓 英文
insulating test voltage
  • : Ⅰ動詞(斷絕) cut off; sever Ⅱ形容詞1 (完全沒有了; 窮盡; 凈盡) exhausted; used up; finished 2 ...
  • : Ⅰ名詞1 (緣故) reason 2 (緣分) predestined relationship 3 (邊) edge; fringe; brink Ⅱ動詞(攀...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 壓構詞成分。
  • 絕緣 : 1 [電學] (隔斷電流) insulation; isolation; insulate; isolate 2 (跟外界不發生接觸) be cut off ...
  • 試驗 : trial; experiment; test
  • 電壓 : voltage; electric tension; electric voltage
  1. This heating helps to break down weak spots in the dielectric that otherwise might pass through the electrode undetected, only to fail during a later spark or hipot test

    這熱量幫助擊穿較薄的地方?否則線材通過極而沒有被檢測到?結果在以後的火花測和高將會失效。
  2. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、氣強度、阻、接地連續性、泄漏流、微波泄漏、功率、溫升、濕熱、灼熱絲、水平燃燒、垂直燃燒、漏起痕、球、防雨淋、防濺水、粉塵、鹽霧、耐久性(壽命)機負載源線彎折、源線提拉、拉扭力測、燈頭互換性、安全結構檢查等。
  3. Standard test method for dielectric breakdown voltage of insulating oils of petroleum origin using vde electrodes

    用vde極測量源自石油的油介擊穿的標準方法
  4. Aerospace series - elements of electrical and optical connection - test methods - part 219 : voltage strength for insulated terminal lugs and in - line splices

    航空航天系列.光連接件.方法.第219部分:終端插片和內連接件強度
  5. The main contributions to the study on the flashover of insulators in vacuum are as follows : 1. a set of test system for the studies on flashover of insulators in vacuum has been developed, which consists of vacuum system, electrode system, e - dot pulse voltage measurement system, surface charge measurement system, current monitor system and luminescence signal measurement system

    本文主要完成了以下工作: 1 .通過設計加工真空及極系統,研製e - dot沖擊測量系統、真空中表面荷測量系統、沖擊流和表面微弱光信號測量系統,建成了國內第一套用於研究真空中子沿面閃絡現象的平臺。
  6. The existence of air gaps will inevitably distort strongly electrical field distribution and cause to a significant voltage drop across the gap, which causes severely non - uniform electrical field near the icicle top

    運行和研究表明,子串在運行下覆冰時其高端總是存在空氣間隙。
  7. Insulation testing of large ac rotating machinery with high direct voltage, recommended practice for

    帶高正向的大型交流旋轉機械的的推薦實施規范
  8. It compares and analyses the equipment test voltage emendated to standard atmosphere conditions with the equipment nominal withstanding voltage. and then it concluded that : the emendation value educed by " humidity ratio " integrated emendation method is basically equal or close to the equipment nominal withstanding voltage ; but the values by two traditional emendation methods are mostly higher. it also proves that, " humidity ratio " integrated emendation method is more perfect than any other methods, and it can reflect the influence degree of atmospheric parameters on electrical equipment outer insulation discharge voltage actually

    文中選擇「比濕」綜合校正法和兩種傳統校正法,分別對西高所為羊八井、拉薩、羊湖110kv變所設備所做的人工氣候室模擬數據及雲南中所做的zs - 110工頻放數據進行校正計算,將的校正值與設備的標稱耐受水平進行比較分析;認為: 「比濕」綜合校正法的校正值與設備耐受水平基本相等或接近,而兩傳統校正法的校正值大多高於設備耐受水平;進一步證明, 「比濕」綜合校正法是目前諸多校正法中較為完善的,能真實地反映大氣參數對氣設備外的影響程度的校正法,在高海拔力工程設計中應推廣應用。
  9. Power transformers part 3 : insulation levels, dielectric tests and external clearances in air

    力變器第3部分:水平和外空氣間隙
  10. Power transformers - part 3 : insulation levels, dielectric tests and external clearances in air

    功率變器.第3部分:水平介質和空氣中外隙
  11. Gb10237 - 1998 the insulation level and insulation test for power transformers, air gap of external insulation

    Gb4208 - 1993力變水平和,外空氣間隙
  12. Standard test method for dielectric breakdown voltage of insulating oils of petroleum origin under impulse conditions

    在脈沖條件下石油成因的油的介質擊穿的標準方法
  13. Insulating test voltage

    絕緣試驗電壓
  14. Test methods for determining electrical properties of electric cables and wires. determining insulation resistance. voltmeter - ammeter method

    性能方法-流法
  15. Test limits of the interturn insulation on random wound winding for ac low - voltage machines

    交流低機散嵌繞組匝間.限值
  16. Test methods of the interturn insulation on random wound winding for ac low - voltage machines

    交流低機散嵌繞組匝間.方法
  17. Dry, solid insulating materials. resistance test to high - voltage, low - current arc discharges

    乾性固體材料.高流弧光放阻抗
  18. On the base of the iec standard of dc suspension insulators, we designed a new ion migration test for 500kv dc ceramic support insulators, including the regulation between the bulk resistance and the temperature, the test samples, the test voltage and the temperature for long - term ion migration test, and the amount of accumulative charges

    以懸式子離子遷移標準為基礎,完整的設計了500kv直流支柱式瓷子離子遷移,其中包括研究了品體積阻隨溫度場強變化的規律,成功的設計了品,確定了長期離子遷移( 40kv )和溫度( 130 ) ,計算了50年累計荷量( 0 . 173c ) 。
  19. Insulating materials - industrial, rigid moulded, laminated tubes and rods of rectangular and hexagonal cross - section based on thermosetting resins for electrical purposes - part 2 : methods of test

    材料.工用工業剛性模製矩形和六角形橫截面的熱固性樹脂基層管材和棒材.第2部分:方法
  20. Guide for frequency of sampling extruded dielectric power, control, instrumentation, and portable cables for test

    纜控制纜測量儀器纜和輕便纜頻繁取樣的指南
分享友人