給水閥 的英文怎麼說

中文拼音 [gěishuǐfá]
給水閥 英文
feed valve
  • 給 : 給Ⅰ動詞1 （送對方某物; 使對方得到） give; grant 2 （用在動詞后 表示交與 付出） pass; pay 3 （叫; ...
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 閥 : 名詞1 （指在某方面有支配勢力的人物或家族） established house or power group; a powerful person or...
  • 給水 : [機械工程] feedwater; water supply給水泵 feed pump; 給水量 confluent; 給水能力 capacity of water ...
  1. This watts / flippen float valve product guide features high quality, reliable control assemblies and components that provide make up water for pressure washers, cooling towers, heat transfer units, cattle watering tanks, refrigeration units, and for many other applications where float valves are required

    這種美國瓦茨/ flippen浮球閥的特點在於其優質、控制可靠的部件，為壓力清洗裝置，冷卻塔，熱傳送裝置，牲畜水塔，冷凍裝置，以及其他各種要求浮球閥的應用提供補給水。
  2. Protective interior coatings for valves and hydrants

    閥門和給水栓用防護性內部塗層
  3. Compound quick air inbreathe - release valve for water supply pipeline

    給水管道復合式高速進排氣閥
  4. Water supplying pipe in front of the coal economizer should be installed with a stop valve and check valve for the factory using boiler of mother tube water supplying

    7採用母管制供水的電廠，進入每臺鍋爐省煤器前的給水支管均應裝設截止閥與逆止閥。兩閥應緊接，按水流方向逆止閥在前。
  5. Feed water check valve

    給水止回閥
  6. Note : periodic relief valve discharge may occur on dead end service applications, such as boiler feed lines or cooling tower makeup lines

    注意：在終端應用中，如鍋爐給水管線或冷卻塔補水管線，安全閥可能會出現周期性排放。
  7. When the water is full, the bwf should be stopped immediately, then to weak firing and open blowdown and drain valves till the water level returns to normal

    滿水后應減少給水或及時排水，立即停止鍋爐給水，並減弱燃燒，開啟排污閥及流水閥，直到水位恢復正常后才關閉。
  8. Valves for water supply - fitness for purpose requirements and appropriate verification tests - hydrants

    供水用閥門.目的要求和適當檢定試驗的合理性.給水栓
  9. Steam seal feed valve

    汽封給水閥
  10. Air release, air vacuum, and combination air valves for water works service

    給水裝置用放氣閥空氣真空和混合空氣閥
  11. Standard specification for pressure - reducing valves for water systems, shipboard

    船上給水系統用減壓閥
  12. Method for laboratory tests on noise emission from appliances and equipments used in water supply installations - part 2 : mounting and operating conditions for draw - off taps and mixing valves

    給水裝置中裝置和設備噪聲的實驗室試驗方法.第2部分:排水閥和混合閥的安裝和操作條件
  13. No corner and repair valve for water supply

    實驗水池給水沒有設置角閥及檢修閥門。
  14. Our group owns two production bases ， which manage three specialized manufacture centers ， respectively for butterfly valves ， water supply and discharge valves ， and export valves

    集團兩大生產基地，下設三大專業製造中心：蝶閥製造中心、給排水閥門製造中心、出口閥門製造中心。
  15. Xh rubber slowly - closing cut - off vavle is a new water supply and drainage vavle with full rubber structure, duck - mouthed appearance and functions or positive flow - in and reserve cut - off. according to thrust analysis and calculation as well as different operation mechanism and different rubber products by special processing. all will be open at weak hydraulic pressure is higher, the vavle gate will open more greatly and the water flow is greater. at reserve operation, the vavle gate closes naturally and seals tightly cut - off vavle ; the back pressure is higher, the vavle gate closes more tightly and the seal effect is better. it is used widely in various drainage exit to prevent from pouring backwards and flowing backwards in city planning, water conservancy and sewage disposal etc. it is the ideal productto replace flap vavle

    Xf型橡膠緩閉逆止閥是一種全橡膠結構外形呈「鴨嘴狀」 ，具有「正向流入反向逆止」功能的新型給排水閥門產品。它根據受力分析和受力計算，針對不同的工況，採用不同的設計機理，選用不同的橡膠配方，並按特殊工藝製作而成。正向工作時，水由進水口流入，微小的水壓，便能打開閥門，水壓越大，閥門開啟越大，水流量越大。
  16. Abstract : this paper apply asme & quot; feed water pump npsh analysis during load rejection & quot; theory to check bfp npsh of zhuhai power plant 700mw units in the condition of vwo and also confirm the calculating result by load rejection test

    文摘:利用asme的「甩負荷時給水泵汽蝕余量的分析」理論，校核了珠海電廠容量700mw機組在最惡劣工況即閥全開跳機工況時的給水泵汽蝕余量，並在甩負荷時，進行了試驗驗證。
  17. After initial installation, a discharge from the relief valve opening may occur due to inadequate initial flushing of pipe lines to eliminate dirt and pipe compounds

    注：在閉端應用環境，如鍋爐給水管道或冷卻塔補水管道，由於在靜態或無流動期間，供應壓力有所波動，因此安全閥可能發生周期性排放。
  18. Is an enterprise which is specialized in designing and manufacturing plastic mould for pvc - u, pp - r, abs water supply and drainage pipes, plastic valves and fittings, insulation electric conduits and fittings for installation in buildings

    是一家專業設計生產建築用u - pvc pp - r abs給水排水管件塑膠閥門及配件和絕緣電工套管及配件等系列模具的現代企業。
  19. Boiler feed valve

    鍋爐給水閥
  20. Branch pipe valves. draw - off cocks. nominal pressure pn 10

    支流閥.給水閥.公稱壓力，標準壓力
分享友人
分享到 Line

分享到臉書