網狀拓撲結構 的英文怎麼說

中文拼音 [wǎngzhuàngjiēgòu]
網狀拓撲結構 英文
mesh topology
  • : Ⅰ名詞1 (捕魚捉鳥的器具) net 2 (像網的東西) thing which looks like a net 3 (像網一樣的組織或...
  • : Ⅰ名詞1 (形狀) form; shape 2 (情況) state; condition; situation; circumstances 3 (陳述事件或...
  • : 拓動詞(把碑刻、銅器等的形狀和上面的文字、圖形印下來; 拓印) make rubbings from inscriptions pict...
  • : 結動詞(長出果實或種子) bear (fruit); form (seed)
  • : Ⅰ動詞1 (構造; 組合) construct; form; compose 2 (結成) fabricate; make up 3 (建造; 架屋) bui...
  • 網狀 : nets (土紋); dicty-; dictyo-網狀脈 [地] network vein; [植物學] netted [reticulated] veins
  • 結構 : 1 (各組成部分的搭配形式) structure; composition; construction; formation; constitution; fabric;...
  1. Meanwhile, on the basis of the network topology this paper detailedly states the formation of funneling effect and origin of funneling noise, and also demonstrates its huge damage to network

    漏斗噪聲的根源就在於路的樹,並指明了漏斗噪聲可以對路造成巨大的危害,嚴重的時候使得路無法正常運行。
  2. The main results are as follows : 1. dynamical behavior in coupled map lattices with regular topology are investigated by using lyapunov componet. 2. dynamical behavior in coupled map lattice with scale - free topology are investigated in detail. our strategy is to apply three feedback control methods, including constant feedback and two types of time - delayed feedback, to a small fraction of network nodes to reach desired synchronous state

    本論文正是對具有無標度的耦合映象格子的動力學行為進行了研究,主要內容和創新點如下: 1 .利用lyapunov指數對具有規則的耦合映象格子系統的動力學行為進行研究; 2 .對具有無標度的耦合映象格子系統的動力學行為進行了詳細研究;為了使系統達到同步,我們的策略是應用三種反饋方法(常數反饋和兩種時延反饋)對系統的部分節點進行控制以達到我們期望的態。
  3. In this paper, we provide a summary of all the possible topologies of data grid replica location mechanisms based on the research status of related activities, and design a new kind named distributed replica information index location mechanism ( dilm ), which is based on the topology of improved ring and integrates four techniques : overlay network, bloom filter, soft - state protocol and md5

    本文介紹了數據格復制定位研究的現,總了數據格復制定位可能的種類,提出了一種新的數據格復制定位機制? ?分散式復制索引定位機制dilm 。 dilm基於改進環型,包含以下4種技術:重疊路技術、 bloomfilter壓縮技術、軟態協議和md5散列演算法。
  4. This paper introduce the topologies of avionics communication system, transfer protocol of the data bus and the kernel of designing the avionics system through the study of the development of avionics communication sytem in the world

    本文合目前國內外航空電子通訊系統的發展況,討論了航空電子通訊路的,總線通訊的傳輸協議,以及航空電子通訊軟體的設計規則。
  5. If the number of application systems of enterprise and government is too large and the application systems are complex, it causes a complex point - to - point netlike structure

    如果在企業或政府應用系統較多而且復雜的情況下,就會形成復雜的點對點的網狀拓撲結構
  6. In the chapter 4, the particular network topology and the four training algorithms are designed for the switching state selector in dtc by the neural network control technology, and the learning speed, stability, and weight convergence of the algorithms are discussed and compared

    第四章對直接轉矩控制中的開關態選擇器用神經路控制技,術設計了具體和四種演算法,並對幾種翼法的學習速度、穩定性、權收斂性進行了比較和研究。
  7. In designing or selecting a topology for a parallel processing system, one fundamental consideration is system - level fault tolerance. in order to improve the fault tolerance, the paper analyses from the two following sides : one is by adding the less links related to the original networks, modifying the topology of the original one, we get higher fault tolerance of the new network ; the other is under the same topology network, ignoring the likelihood of one processor and ail its neighbors failing at the same time, or considering the distribution of the faulty nodes, that is studying the fault tolerance under the conditional connectivity or cluster - fault - lolerance

    本文以提高路的容錯度為目的,從兩個方面分析互連路的容錯性質:一是在原路基礎上增加少量連接,使新型路具有更高的連通度(容錯度為連通度減1 ) ;二是在給定互連下,考慮故障處理器發生的概率和故障處理器的分佈況,在其中的某一具體條件下,即在條件連通度和簇容錯下分析互連路的容錯性能,從而得到更高的路容錯度。
  8. By analyzing the incidence matrix of chain structure model and tree structure model, incidence matrix was obtained, then topology information of basic network structures could be reflected

    通過對路的鏈和樹基本關聯矩陣的分析,認為關聯矩陣可以完全反映路基本信息。
  9. Hierarchizing and decomposing the triangular incidence matrix, topology information of network is extracted, which is suitable for network topology identification of common tree structure, even suitable for network topology identification of the structure with parallel branch ( circle branch )

    這種方法適用於實際應用中常見的樹的辨識,甚至適用於帶並聯支路(環路)的辨識。
  10. Compared with the traditional shape localization algorithms, e - tdsm has the following advantages : 1 the un - warped edge - based texture can better predict the shape and is more robust to the illumination and expression variation than the conventional warped gray - level based texture ; 2 the presented bayesian network indicates the logic structure of the face alignment task ; and 3 the mutually enhanced shape and texture observations are integrated to infer the optimal parameters of the proposed bayesian network using em approach

    在人臉定位問題中,傳統的紋理的定義是將原圖中形包含的灰度值塊通過分塊仿射變換映射到平均形中,從而得到定長的紋理表示。但是,對于側臉圖像,由於自遮擋的原因,由平均形決定的格並不能反映所有形的二維,這樣得到的紋理表示很多地方會出現被遮擋部分的紋理無法得到的問題。
  11. Based on the analysis of current situation and development trend of study about devicenet - based device, the basic contents of field bus and can bus is introduced, the concept and characteristic of devicenet is explained, the likeness and difference between devicenet and can is analyzed, especially in the aspect of communication model, network topology and error control. the powerful application layer protocol of devicenet is summarized, which differs from control area network

    在對基於devicenet設備的研究現和發展趨勢的分析基礎上,介紹了現場總線和can總線的基本內容,說明了基於can總線的devicenet路的概念、性能特點,著重分析了devicenet與can在通信模型、和差錯控制方面的異同點,概括總了其不同於can的功能強大的應用層協議的主要內容。
  12. Finally, ns2 are discussed and simulation results show that the improvement schemes can reduce the blocking probability. the major research works and initiative points in this article are as follows : 1

    本文的主要研究工作及創新點如下: 1 、分析光互連路的研究現,包括光互連路的、參考模型、分類和研究熱點等。
  13. In this paper the communication and collecting data and the design of software and hardware are elaborated. in the construction of network, this system adopt both direction circle redundancy network. making use of its advantage can transfer data by both direction, so without reference to anyone node has error that can not affect natural working

    上本系統採用雙向環形冗餘路(雙環形以太) ,利用雙向環形冗餘的特點可以雙向傳輸數據,因此不論任何一個節點出現問題都不會影響正常的工作態,假設在某一方向出現了問題可以通過另一方向傳輸數據,這樣就更增加系統的實時性、穩定性。
  14. Sdh - based mstp can build networks of rings or tangency rings, so it has strong ability of constructing networks, which means it may used for multiple service types such as point - to - point, multi - point - sharing or convergence

    在系統的設計中應用了vlan技術、 lcas協議、 gfp laps封裝技術,基於sdh的mstp可組成環、相切環等,具有很強的組能力。
分享友人